查询词典 girder

The result shows combination using of lead rubber bearing and seismic restrainers can not only eliminate the usual defects of curved PC box girder bridge,but can also avoid the negative effect that caused by seismic restrainers,so it is deserved to make popularized.

结果表明：将铅销橡胶支座与常用限位辅助设计结合应用，既可以减轻常见病害，同时避免了限位装置带来的不利影响，值得推广应用。

Then, the construction techniques of R.C girder transfer floor in high-rise buildings are systematically investigated, three important item about construction of transfer floor: the form board and the carriage system, the joining and colligation of reinforcing steel bars, the casting of large volume concrete are partially analyzed and studied, otherwise, the design principle of the supporting system, the main point on connection of the reinforcing bar and the crack control measures of mass concrete are proposed.

然后，系统的研究了高层建筑钢筋混凝土梁式转换层的施工技术，重点对梁式转换层施工的三大分项：模板和支撑体系、钢筋的连接和绑扎、大体积混凝土的浇筑进行了分析和研究，并提出了支撑体系的设计原则，钢筋的连接要点和大体积混凝土裂缝的控制措施。

But the steel box girder is typical space thin-walled bars, because of bending-torsion coupling and steel curved box bridge distribution of stress is relatively more complicated even under dead load, so it is necessary to distribute emulation analysis to the real stress of curved box bridge.

但是钢箱梁是典型的空间薄壁杆件，由于弯一扭耦合作用，曲线钢箱梁即使在恒载作用下其应力的分布也比较复杂，因此有必要对曲线钢箱梁实际的应力分布进行仿真分析。

The methods of plane arrangement and checking of bowl-button steel scaffold were demonstrated in detail based on the engineering construction of cast-in-place Continuous beam in Houyan Cross-bridge of Shenda Highway. In addition, the methods of communicating the length of U-tray and adjusting the gradient have been given. It is pointed out that original pod can adjust the greater longitudinal or tranverse grade in the box-girder construction and welding-steel-bar can reduce partial compression.

通过后盐立交桥连续箱梁施工这一工程实例，详细论述了碗扣式钢管脚支架的平面布置方法及受力验算方法，提出了碗扣式钢管脚支架的U托旋出长度的计算方法及纵横坡的调整方法，并指出采用找零立杆的方法可以解决较大纵横坡度箱梁的施工问题；采用贴焊钢筋的方法可以解决U托偏心受压的间题。

The project used in conjunction with three holes of a prestressed continuous box girder design, layout for cross-bridge 30m +30 m +30 m, two-way four-lane bridge to meet current conditions, after the completion of the construction of the bridge under the bridge to meet the 8-lane two-way traffic conditions.

本工程采用三孔一联预应力连续箱梁设计，桥跨布置为30m+30m+30m，桥上满足双向四车道通行条件，建设完成后满足桥上桥下双向8车道的通行条件。

In the paper,the equations of motion for the vehicle_bridge_MTMD system are presented and the effectiveness of suppressing the transverse vibration of the deck steel plate girder bridge with multiple tuned mass dampers is investigated by the field test and simulated calculation.

本文建立了车-桥-MTMD系统振动方程，对利用多重调频质量阻尼器抑制铁路上承钢板梁桥横向振动的效果进行了模拟计算和现场试验。

With the theory of energy random analysis of train derailment, the security of moving train on up line and down line of Laoluanhe bridges is analyzed contrastively, and the influence on improving resisting derailment ability of bridges by widening the distance between two main beams of the deck steel plate girder bridge is studied.

进一步运用列车脱轨能量随机分析理论，对比分析了老滦河桥上、下行线上的列车走行安全性，分析了增大钢板梁主梁中心距对提高桥梁抗脱轨能力的影响。

Based on qualitative analysis and comparison of several options for suppressing transverse vibration on deck type steel plate girder of railway bridge,conclusions are made as follows:with static reinforcing,the vibration amplitude can be suppressed to some extent,but quasi-resonance of the bridge can not be avoided,moreover,the construction is inconvenient and costly.

通过对目前抑制铁路上承式钢板梁桥横向振动的几种方案进行定性的分析和比较，认为：静力加固方案可以使桥梁振幅有所减小，但不能避免准共振现象的发生，而且工程造价较高，施工也不方便；两桥连接方案减振效果明显(减振率近50%)，比较经济也比较方便，但同样不能避免准共振现象的发生；动力减振方案可以有效的抑制桥梁的准共振现象(现场试验中减振率达51.83%)，而且工程造价较低，施工简单、方便。

In this paper, the vehicle model on a scale of 1/4 and the half-sine curve are used to simulate the longitudinal curve of the plate girder bridge deck with creeping camber and the mathematical relations between the vehicle vertical vibration response and creeping camber, span length and vehicle traveling speed of the bridge are derived.

采用1/4汽车模型和半正弦曲线模拟板梁徐变上拱桥面线形，推导车辆竖向振动响应与板梁徐变上拱度、桥梁跨径、行车速度之间的数学关系。

In the case of in-plate loads, such as those induced in the deck by longitudinal bending of the hull girder, the beams serve to maintain the deck plating in its designed shape.

在板材装载情况下，例如在甲板上那些由纵向弯曲船体纵桁所诱导的，梁架就用来维持甲板板设计的形状。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。