查询词典 heat-exhaustion

In order to simulate phenomenologically the process of transformation from fuel injection rate to heat release rate, a quasi-dimensional combustion model has been established, which includes fuel-air mixing, droplet evaporation, ignition delay, heat release and heat transfer.

在只有喷油规律的条件下，本文建立了分韦柏放热规律模型，通过对喷油规律依次分段，各分量按各自韦柏规律燃烧，实现了从喷油规律对放热规律的直接快速预测。

In the meantime, Ingersoll and plass Kelvin line source in accordance with the concept of the underground pipe line heat source heat exchanger theory, but at that time because of low energy prices, high system costs, has not been widely applied. 70 era, the oil crisis put people's attention to the energy-saving, cost-effective use of energy, so that the development of ground-source heat pump into the climax stage, when the underground pipe from an early plastic pipes replaced by the amount of possession.

在此期间，Ingersoll和Plass根据Kelvin线源概念提出了地下埋管换热器的线热源理论，但当时由于能源价格低，系统造价高，没有得到广泛应用。70年代，石油危机把人们的注意力集中到节能、高效益使用能源，使地源热泵的发展进入了高潮阶段，此时地下埋管已由早期的金额管改为塑料管。

The tendencies of HSP70 protein and mRNA expression are splenogastric hygropyrexia syndrome group＞deficiency of spleen-QI syndrome group＞normal control group,and heavy heat impairing dampness＞simultaneous onset of dampness and heat＞heavy dampness impairing heat.HSP70 expression may be prompted with the certificate type of syndrome may exist a certain degree of correlation.HSP70 was obviously expressed in pyretic syndrome.

Hp感染程度可能与胃粘膜炎症程度及炎症的活动性呈正相关，Hp感染程度越重，胃粘膜的炎症越重。5、HSP70蛋白和mRNA表达水平呈现脾胃湿热证组＞脾气虚证组＞正常对照组的趋势；而在脾胃湿热Hp组各亚型中，又呈现热重于湿＞湿热并重＞湿重于热的趋势。

In this paper,the influence of both the convective heat transfer of foil and the heat conduction in thermocouple wire on the performance of the radiational thin-foil heat flow meter has been considered and a precise mathematic model for this condition is presented and analysed in detail.

本文全面考虑了圆箔式辐射热流计中对流放热及热电偶丝导热对热流计特性的影响。建立了完整的数学模型，对灵敏度进行了详细的分析。

Through this material one could setup an overall impression of the study content and the study method.In order to investigate the basic heat transfer characteristics of regeneratively cooled scramjet, in the second chapter, one dimensional heat transfer model of regeneratively cooled scramjet was developed. In this model, N-R correlations were used to describe hot gas-side and coolant-side convection heat transfer. Simple model of gas properties was also used.

为了初步了解超燃冲压发动机再生冷却传热的基本特征，第二章建立了超燃冲压发动机再生冷却的一维传热数理模型，采用了准则关系式描述燃气侧和冷却剂侧的对流换热，采用了简化的燃气物性模型，并对衬层材料、衬层厚度和冷却剂流量进行了参数研究。

The heat pipe technology is one of the most efficiency method to solve the key technique for hard problems in order to gain high efficiency of resource utilization and good economy benefit in the application of renewably energy,In this paper,characteristics of the heat pipe technique is introduced,and its application and exploration in the solar energy,subterranean heat energy,living material energy are reviewed.

笔者结合热管技术特点，综述了其在太阳能、地热能、生物能三大能源利用领域中的国内外进展。1热管技术的技术特点[1](1)高的导热性。热管内部主要靠工作液体的汽液相变传热，热阻很小，因此具有极高的传热效率。(2)优良的等温性。

Design indoor temperature of residental buildingfor household heating and heat metering was studied in this article based on thermal comfort formula and PMV/PPD evaluation index. It can be determined that when indoor temperature is 20℃ and varies in the range of 16℃~24℃,it's feasible for thermal comfort,woking efficiency and health standard,thus the key problem of heat load calculation is resolved. It's significant for perfecting heat metering techniques and providing specifications of HVAC.

简介： 本文从热舒适、工作效率、健康标准等方面出发，以热舒适方程及PMV/PPD评价指标为依据，对采用分户计量供热系统的居住建筑的室内设计计算温度的确定进行了研究，确定其为20℃，室温变化范围是16℃～24℃，从而解决了热负荷计算的核心问题，对完善热计量技术及相关暖通规范的编写有一定的指导意义。

In actual reactors, the cooling condition outside the hexcan-wall of blocked fuel subassembly is analogous to its counterparts in the SCARABEE BE+ experiments. The upward and downward heat transfer could be neglected, while the radial heat transfer plays a key role in slowdown the accident scenario. As time goes on, the dominant radial heat transfer mechanism is liquidus sodium convection at first, and then gradually transforms into sodium condensation near the inner surface of the hexcan-wall, and finally becomes volume heated boiling pool convection.

对实际快堆中发生全堵的燃料组件而言，其外部的冷却条件与SCARABEE BE+系列实验非常相似；2）堵流组件向上和向下的传热可忽略不计，径向传热对事故有较强的延缓作用；3）随着时间推进，径向传热的主导机理依次为液态钠单相对流、钠蒸汽在组件盒内壁冷凝、体热源沸腾池散热。

Development of speciality resin for heat shrinkable film ;2. The heat sensitivity of polyvinyl chloride heat shrinkable film was described.

阐述了聚氯乙烯热收缩膜的热敏性，并从生产实际的角度详细讨论了PVC热收缩膜热敏性的影响因素以及热敏性与成型收缩率和贮存性能之间的关系。

Toop's model and Miedema method are to be used to calculate the heat of formation of ternary compounds. A projected method is used to obtained the heat of formation of AB_(1-x)G_x. The heat of formation is negative for GaAs_(1-x)P_x and for GaAs_(1-x)N_x compounds in the all range and for GaP_(1-x)gN_x compound in the

我们分别用Pauling和Phillips经验方法及Miedema半经验方法计算[59]得到Ⅲ-Ⅴ族二元合金的生成热，比较三种方法，均只定性与实验结果吻合，但Miedema方法具有准第一原理特点，可以从组元基本特性出发来得到合金生成热的数据；我们把TOOP'S模型引入计算中，并把计算结果投影到Ⅲ族组元总浓度等于所有Ⅴ族组元总浓度的平面上，即计算AB_(1-x)C_x合金系的

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。