查询词典 heat-resistant

Analyzing heat of combustion of paint layers measured by oxygen bomb calorimeter revealed that using monomers with lower heat content or optimizing formation for intumescent fire retardant paints can effectively reduce heat of combustion of paint layers and fire performance of painted plywood.

本研究并以弹氧热卡计进行标准燃烧热之测量，发现减少容易发出热量的高分子单体或改变使用剂量做为防火涂料可以有效的降低涂膜本身的燃烧热，亦可提升涂布后薄合板之耐燃性能。

This paper gives a review of the heat transfer of supercritical carbon dioxide in-tube flow and points out that the main factors to influence heat transfer are heat flux, buoyancy, pressure,lubricant and so on.

概述了超临界CO2流体管内对流换热的研究，指出了影响换热的主要因素有热流密度、浮升力、压力、润滑油等，提供了多种公开发表的超临界流体在冷却工况下的换热关联式，同时指出了现有研究内容的不足。

In this thesis, we design and test the electrical circuit modules of this kind of heat meter beginning with hardware design, conduct the design of the software for heat meter, and devise the IC card writer. As a result, we realize the functions of IC card controlling, heat measuring, and flux displaying.

本文从底层的硬件设计开始，对热量表的各硬件电路模块进行了设计和测试，完成了热量表的软件设计，制作了IC 卡写卡器，对IC 卡控制热量表进行了系统测试，实现了热量表的IC 卡控制、热量计量、显示等功能。

According to heat load source of die cavity, temperature distribution gradient equations and heat flux equations and the peak value equations of temperature load at die cavity surface have been obtained with research of temperature distribution and transfer laws of die surface by unsteady heat transfer theory.

摘要根据锻模型腔热负荷来源，通过非稳态传热理论，分析研究了模具工作表面层的温度分布与传递规律，给出了型腔表面温度分布梯度和热流密度公式，并给出了锻模型腔表面的温度负荷峰值的计算公式。

According to heat load source of die cavity, temperature distribution gradient equations and heat flux equations and the peak value equations of temperature load at die cavity surface have been obtained with research of temperature distribution and transfer laws of die surface by unsteady heat transfer theory.

新闻摘要：根据锻模型腔热负荷来源，通过非稳态传热理论，分析研究了模具工作表面层的温度分布与传递规律，给出了型腔表面温度分布梯度和热流密度公式，并给出了锻模型腔表面的温度负荷峰值的计算公式。

The energy balance of flue gas, radiative heat transfer equations and zero dimensional model of heat transfer are derived in the multiple combustion boiler combining a chain grate with a pulverized coal, considering the radiation heat between the lower and upper zone in the furnace.

将链条炉排加煤粉复合燃烧锅炉的炉膛分成上下两部分，导出了上下炉膛的烟气热平衡方程、辐射换热方程及炉膛传热计算的零维模型，方程中考虑了上下炉膛间的辐射换热。

By Using the 3 D unsteady state heat transfer equation,the heat convection and radiation between the checker and the gas which flows through the checker holes,and the heat conduction among the checker in the chamber of the hot blast stove were studied.

应用三维非稳态热量传输方程，对高炉热风炉在燃烧过程中蓄热室内格子砖与气体之间的对流和辐射传热，以及格子砖内部的导热过程进行了耦合求解得到了在燃烧期内格子砖及燃烧过程中燃烧废气的温度分布情况及其随时间的变化规

By using the 2-D unsteady state heat transfer equation,the heat convection and radiation between the checker,the gas flowing through the checker holes and the heat conduction among the checkers in the chamber of the hot blast stove were studied.

应用二维非稳态热量传输方程，对高炉热风炉蓄热室内格子砖与气体之间的对流和辐射传热，以及蓄热体内部的导热过程进行求解，分析热风炉的不同操作制度对热效率的影响。

The major works are as follows: 1 The 3-D numerical model of U-sharp flow passages is set up. The single-phase fluid flow and heat transfer are simulated for the U-sharp smooth and rib-roughened flow passages with FLUENT software. Their performance curves, temperature field and velocity vector are obtained and the local heat transfer and flow pressure-drop distribution along flow passage are analyzed. It is revealed that the ribbed flow passages can enhance heat-transfer and make the temperature more uniform, but it increases the pressure-drop to more extent. 2 The influences of diaphragm depth, channel width and board spacing on the performance are investigated.

建立了层叠式蒸发器U形流道的3维湍流模型，用FLUENT软件对尺寸相同的U形光滑流道和肋化流道中单相流体的传热和流动进行了数值模拟，得到了两种流道的传热和阻力性能关系曲线及速度矢量图、温度场，分析了光滑流道和肋化流道的局部换热系数及沿程压降变化，结果表明流道的肋化能有效的增强传热，而且使流体的流动和传热更加均匀，但也较大地增大了阻力。

The control thermal resistance is that of natural convection and thus heat pipe radiator can be simplified as a vertical plate channel heat radiator. The influence of tilt angle to thermal resistance of heat pipe radiator is also discussed in this paper.

该散热器的控制热阻为翅片与空气间的自然对流热阻，其间的传热可简化为倾斜通道自然对流的传热，在竖直平板通道模型的基础上加以翅片倾斜角度的修正。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。