查询词典 heat capacity
- 与 heat capacity 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Animal ; Heat stress ; Physiological-biochemical index ; Production capacity
动物;热应激;理化指标;生产性能
-
The results show that the optimal value of CoCl2 concentration is 0.2 mol/L and the maximum adsorbed amount is 19.674 mg/g onto this adsorbent. The adsorption capacity of phosphine onto CoCl2-modified ACF decreases with the increase of temperatures. The maximum absorbed amounts are 19.674 mg/g at 298 K, 13.537 mg/g at 313 K and 11.087 mg/g at 328 K, respectively. It is found that the Freundlich equation is more suitable for the description of phosphine adsorption process than the Langmuir equation. The isosteric heat of adsorption decreases with the increase of the surface loading on CoCl2-modified ACF, which means that CoCl2-modified ACF adsorbent has an energetically heterogeneous surface. Meanwhile, adsorptive phosphine removal performance may be a dominant of physical adsorption when the heat of adsorption is 16-24 kJ/mol, the CoCl2-modified ACF adsorbent will be one of the candidates for tail gas purification of airtight calcium-carbide furnace and recycle of phosphine.
研究结果表明:浸渍液浓度最佳值为0.2 mol/L,此改性ACF对PH3的饱和吸附量为19.674 mg/g;PH3在CoCl2改性ACF上的吸附量随温度升高而迅速降低,在298,313和328 K时PH3的饱和吸附量分别为19.674,13.537和11.087 mg/g;Freundlich吸附等温方程较好地模拟了PH3在改性ACF上的等温吸附;PH3气体在改性ACF上的等量吸附热随吸附量的增大而减小,表明改性ACF吸附剂表面能量的不均匀性;吸附热在16~24 kJ/mol范围内,过程为物理吸附,有利于密闭电石炉尾气的净化。
-
The test results show that the crispest HAZ occurs in the process of welding of the 14MnNbq steel on the first heat circulation submerged welding overheat zone and the second heat circulation submerged welding overheat zone plus the not entirely re crystallized zone. The 14MnNbq steel has a tendency of being crisper due to overheat than the SM490C steel is. In order to ensure the toughness of the welding HAZ′s, the welding wire capacity should be properly controlled during welding.
由试验结果表明,14MnNbq钢焊接HAZ最脆区出现在一次热循环的埋弧焊过热区及二次热循环的埋弧焊过热区+不完全重结晶区;14MnNbq钢比SM490C钢有更强的过热脆化倾向,为确保焊接热影响区韧性,焊接时应适当控制焊接线能量。
-
The copolymer derived from the copolymerization in high capacity kettle were testified that copolymerization between AN and MMA occurred. The microcapsules in the films are distributed in the copolymer film matrix. The heat-absorbing temperatures and heat-evolving temperatures of the films are almost the same as that of the MOCT, respectively. In addition, the enthalpy efficiency of MOCT, the melting enthalpy and the crystallizing enthalpy rises with the contents of MOCT increasing.The decomposition temperature of copolymers in the films containing various contents of MOCT decreases with the contents of MOCT increasing.
采用30升聚合釜合成了丙烯腈—甲基丙烯酸甲酯共聚物,证实了丙烯腈和甲基丙烯酸甲酯发生了共聚反应;正十八烷微胶囊分散和镶嵌到了共聚物膜基体中;正十八烷微胶囊含量不同的共聚物膜的吸热温度放热温度与纯正十八烷微胶囊的吸放热温度基本相同;随着正十八烷微胶囊含量的增加,共聚物膜的热焓和热效率逐渐增加;共聚物膜中的共聚物的热稳定性温度随着正十八烷微胶囊含量的增加逐渐减小,共聚物膜的结晶度则有所增大。
-
With the heat-treating temperature rise and time increase, the damping capacity of Fe-Al reaches peaks at 900℃or 1000℃for two hours followed by air cooling and decreases with further increasing of heat-treating temperature and time.
固溶处理后的在350℃时效处理过程中,随着时效时间的增加,合金的晶体并没有发生改变,合金的阻尼性能也没有明显的变化。
-
Our annual production capacity amounts to 6 million pieces.Now we have a 60KA high-frequency heat treatment machine,6 automatic spring winders ,3 spring testers(among them one is up to 10 tons of force)as well as computer-controlled spring grinder,heat treatment facility. Moreover we have punch machine,milling machine,planer machine.
现拥有先进技术设备高频冶60KA,自动捲簧机6台,弹簧测试机3台(其中一台拉力测试机为10T),电脑数控磨簧机,网带式自动热处理,另有冲床、铣床、刨床等等。
-
This article mainly is analyzed the empirical datum of the Heat Transfer in the High Gravity Rotary Device of Countercurrent Flow, and discussed the heat transfer influence, example for intake and outtake temperature of cold and thermal fluid, current capacity, rotational speed and so on.
本文对逆流超重机的传热进行了研究,通过查阅大量关于超重力技术和直接接触传热的资料,综合分析出超重力场下的传热属于冷热流体直接接触的对流传热。流体在高速旋转中产生的强大离心力即超重力,使气液的流速及填料得比表面积大大的提高而不液泛。
-
The heat transmission capacity and heat consumption were calculated in some residential building including roofing, external wall, external door and window, stair well in Dongying. The investment of the saving dwelling was analyzed.
对寒冷地区居住建筑中屋面、外墙、外门窗、楼梯间等围护结构耗能部位的传热耗热进行了计算和分析,找出了居住建筑耗能症结并提出了解决办法。
-
The heat transmission capacity and heat consumption were calculated in some residential building including roofing, external wall, external door and window, stair well in Dongying.
对寒冷地区居住建筑中屋面、外墙、外门窗、楼梯间等围护结构耗能部位的传热耗热进行了计算和分析,找出了居住建筑耗能症结并提出了解决办法。
-
This paper expounds some problems that need to be solved on cleaner heat recovery coke oven in the process of report compiling of environmental impact assessment,including the discharge capacity per ton coke,material consumption indexes,the methods for the desulphurization of waste heat boilers and the comparison and selection of these methods.
阐述了清洁型热回收焦炉在环境影响报告书编制过程中需解决的问题,包括吨焦排污量和物耗指标以及余热锅炉脱硫方法及其比选。
- 推荐网络例句
-
Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).
呼气,收缩臀部肌肉;拱起身体,尽量抬起头来,右腿伸直朝向天花板(膝微屈,以避免肌肉紧张)。
-
The cost of moving grain food products was unchanged from May, but year over year are up 8%.
粮食产品的运输费用与5月份相比没有变化,但却比去年同期高8%。
-
However, to get a true quote, you will need to provide detailed personal and financial information.
然而,要让一个真正的引用,你需要提供详细的个人和财务信息。