查询词典 heat-insulating layer

Content, strong radiant heat resistance, thin-layer insulation, waterproofness, radiation resistance, strong tensile resistance and flexibility under all temperatures, as well as durableness and energy-saving.

经过不断努力，现已推广应用的"CC-100瓷层绝热节能液体材料涂层系统"和"纳米气凝胶保温毛毡"是开创现代科技领域应用的技术先锋，在国内外市场均引起广泛关注。

Research shows : laser treatment, the hardening layer from the melting zone, transformation hardening and the heat-affected zone, organizations to small uniform martensite, have a high density of dislocations, which are high hardness and wear resistance of the main reasons.

研究表明：激光处理后的硬化层由熔凝区、相变硬化区和热影响区，组织为细小均匀的马氏体，产生了高的位错密度，这些是硬度和耐磨性高的主要原因。

The frictional heat energy was concentrated on the thermal effect layer with the thickness of 4 mm, The temperature gradient of contact surface is the highest, and decreased rapidly with the radius direction of the lining's groove. The temperature gradient and TEL's thickness increased with the increasing of the sliding speed. The temperature decreased rapidly with the radius direction and also with the increasing of center angle of the lining's groove. The sliding speed and distance are obtained under two sliding conditions when the lining fails, which supply the theoretical basis with the antislip design of friction hoist.

摩擦热量集中在热影响表面层，其厚度仅为4mm，接触表面温度梯度最大，沿绳槽径向迅速减小；温度梯度和热影响表面层厚度随相对滑速的增大而增大；衬垫温度沿径向急剧降低且随圆心角增大而减小；并得到了2种滑动工况下衬垫失效时的相对滑速和滑动距离，为摩擦提升防滑设计提供理论依据。

The bonding strength of bonelike apatite layer formed on the titanium oxide films to the substrates under different heat treatment temperature is examined under tensile s...

当对氧化钛膜进行适当的碱处理和热处理，在人体仿生液SBF溶液中浸泡7天后表面形成的骨质磷灰石与基体的结合强度可达到36MPa。

The research contents and main conclusions are as follows:1. The present thesis adopted one-dimension interior ballistic model, regarding the ballistic spatial core as the unsteady quasi one-dimension airflow containing the friction and heat exchange between airflow and tube wall, considering the boundary layer unsteady, nonstationary condensable current; and employed the MacCormack finite difference method to write the program.

本文的研究内容及结论主要体现在以下几个方面： 1、采用了一维内弹道模型，把弹后空间的核心流部分考虑为包含气流与身管管壁发生摩擦和热交换的不稳定准一维流，边界层考虑为不稳定、非定常可压缩流，用MacCormack有限差分方法求解，编制程序进行计算，较为准确的得到了复合材料身管固壁瞬态温度场分析内边界条件所需的气流温度和对流换热系数结果。

Content, strong radiant heat resistance, thin-layer insulation, waterproofness, radiation resistance, strong tensile resistance and flexibility under all temperatures, as well as durableness and energy-saving.

经过不断努力，现已推广应用的&CC-100瓷层绝热节能液体材料涂层系统&和&纳米气凝胶保温毛毡&是开创现代科技领域应用的技术先锋，在国内外市场均引起广泛关注。

The microstructure of MDF and MDF tested were studied. The results showed that the fibers in MDF are arranged randomly. Some of them arranged separately, most of them arranged in bundles. There are many blind holes between the fiber cells in MDF. The damage of MDF's compressive creep is the result of new cranny occuring, spreading and the combination of old cranny. In the repressing process, besides the pressure, heat is also the main factor on the damage of MDF, which can accelerate the adhension layer to deteriorate and lead to the gule strength decreasing.

结果表明：MDF的纤维排列无规则，纤维排列形态除少量纤维呈单根状外，大量的纤维以纤维束的形态排列；纤维之间存在许多大小不等的孔洞，呈不贯通状；MDF蠕变损伤是不断萌生新的裂隙并扩展和合并原有裂隙的结果；MDF二次加工过程中，除了压力是破坏MDF结构的主要因素外，加热温度使MDF胶层老化，胶合强度下降，也是破坏MDF结构的主要因素；MDF的破坏形态除了有纤维拉断外，还有纤维拔出和胶粘剂脱落。

Methods of forming a pattern of filled dielectric material on a substrate by thermal transfer processes are disclosed comprising exposing to heat a thermally imageable donor element comprising a substrate and a transfer layer of dielectric material.

公开了通过热转移工艺在基底上形成填充介电材料图案的方法，包括将包含基底和介电材料转移层的热成像供体元件向热暴露。

It emphasizes the study of temperature stress induced by hydration heat during underwater indiscrete concrete pouring into the proof seepage layer of the dam.

着重对防渗层浇筑过程中因混凝土水化热产生的温度应力进行了研究，其中考虑了自生体积膨胀、应力徐变的影响，得出了对工程指导有益的结论。

With the design of multi-layer circuit board makes the informity of current distribution, quick heat dispelling, long life span and

多层电路板结构设计，电流分布均匀，功耗小、散热快，有效延长屏的寿命，可靠性高

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。