查询词典 heat up

To investigate the thermal protection effects of a heat sinking vest with phase-change material in high-temperature and high-humidity environment and the feasibility of numerical computation of heat transfer to the vest,based on the analysis of heat and mass transfer characteristic about the accouterments,a thermodynamic model was set up with the enthalpy method.

为了研究相变材料降温服在高温高湿条件下的热防护性能和相变材料数值计算方法应用于降温服传热计算的可行性，在分析服装传热传质特点及计算方法的基础上，利用焓值分析法对服装中的相变材料建立传热模型，在整个区域建立统一的能量方程，在区域结点进行离散，并进行隐式求解，得到焓的分布。

To investigate the thermal protection effects of a heat sinking vest with phase-change material in high-temperature and high-humidity environment and the feasibility of numerical computation of heat transfer to the vest, based on the analysis of heat and mass transfer characteristic about the accouterments, a thermodynamic model was set up with the enthalpy method. The uniform energy equation was constructed for the whole domain, and the implicit difference equation was used in every node, the distribution of enthalpy was solved by numerical method.

为了研究相变材料降温服在高温高湿条件下的热防护性能和相变材料数值计算方法应用于降温服传热计算的可行性，在分析服装传热传质特点及计算方法的基础上，利用焓值分析法对服装中的相变材料建立传热模型，在整个区域建立统一的能量方程，在区域结点进行离散，并进行隐式求解，得到焓的分布。

Thermal models of parallel moving heat source, oblique moving heat source, and circle arc moving heat source are set up and analyzed.

采用均布热源建立平面移动热源模型、倾斜运动热源模型和弧形热源模型，并进行了分析。

It builds the whole liquid-cooling system mainly by the design of the liquid-cooling decalescence boxes(improve its bottom material from aluminium alloy to pure copper, enlarge its volume, better cooling effects, and strengthen pressurization), by the operations of cooling effect about the heat exchanger worked by its temperature adjustability of the ribs(diffuse the heat fleetly owing to the excellent diathermancy of the material of the ribs ,make effective diathermancy owing to ribs outside areas, and drive the heat of the ribs away by the fans), and by the water pump made up of the piezoelectric ceramic with the excellent performance-no electromagnetism interference, little cubage, little noise, light exterior, light weight, low consume, high flux, replacing the mechanical pump.

在液冷散热器的研究中，主要通过对液冷吸热盒设计不断地改进(使吸热盒底部的材料从铝合金变为纯铜材料，其整个体积有所变大，但其散热效果明显变好，且密封性得到了极大地加强)，综合地运用换热器中肋片的壁面温度调节作用产生的散热效果(肋片材料优良的导热性，快速地扩散了热量：肋片较大的与流体接触的表面积，使传热更加充分，对流热阻大大减小；再利用风扇对肋片上的热量进行吹散)，利用性能优良的压电陶瓷泵(该泵机电性能稳定，具有无电磁干扰、体积小、噪音小、外型轻薄、重量轻、低能耗。、高扬程等优点。)代替机械泵作为驱动源，搭建了整个散热系统。

Heat it up don't heat it up i might have falling love with style it's ok i want u baby now it's ok love me tonight it's ok i want u baby now it's ok , it's ok why don't u leave me when i really need me , myself and I ,baby i don't want u to change my mind ah ah I forget this forget about a night so wonderful so mense Stiring ur finger in my pie ah but...

向上加热它不向上加热它 i 可能已经落下有风格的爱资讯科技是 ok 你需要你现在纵容资讯科技是 ok 今晚爱我资讯科技是 ok i 需要 u 现在纵容资讯科技是 ok，资讯科技是 ok 当 i 真的需要我的时候， u 何不离开我，我自己和我，宝贝 i 不想要 u 改变我的想法啊啊我忘记这大约一个夜晚忘记如此令人惊奇如此 mense 我的派 Stiring ur 手指啊但是。。。

Over the years, obsorbing the advanced technology, the Association has developed the straight line drawing machines, wet drawing machines, upside down style wire drawing machines, spool take-up, pay-off unit, wheel heat treating winder, heat treatment take-up, pay-off unit, strander machines, pre-treatment line machines.

多年来，吸收先进的专业技术，已研制开发了具有国内领先水平的直进式拉丝机，水箱拉丝机，倒立式拉丝机，收放线机组，工字轮热处理收线机，热处理收放线机组，预处理作业线，管式股绳机和成绳机。

Using the opened thermosiphon of 38x3 as experimental element and water as working fluid,the characteristics of dynamic low load boiling,stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0.02-0.1MPa and 0.1-0.8MPa respectively,which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas.

本文以工程上常用的Φ38×3的开口封底为实验元件，以水为工质，对开启式热管内的动态低负荷沸腾、稳态旺盛沸腾及临界沸腾特性进行系统的可视化实验研究，实验压力为0.02～0.8MPa，实验得出了Φ38×3的开口封底管在工作压力为0.02～0.8MPa和0.1～0.8MPa下的管内沸腾传热系数及临界热负荷计算关联式，弥补了开口封底管——这一新型传热元件尚无准确的沸腾换热关联式的缺陷。

The major works are as follows: 1 The 3-D numerical model of U-sharp flow passages is set up. The single-phase fluid flow and heat transfer are simulated for the U-sharp smooth and rib-roughened flow passages with FLUENT software. Their performance curves, temperature field and velocity vector are obtained and the local heat transfer and flow pressure-drop distribution along flow passage are analyzed. It is revealed that the ribbed flow passages can enhance heat-transfer and make the temperature more uniform, but it increases the pressure-drop to more extent. 2 The influences of diaphragm depth, channel width and board spacing on the performance are investigated.

建立了层叠式蒸发器U形流道的3维湍流模型，用FLUENT软件对尺寸相同的U形光滑流道和肋化流道中单相流体的传热和流动进行了数值模拟，得到了两种流道的传热和阻力性能关系曲线及速度矢量图、温度场，分析了光滑流道和肋化流道的局部换热系数及沿程压降变化，结果表明流道的肋化能有效的增强传热，而且使流体的流动和传热更加均匀，但也较大地增大了阻力。

In respect that various requirements of load and temperature on different parts of the baker, firebrick lining was chose reasonably, and the dosage of light heat preservation brick is in enlargement. As a result of that, the weight of the furnace was decreased, and increased its performance of heat preservation and cumulation was increased consumedly. With the use of ""W"" type fire tunnel and straight-through dilatation joint, and two enlargement of the perpends on the wall appropriately, all the problems of heat preservation in the anode baker, uniform temperature in the tunnel, and its life span were solved effectively. In the research of anode blocks in and out of the furnace, and of tidying it up, the multi-function crane clamps was alented and the assembling unit was reconstructed, which made it easy to automatic ally assemble the carbon blocks of various specifications with only one set of assembling unit.In the aspects of automation, a new type pulse combustor and solid thermocouple, as a result of that, not only the control accuracy of the fire tunnel's temperature was increased, but also the system function was improned to be more dependable, safe and practicable.

在焙烧炉炉体研究方面，针对焙烧炉不同部位的负荷及温度要求的不同，合理选用耐火材料，加大轻质保温砖的用量，既减轻炉体的重量，又大大提高炉体的保温蓄热性能；火道墙采用&W&型火道结构，直通性膨胀缝，并适当加大火道墙竖缝，有效地解决了阳极焙烧炉的保温、火道温度均一及火道墙的使用寿命等问题；在阳极炭块装出炉及清理等研究方面，通过对编解机组及多功能天车夹具进行改造，实现一套机组对多规格炭块的自动编组、解组及装出炉问题；焙烧炉自动化控制研发中，采用先进的分散式控制系统，研制开发新型脉冲燃烧器及实体型热电偶，不仅提高了火道温度的控制精度，而且提高了系统的可靠性、安全性、实用性。

By setting up the mathematical models of the regulating objects （combusting heat transfer, heat utilization and storage, superheater and main steam pipe line）, by combining heat transfer function of regulating system and by selecting method of setting PID accoding to set attenuation index object, the corrections among PID and pulverized coal＇s caloric values are found. Now the PID can be set according to caloric values of the pulverized coal burned in the unit and the automatic control can be put into operation.

通过建立调节对象四个环节（燃烧传热过程、热量的利用和储存过程、过热器、主蒸汽管道）的数学模型，结合调节系统的传递函数，选用按给定衰减指数设定PID参数的方法，找出PID参数与煤粉热值的关系式，最终达到在机组燃烧不同热值的煤粉时可依据该方法设定不同的PID参数、并都能投自动的目的，从而有利于提高机组的稳定性，并可节约煤粉。

The concept of equivalent rotationally rigidity is offered and the formula of rotationally rigidity is obtained.

主要做了如下几个方面的工作：对伸臂位于顶部的单层框架—筒体模型进行分析，提出了等效转动约束的概念和转动约束刚度的表达式。

Male cats normally do not need aftercare with the exception of the night after the anesthetic.

男猫通常不需要善后除了晚上的麻醉。