查询词典 green surface

Inhibitors including sodium dodecyl sulfate, boric acid, sulfur, and potassium fluoroborate (KBF4) are added to compare the surface quality of AZ91 casting Experimental results show that adding sulfur in green sand obtained AZ91sand castings with satisfied surface quality and adding KBF4 in green sand produced sand castings with best mechanical properties.

实验结果显示添加硫磺，可得到较佳模砂性质且有效控制产生较好的金属表面品质，添加氟硼酸钾有较佳机械性质。

Leaves glossy deep green adaxially, narrowly linear-lanceolate, straight or slightly falcate, 0.8-6.5(-7) cm × 1.5-5 mm, midvein green abaxially, 0.3-1.2 mm wide, flat with median longitudinal keel throughout, stomatal bands present on both surfaces, bands on adaxial surface 0.5-1.5 mm wide, of 7-28 rows of stomatal, white powdery or not, bands on abaxial surface 1.2-2.8 mm apart, 0.3-0.8(-1) mm from leaf margin, not or rarely white powdery, base decurrent, margin denticulate, sometimes indistinctly so, especially on old trees, with 18-55(-90) teeth per side, apex usually symmetric and spinescent, spine 0.3-2 mm. Pollen cone fascicles terminal, 1-3(-5) together, broadly obovoid, each of 8-20 cones, occasionally a few also around base of seed cone; peduncle 2-4 mm; cones narrowly oblong-conical.

正面的叶有光泽的深绿色，披针形狭线形，直的或稍镰刀形， 0.8-6.5(-7)厘米×1.5-5毫米，中脉绿色背面，全部的0.3-1.2毫米宽，平的具中间的纵向的脊，气孔带宿存在两面，在正面0.5-1.5毫米宽上条纹状，7-28排stomatal的，与否白色粉状，相隔1.2-2.8毫米的条纹状的在背面，从叶缘的0.3-0.8(-1)毫米，白色敷粉的或很少的不，基部下延，边缘具小齿，有时不清楚如此，特别是在古树上，具18-55(-90)齿每边，先端通常对称和具刺，刺0.3个-2毫米雄球花束簇终端，花序梗2-4毫米；圆锥形孢子叶球狭长圆形。

Diamonds began growth when "Jiangnan continent" combined to Yangtze craton, the growth and residence average temperature T〓 was about 1200℃; Diamonds were mutil-stages growth and interruption caused by temperature and pressure varied during Yangtze craton activities; Diamonds were etched when the magma did not erupt on the surface and form failed magma in mantle; during the later growth term T〓＜1050℃, the type ⅠaA diamonds formed unclear and growth; Before the host magma erupted T〓＜0.5Ma, T〓A＜850℃, the type Ⅰb diamond formed unclear and growth; Few diamonds were brittle deformation during growth term, some were plastic deformation after growth; when the host magma erupted on the surface and weathered to alluvial deposit, diamonds surfaces formed green spots caused by irradiation, then most of green spots became to brown spots during a mid-temperature metamorphism; modern river reform it to alluvial deposit in the minute valley again.

在扬子地台&江南古陆&克拉通化时，金刚石开始生长，其生长与保存的平均温度T〓在1200℃左右；期间由于地台的活动，生长的温度压力条件发生了多次变化，使金刚石出现多次生长、停顿；夭折的母岩上侵活动使金刚石受到熔蚀作用；在金刚石形成的晚期，T〓值下降到1050℃以下，出现了另一次金刚石的生长期，在临近金刚石母岩上侵时T〓＜0.5Ma，温度进一步降到850℃以下，使Ⅰb型金刚石得以保存；在金刚石形成期间还有过碎性变形发生；金刚石形成后部分样品经过了塑性变形；金刚石在上侵过程中，遭受了强烈的熔蚀；在母岩露出地表，形成沉积砂矿时，受到了放射性物质的辐照，先形成表层的绿色斑点、壳层，后经过中低温的热变质作用，大部分绿色转化为褐色；现代河流作用对沉积砂矿进一步改造，形成现在的细谷型砂矿。

This paper puts forward the triangle element method for calculating gravity anomaly of three-dimensional sphere-coronal model by using the divergence theorem. In this study, the volume integration was changed into surface integral, a series of triangles were used to fit the surface, and then the Green's formula was adopted to change surface integral into line integral. At the same time, a reasonable calculation program was given.

提出利用高斯公式将体积分变成包围该积分域的全表面积，应用一系列三角形拟合计算表面，然后通过格林公式把对每个三角形的面积分变成对三角形每边的线积分之和的三角元法来计算三度体球冠模型重力异常，同时给出了合理的计算方案。

The numerical results of stationary and transient Green'sfunction for high-velocity surface-head wave on some selected crystals are comparedThrough the above analyse,it is indicate that the first arrival wave mode is thelongitudinal-wave head-wave,and its propagate velocity is equal to the groupvelocity of the longitudinal bulk wave alone the surface.Furthermore,this modedoes not have the Δv/v effect,i.e.,its velocity is the same no matter the surface isfree or metalized.

通过对表面激发的瞬态和稳态Green理论分析和数值计算，表明在压电晶体表面上实际上看到的最高速的最先到达的波动模式是纵波头波，它具有沿表面纵波的群速度，而且对压电晶体，它不具有Δv/v效应，即在自由表面和金属化表面其传播速度是一样的，而压电晶体表面波及伪表面波均存在Δv/v效应。

The polishing fluid is composed of Al2O3 micropowder with a grain diameter of 0.5-1.0 mum, coal oil, lard, plant oil and spindle oil, wherein Al2O3 micropowder is abradant, coal oil is solvent, the mixing liquid of lard, plant oil and spindle oil is as additive; and the polishing fluid is prepared by a mixing liquid which is composed of 2% lard, 2% abraser, 8% plant oil and spindle oil by volume and 88% coal oil. The polishing fluid can produce the H62 brass element with a uniform surface quality and a good surface roughness value up to 0.008 mum, has the characteristics of no eroding elements, effectively relieving mechanical score, good processing surface quality and can be used for decoration of the plastic metal material and surface polishing process before the material metallographic microscope analysis.

抛光液由粒径为0.5～1.0μm的Al 2 O 3 微粉、煤油、猪油、植物油和锭子油混合而成；其中Al 2 O 3 微粉为磨料，煤油作溶剂，猪油、植物油和锭子油的混合液作添加剂；抛光液按体积比由2％的猪油、2％的磨料、8％的植物油和锭子油的混合液、88％的煤油配制而成；该抛光液能够加工出表面质量均匀，表面粗糙度值达到0.008μm的H62黄铜工件，具有不腐蚀工件、有效缓解机械刻划作用、加工表面质量好的特点，可以用于塑性金属材料的外观装饰性加工，以及材料金相分析前的表面抛光加工。

Land surface temperature is an important parameter of energy balance of land surface and plays an important role in the interaction between land surface and atmosphere, and has important significance for energy balance on land surface, widely applied in many fields especially aerography, geology,hydrology,ecology and so on.

地表温度是地表能量平衡中的一个重要参数，它在地表与大气相互作用过程中起着重要的作用，对地表能量平衡的研究有着重要的意义，特别在气象、地质、水文、生态等众多领域有着广泛的应用需要。

Two-phase-learning is adopted. The strongpoint is that intuitionistic knowledge can be used to control the segmentation by using input-weight and distant-weight. Examples prove that segmentation using SOFM network is right and efficient. Surface fitting is an absolutely necessarily process in REGM. Surface fitting includes algebraic and parametric surface fitting. Algebraic surface fitting has not extra requirement for data distribute format and boundary shape.

第三种方法把人工智能用于反向工程的数据分区，因为数据分区的实质是相似特征的聚类，而神经网络可以实现自组织特征映射，在本论文中第一次把自组织特征映射神经网络用于多视图点云的数据分区，通过神经网络对数据点的坐标、法向量等几何特征进行聚类，并且运用了快速稳定的训练方法——两阶段训练算法，最重要的是，通过距离权值和输入权值可以把用户观察所得的直观知识加入聚类过程。

Based on the relations of the diffraction field and the surface wave, which conclude diffraction factor and interference factor, some relations were conformed such as: the diffraction fringes spatial distribution versus surface wavelength, the fringes half angular width versus the numbers of surface wave covered by laser spots and incidence angle, diffraction intensity versus surface wave amplitude.

通过对衍射因子和干涉因子的分析，得到衍射条纹空间分布与表面波波长的关系、条纹的半角宽度与入射激光光斑覆盖表面波的个数和入射方向的关系、衍射光强度与表面波振幅的关系，并解释了条纹缺级现象。

Contact angle between test solvent and filler or polymer matrix by the surface analysis.The surface tension, polar force parameter of the surface tension, apolar forceparameter of the surface tension and polar fraction had been calculated.

通过表面分析的方法，测出参比液在基体与填料表面的接触角e，计算出其表面张力Ys、表面张力的极性分量丫气、非极性分量Y as。

"Yes, now you can give yourself airs," she said, you have got what you wanted.

"对了，您现在高兴了，"她说道，这是您所期待的。

Then the LORD said to me: Rebel Israel is inwardly more just than traitorous Judah.

上主于是对我说：＂失节的以色列比失信的犹大，更显得正义。