查询词典 heat-conducting

The effect of each HMEon temperature, convective heat loss, evaporative heat loss,total heat loss, relative humidity, and absolute humidity ofinspiratory gases was determined.

每种汽热交换仪可测量吸入气的温度、对流热丧失、挥发热丧失、总热丧失、相对湿度、绝对湿度。

For the turbulent developing flow of absorbing and isotropic scattering medium in a circular tube, the steady state heat flux of the coupled heat transfer of turbulent convection and thermal radiation under constant wall heat flux was investigated numerically.

对圆管内物性随温度变化的吸收-各向同性散射介质的湍流入口段，数值研究了定热流加热下辐射与湍流正在发展流耦合换热的稳态热流特征。

To investigate the thermal protection effects of a heat sinking vest with phase-change material in high-temperature and high-humidity environment and the feasibility of numerical computation of heat transfer to the vest,based on the analysis of heat and mass transfer characteristic about the accouterments,a thermodynamic model was set up with the enthalpy method.

为了研究相变材料降温服在高温高湿条件下的热防护性能和相变材料数值计算方法应用于降温服传热计算的可行性，在分析服装传热传质特点及计算方法的基础上，利用焓值分析法对服装中的相变材料建立传热模型，在整个区域建立统一的能量方程，在区域结点进行离散，并进行隐式求解，得到焓的分布。

To investigate the thermal protection effects of a heat sinking vest with phase-change material in high-temperature and high-humidity environment and the feasibility of numerical computation of heat transfer to the vest, based on the analysis of heat and mass transfer characteristic about the accouterments, a thermodynamic model was set up with the enthalpy method. The uniform energy equation was constructed for the whole domain, and the implicit difference equation was used in every node, the distribution of enthalpy was solved by numerical method.

为了研究相变材料降温服在高温高湿条件下的热防护性能和相变材料数值计算方法应用于降温服传热计算的可行性，在分析服装传热传质特点及计算方法的基础上，利用焓值分析法对服装中的相变材料建立传热模型，在整个区域建立统一的能量方程，在区域结点进行离散，并进行隐式求解，得到焓的分布。

Thus, the heat content from the waste gases from blast heating apparatus or those arising in the afterburning of waste gas flows from tunnel driers for the removal of solvent residues can be fed back into the process via a heat transfer medium circuit to preheat the fuels and fuel air or to heat up the material to be dried.

因此，来自于废气/加热设备/燃烧形成的热气流/移走废弃的隧道干燥设备等的热量可以通过一个闭路循环的导热油把热量循环利用或者用来加热需要干燥的物质。

According to the present situations of the two production lines and the temperature needed by the producing technics of the heat-exchanger , using the numerical simulation with the Airpark software to analyze the reason why the cooling system can not meet the technicals requirement; with the heat transfer theory computation based on the heat transfer principle, the technical parameters of the cooling sect refer to the system technic and configuration are obtained. That are made for reasonable organization of the airflow of the cooling system and the new cooling equipment achieving the technical requirement. At the same time, it will ease the thermal pollution of the circumjacent environment and improve IAQ of the workshop

根据某厂两条换热器生产流水线的现状和冷却降温的工艺要求，用Airpark 软件进行数值模拟，分析了冷却系统无法满足工艺要求的原因；运用传热学原理进行了设备与环境的传热理论分析和计算，分析了冷却系统无法满足工艺要求的原因，得出了改造所需要的技术与结构参数，并对冷却系统进行合理布局与气流组织，使新的冷却系统发挥了应有的作用，满足了生产工艺的要求，同时也减轻了生产环境的热污染，提高了环境的空气品质。

The aluminum groove used for heat dissipation is extrusion molding by 6030 aluminum ,and through anodize precessing technic ,with scientific struction for heat dissipation design ,which can solve the problem of heat dissipation efficiently , and can longer the life-span of LEDs , In addition ,the driver power utilize constant current IC driver ,which can asure the precise of power output and the stability during the couse of using .

散热铝槽采用6063铝挤出成型，经过阳极氧化等加工工艺处理，加上科学的散热结构设计，有效解决灯管散热难的问题，大大提高 LED 使用寿命。驱动电源采用恒流 IC 驱动方案，电流输出的精度高，确保 LED 使用的稳定性。

The results show that the glass-ceramics with fibroid structure is produced after definite heat treatment, the main crystallization phase is hedenbergite and anorthite is the minor crystallization phase. The optimal process of heat treatment shows as follows: the nucleation temperature is 850 ℃ and hold time is 100 min, and the crystallization temperature is 980 ℃ and hold time is 80 min. With increasing heat treatment temperature, the FT-IR absorption bands appear obvious split, the aluminum-oxide polyhedron in the glass network changes from [AlO4] to [AlO6]. The titanium ion in the glass network gradually transforms to the 6-coordinated, moreover forms minicrystal of MgTi2O5 and Fe2TiO4 which provides the position of heterogeneous nucleation for the growth of crystal.

结果表明：在一定的热处理条件下可以以基础玻璃制备出主晶相为钙铁透辉石，次晶相为钙长石的纤维状结构的微晶玻璃；最佳的热处理工艺为：850 ℃核化100 min，980 ℃晶化80 min；随着热处理温度的升高，红外吸收带发生明显的分裂；玻璃结构中的[AlO4]向[AlO6]转化；网络结构中的钛离子逐渐转变为六配位，形成微晶相——钛酸镁和钛铁晶石，为晶体的生长提供非均匀形核位置。

Products introduction of Magic Ice-cap : It is develop by ordinary regeneration product of summer hat, it adopts the special refrigeration material , utilize moisture evaporate principle heat absorption lower the temperature , can sunshade sun-proof not merely , skin care protects the eye, have a good one cool to solve the heat , clear brain refresh oneself on function , and have antiultraviolet functions also, in scorching a summer bring people ice-cold impression, can be rated as " little air conditioner with oneself ", it does not consume energy , only uses water, can use for more than three years repeatedly , it is remarkable , easy to use , nonpoisonous and harmless to cool the result, not having side effect to the human body, relieves summer heat except the prickly heat, the clear spirit is striking, go sightseeing , work life not to prevent heatstroke and lower the temperature the indispensable good merchantable brand for a new generation.

凉爽冰帽是普通凉帽的换代产品，它采用进口特殊制冷材料，利用水分蒸发原理吸热降温，不仅能遮阳防晒，护肤护目，还具有良好的清凉解暑、清脑提神作用，而且具有防紫外线功能，在炎炎的夏季带给人冰凉的感受，堪称&随身小空调&，它不耗能，只用水，可反复使用三年以上，降温效果显著，使用方便，无毒无害，对人体无副作用，消暑除痱，清神醒目，为新一代旅游观光、工作生活防暑降温必备佳品。

This paper discusses the property of heat insulation of composite heat shield s made from ablative layer and heat insulation layer manufactured from heat insulation material.

本文对两种隔热层由不同绝热材料制备的复合防热构件材料的隔热性能进行了研究。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐