查询词典 hardness

The copper-coated graphite/silver matrix composites have been made by the method of powder metallurgy. The properties of the composites, such as volume density, resistivity, hardness, bending strength and tribological behavior were tested, and comparison was made with silver-graphite composite of the same content graphite.

将镀铜石墨粉与银粉用粉末冶金法制备成镀铜石墨－银基复合材料，对其密度、电阻率、硬度、抗弯强度和摩擦磨损性能进行测试，并与相同石墨含量的银－石墨复合材料进行对比。

Special metal material and products, such as high-hardness steel plate, copper-coated steel wire, copper-coated aluminum wire, Bi-Sn alloy, Al-Ti alloy, W-Mo alloy, W-Cu alloy, Br-Cu alloy etc.

特殊金属材料，包括超硬耐磨钢板、铜包钢线材、铜包铝线材，及针对特殊用途的合金材料和制品，如铋锡合金、铝钛合金、钨钼合金、钨铜合金、铍铜等。

The water-scaling rate will increase when the water hardness or temperature is increased. The water-scaling rate will increase slightly when the concentration of SO〓 or NaC1 is increased. The presence of Mg〓 will change the crystallization process of calcium carbonate and produce aragonite scale. The presence of Zn〓 can prevent the formation of the crystal nucleus of calcium carbonate and then prevent the scale.

当水的硬度、温度增加时，水的结垢速率增加；SO〓和NaCl含量增加，能使水的结垢速率略有增加；Mg〓能改变碳酸钙的结晶过程并产生文石状的水垢；Zn〓的参与能明显阻碍碳酸钙微晶核的生成，从而达到阻垢的目的。

The results show that the effects on surface roughness are feed speed, depth of cutting , tool rake angle and parts hardness in turn.

结果表明：工件进给速度对表面粗糙度的影响最大，切削深度和刀具前角次之，工件硬度影响最小。

The effect of rake angle and cutting velocity on the shear strain imposed in the chips, microstructure and hardness of chips are highlighted in a variety of metals and alloys.

本文对比了不同的金属和合金在各种刀具前角和切削速度条件下，切屑上产生的剪应变、切屑的微结构及其硬度的变化规律。

While the material machined hardness is lower than HRC50, the changing rule of cutting force and cutting temperature was accordant with the common cutting theory.

当工件材料硬度低于HRC50，切削力和切削温度的变化规律符合普通的金属切削理论，硬度超过HRC50则切削力和切削温度的变化规律大不相同。

The effect of hydrocarbon chain of co-surfactant,chlorpyrifos solution content,chlorpyrifos content in oil,temperature,and water hardness were investigated by surfactant/cosurfactent/oil/water pseudo-ternary phase diagram to evaluate the factor effect in forming chlorpyrifos microemulsion.

为考察各因素对毒死蜱微乳液形成规律的影响，系统研究了助表面活性剂直链醇碳链长度、毒死蜱溶液含量、油相中毒死蜱的含量、温度及水质对表面活性剂/直链醇/毒死蜱溶液/水体系拟三元相图的影响规律。

An instrument that measures the hardness of materials by penetrating them with a diamond-pointed stylus.

通过菱形触针穿透物体以测量物质硬度的仪器。

Microstructure observation, micro-hardness testing, scanning electron microscope observation, energy dispersive spectroscope and X-ray diffraction analysis were employed to investigate the structure and performance of the joints.After SSNCed for 5min by means of HESP, surface nanostructured layer about 70μm and 50μm thickness were obtained on the stainless steel and titanium alloy ends respectively.

文中对高能喷丸处理后的不锈钢和钛合金的纳米组织进行了表征；试验研究了不锈钢和钛合金表面层纳米组织的热稳定性；采用恒温恒压、脉冲加压对表面自纳米化0Cr18Ni9Ti不锈钢与TA17近α钛合金进行扩散连接；借助拉伸实验机、金相观察、显微硬度测试、扫描电镜观察、能谱分析、X-射线衍射等分析手段研究了表面自纳米化钛合金与不锈钢扩散连接接头的组织结构和性能。

The use of diesel powered machinery in the water cycle by using a specially designed forming a bit-wide hole, a hole diameter of 120 MM, the largest drilling Depth of up to 60 meters, drilling speed (if the soil is pure, then one day drill 25 meters above the middle aquifer hardness of rock drilling 8 ~ 10 M)!

该机械采用柴油机做动力，在水循环下利用特殊设计的全孔钻头一次成型，成孔直径为120MM，最大钻井深度可达60米，钻井速度快(如果是纯土层，则一天可以钻25米以上，中等硬度含水岩石可钻8~10M)！

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。