查询词典 high molecular

Super high molecular weight (3.00 ×107 ) is obtained. In contrast with the previous study , the molecular weight and dissolubility are greatly improved.

最终得到了分子量高达3.0× 10 7的产物，其分子量和溶解性能较前人研究成果有明显提高。

Hole structures were obtained for low molecular weight polySt, and protuberance structure for high molecular weight polySt.

低分子量的PSt获得孔洞形貌，而高分子量的PSt则得到中间有凹陷的凸起结构。

Under laboratory conditions, this paper studied the adsorption of different concentration 40, 400 and 4 000 μgL^(-1 polycyclic aromatic hydrocarbons including low molecular weight acenaphthylene, phenathrene and chrysene and high molecular weight benzo perylene in seawater by the leaf litters of Kandelia candel and Avicennia marina at different decomposition status.

在实验室条件下，研究了海水中多环芳烃（含低分子量PAHs苊、菲和以及高分子量PAHs苯并芘）浓度分别为40、400和4000μgL^(-1)时，红树植物秋茄和白骨壤不同分解状态落叶碎屑对PAHs的吸附作用。

The introduces binaphthyl bisphenol monomer on side-chain benzene ring of sulfonic group on molecular level, prepares sulfonated poly aryl ether with sulfonic group only on naphthalene ring of side chain, so that ensures chemical stability of main chain with high molecular weight, while having no influence on mechanical property thereof.

本发明从分子水平出发，将磺酸基在侧链苯环上的联萘双酚单体引入，制备仅在侧链苯环上有磺酸基的磺化聚芳醚，从而保证了高分子主链的化学稳定性，且不会影响其优异的物理机械性能。

The factors which affect the average molecular weight of the polymer of AM and DMDAAC were investigated. The optimal reaction conditions are as follows: the concentration of monomer AM was 30%, while DMDAAC was 5%; the reaction temperature was 30℃, the amount of initiators at the low temperature stage was 0.05‰(compared to the weight of the monomers joining the polymerization), while V-50 was 0.025‰, the weight ratio of potassium persulphate to sodium bisulphite is 1:1, the amount of carbamide was 40‰, and complexing agent was 0.05‰, besides, aerate nitrogen gas for 8min, then the high molecular weight polymer (M=1.217×10^7) could be got after 16h reaction.

研究了影响AM与DMDAAC共聚物的平均分子量的因素，得到了优化条件为：单体浓度为30%，DMDAAC与AM摩尔比为5：95，聚合温度为30℃，低温段引发剂用量为0.05‰，K2S2O8与NaHSO3质量比为1：1，偶氮二异丁基脒盐酸盐(V-50)用量为0.025‰，尿素用量为40‰，乙二胺四乙酸二钠(EDTA-2Na)用量为0.05‰，在此优化条件下聚合反应16h后得到分子量为1.217×10^7的阳离子型聚丙烯酰胺。

Priority PAHs recommended by USEPA were all detected, and the mass concentrations of individual PAHs was between 1.49 and 87.43ngg^(-1), The PAHs with low molecular weight, such as Nap, Flu, Ace were observed in relatively low mass concentrations. The PAHs with high molecular weight, such as Chrysene, Indeno [1, 2, 3-cd] pyrene, Benzo perylene were relatively abundant and the mass congcentration of BghiP was the highest. The total mass congcentration of 16 PAHs exceeded standard of Holand from 10 to 40 times, and in middle pollution level comparatively with other districts.

美国环保总署推荐优先控制的16种多环芳烃均被检出，多环芳烃单体的质量浓度在1.49~87.43ngg^(-1)扩之间；其中萘、药、苊等低分子量芳烃的质量浓度相对较低；窟、茚并[1， 2， 3-cd]苝、苯并苝等高分子量芳烃的质量浓度相对较高，苯并苝的质量浓度最高。16种多环芳烃的质量总浓度超过荷兰政府规定无污染土壤PAHs值的10~40倍；与国内外其他地区相比较，多环芳烃污染处于中等水平。

Data analysis shows that the total amount of PAHs in the sediments of north Taihu Lake is obviously higher than that at the central and south Taihu Lake, and that there is a little difference between the contents of PAHs of high molecular weight and low molecular weight, while the ratio of PAHs varies in different sections of the lake. Through the statistical analysis of the ratio of fluoranthene to pyrene, it is concluded that PAHs mainly come from oil burning with part of them from coal and wood burning.

分析结果表明，太湖北部的多环芳烃总量明显高于中部和南部，低分子量多环芳烃与高分子量多环芳烃的含量差别不大，但在地域上比例有所变化；根据荧蒽/芘的比值统计，多环芳烃主要来源于石油燃烧，部分为煤和木材的燃烧形成。

In this thesis, using a low molecular weight polymer TPA-PPV and a high molecular weight polymer PVK as the model compounds, a series of highly monodisperse nanoparticles with controlled size and shape had been prepared by reprecipitation method and a new method respectively.

本论文以小分子量聚合物TPA-PPV和大分子量聚合物PVK为目标化合物，分别用再沉淀方法和一种新的方法成功制备了一系列不同尺寸的、高度单分散的聚合物纳米超微粒，并研究了PVK纳米球二维阵列的自组装过程。

The concrete steps are: the lactic acid and small-molecule dicarboxylic acid react under the condition with the presence of the catalyst to directly polymerize the carboxyl-terminated lactic acid prepolymer; then the aliphatic polycarbonate diol and the catalyst are added; with the presence of the N2, the reaction is kept for 1 to 10 hours at the temperature of 150 to 200 Celsius system to get the poly lactic acid and polycarbonate copolymer of the low molecular weight; then the reaction is done in the twin-screw extruder at the temperature of 150 to 190 Celsius system to screw out the extension chain; finally the polylactic copolymer of the high molecular weight, toughness and heat resistance is made.

具体步骤是：乳酸和小分子二元酸在催化剂条件下反应直接缩聚合成羧基封端的乳酸预聚物，然后加入脂肪族的聚碳酸酯二元醇和催化剂，在N 2 气氛下，抽真空，在150～200℃温度下，反应1～10小时，得到低分子量聚乳酸/聚碳酸酯共聚物，然后在双螺杆挤出机中在140～190℃下，进行反应挤出扩链，最终得到高分子量的、韧性与耐热性较好的聚乳酸共聚物。

Is a class of high molecular weight compounds made of the molecular aggregation, also known as polymers, macromolecules, etc..

是由一类相对分子质量很高的分子聚集而成的化合物，也称为高分子、大分子等。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。