查询词典 furnace

Bumer of this type is favorable for primary air-coal flow ignition and flame stability, as well as low Nox emissions. Flue gas re-circulation is employed to prevent furnace slagging and opposed-fired burner arrangement is capable of reducing residual swirl of furnace exit flue gas.

该炉燃烧器有利于煤粉气流的着火和火焰稳定；低Nox燃烧，有利于环保；与烟气再循环配合有利于防止炉膛结焦；前后墙布置切圆燃烧方式减少了炉膛出口气流的残余旋转，使水平烟道烟气流速分布更趋均匀。

This paper presents analysis and comparison of direct recovery rate and other technical parameters in crude tin reduction smelting between reverberatory furnace and Ausmelt furnace.

通过对云南锡业股份有限公司冶炼分公司反射炉与澳斯麦特炉粗锡还原熔炼直接回收率等技术指标分析和比较，对两种熔炼技术进行了评价。

The furnace makes rail heating wire as its heating component, and the structure is open type. Make there is no flammability and corrosion gas, electric dust or collision around the furnace when the heating wire is rubefaction. Do not prolong or circle the heating wire when repair it.

电子调温电炉采用铁路电热丝作为发热元件，结构形式为开启式，炉盘内电热丝当发红状态，在使用时其周围环境空气中应无易燃性，腐蚀性气体或导电尘埃存在，不宜剧烈震动，修理电热丝时，也不宜拉长或复绕。

The shaped and unshaped refractories manufactured by our Co.,such as bricks of clay,high AL,silicon,AL-C,carbon corundum,cordierite,corundum,sillimanite,andalusite,etc.,which are used in blast furnace,hot stove,mixer furnace,melton iron ladle and torpedo car,have gained customers'good commendation on its steady quality and good results.

我公司可生产各种高炉、热风炉、混铁炉、铁水包、鱼雷罐用粘干质、高铝质、硅质、铝碳质、碳化硅、堇青石、刚玉质、硅线石砖、红柱石砖等制品和不定型耐火材料，以质量稳定，使用效果好而得到用户一致好评。

Based on the mass balances of blast furnace,typical slag basicity was calculated and analyzed in different zones of the blast furnace.

根据高炉的炉料平衡，对典型高炉不同区域内的炉渣碱度进行计算。

Smoulder Furnace is an important device to dispose cinder and extract mental which are difficult to be extracted from ore. In the past, the control of Smoulder Furnace is dependent of workers experience..

烟化炉是冶金行业用来处理炉渣及难选矿的重要冶炼设备，长期以来对烟化炉的控制，主要依赖于人工经验的方法，这种方法有很多缺点。

Lining of heating furnace, soaking pit and heat treatment furnace.

加热炉、均热炉、热处理炉的炉衬。

It used in heating furnace, tubular furnace, lining of industrial boiler and stud of soaking pit.

加热炉、管式炉、工业锅炉内衬、均热炉的立柱。

In order to require of the decarburized layer depth of T11A～T13A carbon tool steel wire rod up to the GB/T1298-1986 standard,the correspond heating processes for roughing soaking pit,pusher-type furnace for structural steel and rail and step-by-step furnace for wire were established based on the feature of T11A～T13A carbon tool and process technology in Pan Steel Co.

为使攀钢T11A～T13A碳素工具钢盘条的脱碳层深度满足GB/T12 98 1986标准的要求，根据T11A～T13A碳素工具钢的特点及攀钢的生产工艺，对初轧均热坑、轨梁推钢式加热炉及线材的步进式加热炉制定了相应的加热工艺，生产出的T11A～T13A碳素工具钢盘条的脱碳层全部满足GB/T12 98 1986标准的要求。

The development trend and importance of sponge iron production technique in iron and steel industry are introduced as well as the features of producing sponge iron with car bottom continuous furnace, its small-scale industrial test and trial use in electric furnace steel-making.

分析了海绵铁生产技术在钢铁行业中发展趋势及其重要性，介绍了台车底连续炉海绵铁生产技术的特点及小型工业试验和在电炉炼钢试用情况。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。