查询词典 high strength

Alite has low early strength and high long-term strength.

阿利特矿物的早期强度偏低，后期强度高。

The autofrettage analysis of high-pressure vessel of linear strength material with different yield strength in tension and compression based on the Mohr's yield criterion is dealt with.

运用莫尔屈服准则，对承受内压的拉压屈服强度不同的线性强化材料高压容器进行了自增强分析，得到了依赖于材料拉压比和强化模量的筒壁弹性区与塑性区中的应力、残余应力及合成应力的分布。

All results point to that 7%wt plasticizing agent add into PA1010 can receive high ensile strength and impact strength.

将这种热致液晶聚酰胺与尼龙1010共混，并加入N-乙基-对-甲苯磺酰胺作为增塑剂，进行了结构与性能的研究。

In the long time creep tests, by regressive analyses, the creep curve of glauberite at different stress level is obtained: at 50% of its compressive strength, the creep curve is ε 0.009t0.3265, at 80% of compressive strength, the creep curve is ε=0.0098ln-0.0014. It is clear from the creep curves of the rock mass, that the creep rate at high stress level is higher than that at the lower stress level.

通过长时间的蠕变实验，回归出钙芒硝盐岩蠕变在不同应力水平下随时间变化的曲线，其抗压强度50%时的曲线方程为ε=0.0098ln-0.0014，抗压强度80%时的蠕变曲线方程为ε=0.012ln-0.0056，应力水平高时其蠕变速率高于低应力水平的蠕变速率。

This article introduces the research progress in the improvement of the tradition wet strength agent and the development of new environment-friendly wet strength agents such as the polyacetal, the glutaric dialdehyde, the high polymer latex and so on.

介绍了国内外改进传统湿强树脂和聚缩醛类、戊二醛、高分子胶乳类等新型环境有好型湿强剂的研究现状及其作用机理，并且指出环境友好型湿强剂是今后研究发展的方向。

Compressive strength curing 7 days of lime-polishing powder binder is slightly higher than those of lime-fly ash binder, but amplitude of strength curing 28 days is obvious high, average amplitude is up to 190% and maximal amplitude is up to 210% comparing to fly ash-lime binder. Lime-PP binder preceded lime-FA binder in intenerate index of 7 days and 28 days under the same ratio of PP to lime condition.

结果表明：在相同配比条件下，石灰－抛光砖粉结合料与石灰－粉煤灰结合料相比，前者的早期抗压强度略有提高，28d抗压强度增幅明显，平均增幅达190%，最大增幅高达210%；前者的7d、28d软化系数均高于后者，具有更好的水稳定性。

ABSTRACT The ionic strength of mobile phase can significantly affect the peak shape of ionogenic compounds such as antibiotics in reversedphase high performance liquid chromatography. The influence may be attributed to overloading of ionogenic analytes in lower ionic strength mobile phase.

在反相高效液相色谱过程中，流动相的离子强度可显著影响可解离的化合物如抗生素的色谱峰形，原因在于流动相的离子强度较低时，色谱填料的固定相易于过载，使离子化的化合物的色谱峰形呈典型的过载特征――峰形接近直角三角形。

ABSTRACT The ionic strength of mobile phase can significantly affect the peak shape of ionogenic compounds such as antibiotics in reversedphase high performance liquid chromatography. The influence may be attributed to overloading of ionogenic analytes in lower ionic strength mobile phase. In such phase, peak becomes increasingly rightangled triangle in shape with increasing sample load together with increasing peak width and tailing.

在反相高效液相色谱过程中，流动相的离子强度可显著影响可解离的化合物如抗生素的色谱峰形，原因在于流动相的离子强度较低时，色谱填料的固定相易于过载，使离子化的化合物的色谱峰形呈典型的过载特征――峰形接近直角三角形。

ABSTRACT ionic strength of mobile phase can significantly affect the peak shape of ionogenic compounds such as antibiotics in reversedphase high performance liquid chromatography. The influence may be attributed to overloading of ionogenic analytes in lower ionic strength mobile phase. In such phase, peak becomes increasingly rightangled triangle in shape with increasing sample load together with increasing peak width and tailing.

在反相高效液相色谱过程中，流动相的离子强度可显著可解离的化合物如抗生素的色谱峰形，原因在于流动相的离子强度较低时，色谱填料的固定相易于过载，使离子化的化合物的色谱峰形呈典型的过载特征――峰形接近直角三角形。

In this article, three kinds of prealloy powder were developed by water atomization method. The base attribute, pattern, phase composition, differential thermal analysis of powder were researched. Sintered density, hardness, bend strength, Young's modulus were researched as hot pressed sintering temperature changing. By using abrasive wearing equipment upbuilt by the authors, the wear resistance were determined. Green-pressing density, simulated green-pressing strength and bonding momental of high frequency brazing were assayed. SEM corrosion structure and SEM appearance of fracture were observed.

本文采用水雾化法开发了三种预合金代钴粉末：对粉末的基本属性、形貌，粉末的相组成，粉末的差热性进行了分析研究；测定了它们的烧结密度、硬度、抗弯强度、弹性模量随热压烧结温度变化的规律；采用作者自行建立的磨料磨损试验方法，测定了它们的质量磨损百分率；测定了它们的冷压生坯密度、模拟生坯强度以及高频钎焊的结合力矩；观察了热压烧结SEM腐蚀组织和SEM断口形貌。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。