查询词典 heat-unit

With a constant space and different duty ratios, two conditions with high heat transfer performances emerged mainly due to the different degrees of influence of the heat transfer surface area and the rib thickness on the heat exchange performance.

以换热系数进行比较，当占空比为83％左右时，热沉表面温度最低，换热性能最佳；当间距恒定不变而占空比不同时，会出现两个换热性能较好的情况，主要是由于换热表面积和肋片厚度影响换热性能的程度不同。

By the concrete index and using request of 1 375 ℃ high strength castable refractory , 1 204 ℃ heat insulating refractory, 1 260 ℃ heat insulating refracrory,1 09 3℃ heat insulating refractory and 1 316 ℃ Si castable, the castable refractory for CSP billet soaking furnace is researched, which is acquired the good using effect.

根据CSP薄板坯均热炉用1375℃高强度浇注料、1204℃隔热浇注料、1260℃隔热浇注料、1093℃隔热浇注料和1316℃熔合硅浇注料的具体指标和使用要求，结合国内耐火原料的特点，研制出了满足CSP薄板坯均热炉使用需要的耐火浇注料，达到了预期效果。

The study of the influence of heat insulation layer on the result of deicing or snow-melting illustrates that if the cost of making heat insulation layer is high and the price of the electricity is proper, the heat insulation layer can be abandoned.

通过分析隔热层的存在与否对融雪化冰效果的影响，提出了可以考虑不设隔热层的方案。

The flow parameters, which controlled the heat transfer phenomena in the coolant channel of the piston, are identified; the experimental facilities and program will be established in accordance with the parametric conditions experienced by a real marine diesel engine. The experimental result for the flow within smooth-walled duct under the reciprocating motion will be used as the reference datum to assess the results for the study of heat transfer augmentation. As an attempt to enhance the cooling performance, the ribs will be installed in the coolant channels which flow was orthogonal mode for the piston moving direction. Finally, the results obtained for the tests with heat transfer augmentation devices will be compared with the smooth-walled test results.

本研究计画利用座标转换理论，对受到与往复运动正交方向之流场进行参数分析，建立控制此流场热传性能之参数后，模拟实际船舶主机运转时活塞之冷却情形并进行实验量测，作为评估活塞冷却之基准，然后应用现行已实用於工业界的技术，在与往复运动正交方向之圆形冷却通道中加装凸起物以增加热传效能并予以测量其热传系数及其相关之物理现象，据以讨论此流场受往复力之影响，在周向不同位置之热传情形以及其与平行於往复运动方向之流场的差异。

Comparison results show that heat pipe work is not continuous but fluctuant in one work cycle about five months,its actual working time is two-thirds of one work cycle,the cooling effect of heat pipe subgrade in winter is obvious,which is good for the contained cool increase of soil body and improves subgrade heat stabilization,there is a decrease for its cooling strength with the increase of horizontal distance,its effective operating radius is 2.25 m,its maximum cooling strength is in evaporation segment in depth direction,which low the thaw sensitivity of permafrost in the seasonal thaw layer about permafrost table.

研究发现，热棒在约为5个月的工作周期内并非连续工作而呈波动式，实际工作时间为工作周期的2/3；热棒路基冬季降温效果明显，有利于路基土体冷储量增加，提高路基热稳定性；热棒在路基中的降温强度，水平方向随距离增大而衰减，有效作用半径为2.25 m，深度方向在热棒蒸发段最大，降低上限附近季节融化层冻土热融敏感性。

The current problems and the corresponding reasons in heat supply network of jilin cancer hospital is analyzed,Top meet the needs of heat supply,the reconstruction project is designed based on the original heat net.

在满足区域内现有及新建建筑物供热需求并兼顾原热网敷设条件的基础之上，提出了热网改造方案，进行了设计。

In rebuilding systems, installs calorimeters and pressure difference controllers at heat entrances, adds evaporative heat meters, thermal static valves and hot water meters on radiators, while in contrasting systems, only sets heating meters at heat entrances.

改造后的系统在热力入口加总热量表、压差控制器，散热器上加温控阀、热分配表、热水表等，对比系统仅在单元入口加热量表。

Product is tetrafluoroethylene - perfluoroalkyl vinyl ether polymer resin by extrusion, blow molding expansion of heat shrinkable tubes, heat shrinkable tube temperature is -80 ℃~ 260 ℃, shrinkage temperature of 180 ℃-250 ℃, the general shrinkage of 30%, it has no viscosity, heat, weathering, corrosion resistance, anti-fouling, and high electrical insulation properties, is a steel bar rubber and silicone rubber coated roll the ideal casing, may be extended roller life, reduced wear and tear, widely used in chemical industry, electroplating, pharmaceutical, printing, papermaking and other fields.

本产品由四氟乙烯－全氟烷基乙烯基醚聚合物树脂经挤出、吹胀成型的热收缩管，热收缩管使用温度为-80℃～260℃，收缩温度为180℃-250℃，收缩率一般为30%，它具有不粘性、耐热、耐候、耐腐蚀、防污和电高绝缘性能，是钢棒橡胶和硅橡胶辊理想的包覆套管，可延长辊筒寿命、减小损耗，广泛地应用在化工、电镀、制药、印刷、造纸等领域。

To understand the different heat transfer characteristics of regenerative cooling in plug nozzle at different operating conditions, computational model of two dimensional plug nozzle and internal nozzle were established and numerical simulation was employed. Heat transfer results of the internal nozzle and the parameter distribution at the outlet were obtained. Flowfield and heat transfer characteristics of the plug at different operating conditions with different coolant flow rates were investigated.

为了解塞式喷管发动机高低空不同的再生冷却换热特性，分别对二维型面内喷管和塞锥建立计算模型，采用数值模拟的方法，得出内喷管的冷却换热结果和出口参数，重点研究了塞锥在地面和设计点工作时的不同换热特性及其冷却剂流量的影响。

Based on the theoretical of ice slurry phase flow and heat transfer, established a heat transfer model of ice slurry flowing in horizontal pipes, at same time analyzed the effects of flow and ice packing fraction on heat transfer of fan and coil

在传统液固两相流的研究成果基础上，建立起二元冰在水平管内换热的数学模型，同时针对二元冰在风机盘管中的输送情况，分析了输送速度、含冰率对于二元冰换热的影响

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。