查询词典 gelled

MASA with an oxidation degree of 20%, 40% or 60% gelled gelatin within 5 min at 37℃.

氧化度分别为20%、40%、60%的MASA，37℃下可使明胶在5min内生成凝胶。

The macroscopic rheological parameters and microstructure parameters were closely related, it is helpful to explain the essence of multiple rheological properties through the analysis of which the wax evolution process and microstructure of the crude oil which is waxy and high viscosity; the yield time of gelled waxy crude oil monotone increases along with the decreasing of rate of shear (the time of stress effect prolonged), there was power function relationship between them, it can be expressed with ; when adding diesel oil to Sudan crude oil, dilute proportion bigger the eccentricity degree of paraffin particles were bigger too, that was to say the symmetry of wax crystal was better, the wax crystal form fabric more hardly when the intermolecular interaction was smaller; in the light of macroscopica, the fall extent of the abnormity temperature, solidifying point and viscosity could be larger along with the accretion of dilute proportion, as a result, it's rheological properties could be improved.

SD原油析蜡点为94℃，析蜡高峰为50～30℃，异常点为40℃；其蜡晶颗粒细小、对称性差，所以具有较大的比表面能，容易形成联生、联锁结构；损耗角曲线与储能模量曲线或损耗模量曲线的交点所对应的温度与原油凝点或倾点温度非常接近，大约在39℃左右；也就是说，含蜡原油粘弹特性曲线的交点可以表征其流动性；原油宏观流变参数与微观结构参数密切相关，原油析蜡过程及蜡晶微观结构分析有助于诠释易凝高粘原油多重流变特性的本质；胶凝含蜡原油的屈服时间随剪切速率的降低而单调增加，二者显然存在幂函数关系，可用关系式描述；当SD原油加柴油稀释处理时，稀释比越高，蜡晶颗粒的偏心度也越大，亦即蜡晶对称性越好，分子间作用力越小，蜡晶颗粒越不易形成结构，宏观表现为异常点、凝点及表观粘度等流变参数下降的幅度越大，流动性越好。

As expected, 2 was not gelled but precipitated under such conditions that brought about the gelation of 1 because the molecular stacking between the HPB units was interfered with due to the lack of planarity.

正如预期的那样，二是不发胶但是沉淀条件下所带来的 1由于凝胶分子量HPB之间的叠加单位是干扰由于缺乏planarity。

Compared with G1 synthesized from 1,2,4,5-benzene tetracarboxylic acid and 4hydroxy pyridine at molar ratio of 1:2,G2 gelled water at higher minimum gelator concentration and gave the gel with lower gel-to-sol dissociation temperature at the same concentration.

相对于在摩尔比1：2条件下，由均苯四甲酸和对羟基吡啶合成的凝胶因子G1，在相同浓度下，G2在更高的最低凝胶因子浓度使水凝胶，并且得到的凝胶具有更低的凝胶-溶胶破坏温度。

For maximum effectiveness, post curing at 90-100℃ should be performed 3-6 hours as soon as possible after the composite has gelled and its exotherm has subsided.

推荐的后固化条件是90~100℃，3~6小时--对于厚制品和形状比较复杂的制品，后固化时间需要更长。

Because I don't know, I felt like that gelled.

因为，我也说不清，我的脑子已经是一团浆糊了。

Because I don't know, I felt like that gelled.

因为 我感觉那很融合

This team however, has gelled well, and is ready to win a championship.

不过，这支球队很团结，够默契，他们已经做好准备了。

This team however, has gelled well, and is ready to win a championship.

不过，这支球队很团结，够默契，他们已经最好准备了。

Once gelled, it can withstand temperatures of up to 80 °C.

一旦胶体，它能够经受温度高达80 ℃。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。