查询词典 heat flow

The study on flow and heat transfer in downcomer under loss of coolant accident is important to the safety of reactor pressure vessel.

前 言对失水事故下有安注流动时的反应堆压力容器内流动和传热的研究，一直是反应堆热工水力研究的热点之一。

The dried materials after the de-watering will go up with the heat-air flow. The step rings will stop and keep the big particles. Small particles will be discharged out of the drier from the ring center and will be restored by the whirl separator and dust remover. The not-fully-dried or big piece materials will be sent to the wall of the equipment by centrifugal force function and be smashed again after they fall down to the bottom.

脱水后的干物料随热气流上升，分级环将大颗粒截留，小颗粒从环中心排出干燥器外，由旋风分离器和除尘器回收，未干透或大块物料受离心力作用甩向器壁，重新落到底部被粉碎干燥。

Heat transfer characteristics and flow behaviors of elliptic cylinder s with different axis ratio k in crossflow are investigated experimentally.

对横掠不同长径比的椭圆管的换热和流动特性进行了研究。

On the other hand, with low process temperature and high Ar flow, the structure is amorphous due to significant energetic particle impingement and less diffusion energy by substrate heating. Phase transformation through process heating and post heat treatment were also discussed.

特别的是，利用高温镀膜制程(550~600aC)及低Ar气体流率(10~15 s.c.c.m)之制程控制，可使结构形成结晶状态，相反地，若使用低温镀膜制程(500~550aC)及高Ar气体流率(15~20 s.c.c.m)之参数控制，则使结构偏向非晶质化。

In this case about 2 h was required for the flow of heat from the outside to the inside to equilibrate.

在这个实验中，温度从试验品的外部逐渐传至内部到内外温度的平衡需要大概2个小时的时间。

According to the classical thermodynamics, driving force equipartition principle has been proposed, and used to derive the optimum parameter distribution of counter-flow heat exchangers.

以经典热力学理论为基础，导出了驱动力均分原理，并将这个原理用于逆流换热器的热力学优化，利用这个原理和变分原理求得了逆流换热器的最佳参数分布。

The heat transfer model, flow models and the physical equations, which are of small calculation error and less limit for the parameters used, are also considered as the subsidiary models.

本文还给出了一些辅助模型，主要包括考虑了适用于卧式蒸汽发生器的各种流型及自然循环等各种因素下的传热模型、流动模型以及精心挑选的参数覆盖范围大、误差小、计算方便的物性方程等等。

The heat transfer models, flow models and the physical equations, which are of small calculating error and less limit for the parameters used, are also considered as the subsidiary models.

辅助模型包括考虑了各种流型及强迫循环与自然循环等各种因素的传热模型、流动模型以及精心挑选的参数覆盖范围大，误差小，计算方便的物性方程等。

Heat transfer and flow characteristics of carbon dioxide in the finned tube evaporator were also studied.

同时，研究了二氧化碳在翅片管式蒸发器中的换热过程。

Flow rate of water in the tubes of evaporator almost has no effect on heat transfer.

此外，蒸发器水流量对换热几乎没有影响。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。