查询词典 heating bath

By orthogonal experimental design method, the optimized degumming parameters have been confirmed: preacid processing, the concentration of sulfuric acid 2 g/L, treatment time 120 min, treatment temperature 60℃, bath ratio 1:15; alkali treatment, the alkaline concentration of one-pot 7.5 g/L, that of two-pot 9 g/L, treatment time of one-pot 3.5h, that of two-pot 2h, treatment temperature 100℃, bath ratio 1:20, each concentration of the Sodium Silicate, carbamide, and JFC 2%.

预酸处理，硫酸溶液质量浓度2 g/L，处理时间120 min，处理温度60℃，浴比1：15；碱处理，一煮碱溶液质量浓度7.5 g/L，二煮碱溶液质量浓度9 g/L，一煮处理时间3.5 h，二煮处理时间2 h，处理温度100℃，浴比1：20，其中一煮与二煮中添加2%的硅酸钠、尿素和JFC。

The feature of the shaft furnace-iron bath smelter charging carbon-bearing pellets is that partial off-gas of shaft furnace is mixed with gas from smelter and then put into shaft for preheating and pre-reduction. The optimum operational parameter is at the point of prereduction degree of 52% and post-combustion degree of 32% where the coal consumption is 750kg/tone-hot metal and oxygen consumption is 420Nm〓/tone-hot metal.(5) The systematic simulation of rotary hearth furnace-iron bath smeter is firstly formulated.

4本文建立的含碳球团竖炉—铁浴工艺流程模型的特点之一是竖炉炉顶出口煤气的一部分与铁浴煤气混合后，重新进入竖炉，本文报道的对系统部分出口物流返回反应器的非序贯式流程进行的系统模拟，为今后类似问题的模拟提供了参考，本工艺的最低消耗点的操作条件是：预还原度52％，二次燃烧率32％，这时的最低煤耗为750kg／tFe（中挥发份煤VM=19％），氧耗约420Nm〓／tFe，对应于预还原度30～70％的优化组合的二次燃烧率为32～13％。

Diffusion relaxative degree descended with the rise of coagulation bath temperature, changed a little with the rise of coagulation bath concentration, increased with the rise of coagulation drawing ratios, and increased with the rise of spinning solution concentrations.

扩散缓和度随温度升高而下降，随凝固浴浓度的升高变化较小，随凝固浴牵伸比的增大而增大，随原液中聚合物浓度的提高而增大。

Remove it when taking a bath, and do not replaster right after the bath until 3 hours later so that the skin may relax and refrain from allergy.

加温软化，贴于病灶处、阿是穴，洗澡时可去掉，洗澡后让皮肤休息3小时再贴。

By polarization curves and SEM study of the combination of bath additives mechanism. hg22 stannous ions can inhibit the reduction in the bump, reducing the matrix near the area the thickness of the lack of metal ions to enhance the capacity and bath scattered the role of grain refinement in order to be bright plating.

通过极化曲线与SEM相结合的方式研究了镀液中添加剂的作用机理。hg22能够在抑制亚锡离子在凸点的还原，减小基体附近的金属离子匮乏区的厚度，提高镀液分散能力和细化晶粒的作用，从而得到光亮镀层。

The Ni-S deposits obtained from bath containing sulphosalicylic have higher sulphur contents, obvious amorphous textures and much smaller grain sizes than those from the bath without additive.

结果表明，磺基水杨酸在电沉积过程中既促进了晶核的形成，又阻碍了晶粒的长大，导致Ni-S沉积层的晶粒细化、非晶态化程度和硫含量的提高。

The Ni-S deposits obtained from bath containing sulphosalicylic have higher sulphur contents, obvious amorphous textures and much smaller grain sizes than those from the bath without additive.

结果表明，磺基水杨酸在电沈积过程中既促进了晶核的形成，又阻碍了晶粒的长大，导致Ni-S沈积层的晶粒细化、非晶态化程度和硫含量的提高。

Bath: bath metabolism of the body surface to eliminate waste, so that telangiectasia, the effective elimination of fatigue.

洗澡：洗澡可消除体表代谢的排泄物，使毛细血管扩张，有效消除疲劳。

Precursor used in this experiment was spun in coagulating bath in different temperature, while the concentration in the bath maintained 60%.

在凝固浴中浓度为60％的情况下，在不同温度下的凝固浴中纺出原丝，用原丝凝固丝条的孔隙率和碘吸附量方法以及密度分析和电镜分析的方法对原丝的微观结构及最终碳纤维的性能影响进行了探讨。

The optimum bath components and operation conditions of electrodepositing Zn-Mn alloy from a sulfate-citrate bath were studied.

研究了硫酸盐-柠檬酸盐体系电沉积锌锰合金的镀液组分及工艺条件，讨论了主盐浓度、络合剂浓度、电流密度及pH等对合金镀层中锰含量的影响。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48