查询词典 heat-killed

Terrestrial heat flow ; Crustal thickness ; Rock radiogenic heat ; Mantle heat flow.

大地热流；地壳厚度；岩石放射性生热；地慢热流

The work had been carried out can be summarized as follows: 1. Thermal cycle analysisBased on the classical thermodynamics, influence of isobaric reheat and isovolumetric reheat on cycle output is discussed. Based on the finite time thermodynamic theory, the thesis discusses the optimization of Rankine cycle, Brayton cycle and Stirling cycle between constant temperature heat source and constant temperature heat sink or between variable temperature heat source and constant temperature.

第一、循环优化分析：采用经典热力学研究了等压再热与等容再热对循环功的影响；采用有限时间热力学深入研究了恒温热源一恒温冷源和变温热源一恒温冷源液氮发动机朗肯循环、布雷顿循环和斯特林循环的优化和对比；着重研究了工质导热率与热机换热器总导热率之比对循环性能的影响、高温侧换热器导热率与低温侧换热器导热率之比对循环功率的影响等内容；得到了一些对循环和系统设计具有现实指导意义的结论。

Note that the direct conversion of nuclear energy to electricity is not how a nuclear power plant produces electricity; instead it uses the heat of a nuclear reaction to run a heat engine, and transforms the heat engine's resulting mechanical energy into electricity via magnetic induction.

请注意，核电站并不是通过直接将核能转换为电能来发电的，而是使用了热核反应驱动热力发动机，并通过磁感应将热机输出的机械能转化成电能。

The results indicate that the uniformity of temperature difference in panel heat-exchanger can be the directive effect in the design of heat exchange system with small temperature difference, and the heat pump technology is one of the effective measures in the rundle using o...

结果表明换热器传热温差的均匀性原则对小温差换热系统设计有指导作用；热泵技术是地热能梯级利用的有效措施之一。

By choosing fuels with an increased degree of sootiness it was found that the heat fluxes do not depend only on the gas temperature, as claimed before for heat fluxes on the floor, but also on the magnitude of the heat release rate and the fuel sootiness.

在选择燃料方面，笔者的依据是燃料燃烧产生的烟尘应越来越浓。试验发现，与以前对地板的研究结果有所不同的是，墙体上的热通量不仅仅取决于烟气温度，还取决于热释放速率的强弱以及燃料所产生的烟尘的多少。

The dynamics and heat transfer on the spinning line during the air drawing process are discussed in detail, mainly relating the forces acting upon the polymer along the spinning line and the expressions of the air drawing coefficient C〓 and heat transfer coefficient h. By introducing the power-law model as the constitutive equation to describe the theological properties of polymer melt and considering the changing of the density and specific heat capacity of polymer melt at constant pressure with the polymer temperature, the former model of polymer air drawing is improved and a complete polymer air drawing model is established, which is integrated with the model of air jet flow field of dual slot die.

在此基础上，对前人的聚合物拉伸理论模型进行了改进，以幂律模型作为描述聚合物熔体流变行为的本构方程，并考虑了聚合物熔体密度和定压比热随聚合物熔体温度变化而变化这个因素，从而建立了完整的熔喷聚合物拉伸理论模型。

The cooling system is more suitable for the purpose of: heat recovery and forced-air cooling, water cooling has high specific heat capacity, it stores a lot of heat energy, have higher density.

水冷系统更适合热回收的目的：与风冷相比较，水冷具有较高的比热容量，它存储了大量的热能，有较高的密度。

At first,the limitation of the general heat conduction equation is discussed and then,nonlinear heat conduction equations are derived,when we consider that thermal conductivity,specific heat capacity and density are dependent of temperature.

研究了线性情形中热传导方程的局限性，在此基础上考虑到热传导方程中导热系数、比热容、密度与温度的关系，导出了非线性热传导方程，并求出了几类非线性热传导方程的孤波解。

So the present study was taken to compare the differences in the mechanisms of dissipating excess light energy in cucurbit crops and to study the differences in both the ROS metabolism in root system and the photosynthesis among six cucurbit crops with different temperature tolerance growing at different root-temperatures. The main results are as follows: 1、The species specific response of three cucurbit crops with different heat-tolerance: warm-adapted cucumber, heat-tolerant sponge gourd and heat-sensitive figleaf gourd to diurnal changes in air temperature and irradiance intensity were investigated in a typical summer sunny day. Three cucurbit species were compared using parameters in gas exchange, chlorophyll fluorenscence, photon allocation and photosynthetic electron flux.

因此，本试验以温度敏感性不同的瓜类作物为材料，研究了夏季自然条件下不同物种间在耗散过量光能的主要机制差异；探讨了它们对不同根际温度在根系活性氧代谢及地上部光合作用等方面的生理响应差异，所取得的主要结果如下： 1、在夏季晴天条件下，三种温度敏感性不同的瓜类作物：喜温的黄瓜，耐热性的丝瓜与热敏感的黑籽南瓜在气体交换、叶绿素荧光、光能分配及光合电子流对一天中温度与光照环境变化的响应上存在物种间差异和日变化特征。

Pass to count to Wisterch parameter , and the steel wire is different from the molding tool get in touch with the length, and settle the path the research taking the length work the stabber angle to get under differently pull to stir the term, mold core adoption of best severally why size, combine the best work stabber of research the Cape, and settle the path to take the length nextly steel wire is in the molding tool of have fever to measure, air inside dispel-heat calories, winding dispel-heat on the coil-canister , and its molding tool dispel-heat calories of, and cause the steel wire the temperature difference pass in and outing the molding tool to influence steel wire machine function, under the experiment inside pull to stir the term according to the same race different work stabber Cape half of adoption the Cape(7 degree,10 degree,12 degrees, the best mold Cape, experience mold Cape) settle the path to take the length(2-3 mm,3-4 mm,4-5 mms, theories length, experience length) to proceed to experiment, and get the conclusion, work stabber the Cape then is more big the steel wire get in touch with the length with

通过对Wisterch参数，钢丝与模具接触长度、定径带长度、工作锥角度的研究得到了在不同拉拨条件下模芯采用的最佳几何尺寸，并研究最佳工作锥角、定径带长度下钢丝在模具中的发热量、空气中散热量、卷筒上的散热量及其模具散热量的不同，导致钢丝进出模具的温度差别对钢丝机械性能的影响，在实验中根据同种拉拨条件下采用不同工作锥角半角、定径带长度进行试验，得出结论，工作锥角越大则钢丝与模具接触长度越短，钢丝变形越剧烈，在模具中发热量就越高，导致钢丝出模温度高，使钢丝强度、硬度升高，弯曲、扭转次数降低，并且降低模具使用寿命。在其它条件相同的情况下，定径带越长则钢丝与定径带简壁磨擦增大，使钢丝发热量加大，从而使钢丝强度、硬度略升高，弯曲扭转次数略降低但定径带的增大减小了钢丝变形产生的弹性后效使钢丝出模直径比较稳定。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。