查询词典 hardware interface

The circuit diagrams and the definition of hardware interface of each module are given. Thirdly, the bootload is designed according to the address mapping of the PCB and the start-up procedure of ARM processor.

接着，通过对ARM处理器启动流程的研究，并根据电路板的地址映射，详细阐述了系统引导程序的设计思路，并给出了程序流程图。

ARP, the full name Address Resolution Protocol, the Chinese called ARP, which work in the data link layer, data link layer and hardware interface links to the upper deck at the same time providing services.

ARP，全称Address Resolution Protocol，中文名为地址解析协议，它工作在数据链路层，在数据链路层和硬件接口联系，同时对上层提供服务。

The software and hardware interface of the synchronous block in the system are designed and implemented.

6介绍TI公司生产的TMS320VC33芯片，介绍GPS输出信息的格式，设计并实现系统同步模块的软硬件接口。

With the rapid development of computer ,micro-electronics and network, embedded system has been widely applied in the national defence, industry, medical treatment,etc.lt is very meaningful and important to develop a general platform, which is an integrated production of embedded control, signal processing and network communication, and provide a programmable hardware interface and a friendly interface, which can improve networking flexibility, system reliability and developability.

随着计算机技术、微电子技术和网络技术的飞速发展，嵌入式系统在国防、工业、医疗等诸多领域的应用越来越广泛。研制一个集嵌入式控制、信息处理和网络通信于一体，且提供可编程的硬件接口和友好的软件开发界面的通用平台，对于提高分布式测控系统的组网灵活性、系统可靠性和可开发性都具有重要的意义。

Then connect hardware interface to any free USB port of your PC or laptop.

然后连接的硬件接口的任何免费的USB端口的PC或笔记本电脑。

The hardware interface design and software development of the hardware-in-oop simulation system are discussed in this paper.

文中对该系统的硬件接口设计和软件开发进行了论述，并进行了部分系统测试评估。

First of all, this paper discusses the designing of minimal system about TMS320C5402 DSP device in detail. Secondly, this paper describes the communication method between TMS320C5402 and TLC320AD50C when the multichannel buffered serial port of C5402 is set up in serial port mode. Hardware configuration and software diagram are described. Thirdly, this paper introduces a designing of human-machine interface device, including hardware interface and accompanying software routine.

首先，详细介绍了基于TMS320C5402芯片的DSP实验系统的最小系统设计；其次，介绍了TMS320C5402的多通道缓冲串口与音频接口芯片(TLC320AD50C)在串口工作模式下实现串行通讯的设计，并给(来源：5cAB9fC论文网www.abclunwen.com)出相应的硬件配置、软件流程；再次，阐述了TMS320C5402的人机接口软硬件设计；最后，本文设计出了一些基本实验和有针对性的实验。

MATLAB applications, through redeployment of C++ language interface Mex, can be achievable in the MATLAB environment for the specific hardware interface signals.

而通过MATLAB应用程序接口Mex调用C++语言，可实现在MATLAB环境下对硬件端口信号的读写。

This paper elaborate on the operational principle, hardware interface circuit, and hardware organization of SCSI memory system.

本文对SCSI存储系统的工作原理、硬件接口电路、数据处理过程等进行了详细的介绍。

The experimental goal is to use SOPC-NIOSII EDA / SOPC system platform for real-time moving object detection system in this paper. After the inputs of image penetrated the CMOS Sensor to receive the data of the image makes the RGB form the transformation. The CPU processes operation of image detects. After the processed of image deliveres to VGA displayed output of real-time image. We use example programs of DE2 platfrom to achieve entire hardware on experiment board of SOPC-NIOSII EDA / SOPC System platform. On system of dectect image we divided into two parts : hardware and software. We use Verrilog of HDL to modify code in hardware. To use Custom IP of SOPC Builder produced IP of our need. We need a interface to connect in the COMS Sensor to FPGA and FPGA to VGA among. The code synthesize to create a programming file of *.S by Quartus II. Then, to use USB BLASTER of SOPC-NIOSII EDA/SOPC System platform programmed on FPGA. We use NIOS II IDE to assign DMA address in sofaware. We use SOPC-NIOSII EDA / SOPC System platform of Hum-Heng Technology co.

中文摘要本论文实验目标是在於利用SOPC-NIOSII EDA/SOPC系统平台来实现即时移动物体侦测的系统，影像输入透过CMOS Sensor接收影像的资料经过RGB格式的转换，再经过处理器处理影像侦测的运算，最后再将处里后的影像资料传送给VGA做即时的影像输出，我们使用DE2平台的测试范例程式转换在SOPC-NIOSII EDA/SOPC系统平台实验板来实现整个的硬体，我们将影像侦测系统分为硬体和软体二部份，硬体部分我们使用Verilog硬体描述语言修改撰写，利用SOPC Builder的自订IP产生我们所需的IP ，在COMS Sensor到FPGA跟FPGA到VGA中间我们需要一个interface来进行连接，经由Quartus II来合成产生*。sof的烧入档，然后利用SOPC-NIOSII EDA/SOPC系统平台专用的USB BLASTER来烧入到FPGA上，软体部分我们使用NIOSII IDE来定址我们DMA位址，主板我们采用华亨科技公司的SOPC-NIOSII EDA/SOPC系统平台。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。