查询词典 groove

Roughly the first 8 minutes of Part II A is a vamp over a D major groove with a repeated bass vamp in the left hand, and in Part II B, Jarrett improvises over an F# minor vamp for approximately the first 6 minutes.

在 Part II A 的前8分钟，他又用左手在D大调的范畴内弹奏出连续的低音伴奏，而在Part II B的最初六分钟，音色又换到了F#调上，持续了6分钟的即兴伴奏。

Relatively, the intercalation of Λ-〓 into minor groove is more preferable than other intercalating styles.

因此，这些错配碱基对的空间结构和静电势分布也必然影响识别结果。

Undercut is a small groove that can be lathed in advance at the end of the component .

退刀槽是指在螺纹终止处预先车出一个小槽。

To solve the problem,we redesigned pulley to keep the wheel of pulley always aplomb,and we also lathed the groove deeper to ensure the wire never come out.

经过工程师现场检查，重新设计了滑轮机构，可以始终保证钢丝绳与滑轮呈垂直的角度，另外加深了滑轮的U型槽，保证钢丝绳始终在槽中运行。

Combining with rolling bearing design engineering practices, a new method for deve loping three-two dimensional integrated miniature deep groove ball bearing design software is proposed in this dissertation.

本文结合滚动轴承设计的工程实践提出了一种新的微型深沟球轴承三维和二维设计软件开发方法。

In the beginning, where the groove meanders is totally random, but once established, the course of the following canyons are fixed.

最初，这些细小的沟槽的走向是完全随机的，但是一旦形成，随后形成的峡谷的走向便固定了。

In the beginning, where the groove meanders is totally random, but once established, the course of the following canyons are fixed.

初期，这些细小沟槽的走向是完全随机的，但是一旦形成，随后形成的峡谷的走向便固定了。

In the beginning, where the groove meanders is totally random, but once established, the course of the following canyons are fixed.

最初，这些细小的沟槽的方向是完全随机的，但是一旦形成，随后形成的峡谷的方向便固定了。

The C-terminal tail of SecA occludes the groove and inhibits signal-peptide binding, but autoinhibition is relieved by the SecB chaperone.

SecA的C端尾巴封闭了沟，抑制信号肽的结合，但是自动泛素化作用被SecB伴侣分子阻止。

The disk shot down the groove, wobbled a while, ceased and ogled them: six.

163圆盘顺着槽溜下去。晃了一阵才停住，朝他们飞上一眼：六。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。