查询词典 furnace

Medium frequency induction furnace is used for heating in stead of traditional gas heating furnace.

0引言应用中频电源实现感应加热的最大特点是工件加热速度快，温度易于控制，投资省，经济效益显著，在机械和冶金行业的金属锻造、熔炼、焊接、透热和淬火等热加工、热处理场合应用广泛。

And 17. 6% respectively when increasing furnace arch height 10 times original height and adopting furnace arch stmcture of inequilateral depth and double fumace arch structure.

研究表明，当折焰角高度增加为原高度的10倍、采用左右不等深度折焰角和双折焰角三种结构时，炉膛出口残余旋转明显减小，末级再热器入口截面最大速度不均匀性系数M〓可分别减小30.7％、19.3％和17.6％。

The problems such as regenerative reheating furnace needing high coal gas pressure, regenerator jamming, great oxidation loss and furnace control inexactitude are solved by ameliorating technique and strengthening operation management.

针对蓄热式加热炉要求煤气压力大、蓄热室易堵塞、氧化烧损大、炉况控制不精等问题，通过技术改进与加强操作管理得到基本解决，提高了蓄热炉的性能，改善了使用效果。

Various pit furnace are manufactured by WDS energy saving furnace lining , never swap resistance wire interior angle upwarping brick, high temperature resistance wire layout law, and many other advanced technologies.

等各种井式炉型制造均采用WDS节能炉衬，永不掉电阻丝内角上翘搁丝砖，高均温布置电阻丝法等许多先进技术。

Major equipment has seven tons of hot air cupola 1, 3-ton cupola 2; 1 ton-frequency furnace 1; 10 tons lane 2, 5 tons lane 3; Q378C blast cleaning machine 1; S1120, S118, S111 type mixer and the resin sand Mixer 1; ZNVSR-vibration system to eliminate stress 1; drying kiln and the annealing furnace 1, and other wood-based and aircraft plus 16 sets of equipment, and the other physical and chemical room with a professional .

主要设备有7吨热风冲天炉一座，3吨冲天炉2座；1吨工频炉1座；10吨行车2台，5吨行车3台；Q378C抛丸清理机1台；S1120、S118、S111型混砂机和树脂砂混砂机各1台；ZNVSR-振动消除应力系统1台；烘干窑和退火炉各1台，其他木型和机加设备16台套，另设有专业理化室。

Most chemical occupational-disease hazards were low to the limit of GBZ2-2002 except lead smoke and carbon monoxide in front of the furnace. The noise of most workplaces was classified as 0 except those above Ⅰ at some workplaces like grinding, granule-making, etc. The hot working environment of the furnace was classified as Ⅵ, other hot working environments were classified asⅠ.

除炼铁厂炉前铅烟、一氧化碳个别点超标外，其他化学性职业病危害皆未超过接触限值；除个别岗位如破碎、制粒等噪声作业分级为Ⅰ级以上外，大部分作业点噪声作业分级为0级；炼铁厂炉前高温作业为Ⅵ级，其他热源岗位为Ⅰ级。

Which can get higher recovery ratio when the temperature of melting furnace was 833K,the temperature of liquation hearth was 703K,the temperature of evaporator furnace was 1373K and the temperature of condenser was 373K;With this method to dispose the hot-dip galvanizing dregs,when the recovery ratio was more than 70% that could get more profit

当熔化炉的温度为833K，熔析炉的温度为703K；蒸发炉的温度为1373K；冷凝器的温度为373K可以得到较高的回收率；发现采用该法处理热浸镀锌渣，当回收率在70%以上时有较大的利润空间

Furnace acid is made by reducing phosphate rock with loke in an electric furnace.

炉酸是在电炉中用焦炭还原磷矿制得的。

The GYG-1-240 energy conservation power frequency has the core smelting furnace, mainly uses in smelting the carbon steel, metals and so on alloy steel, high-manganese steel, ferroalloy, cast alloy iron, gray iron, copper, copper alloy smelts, because the furnace temperature is higher than 1600℃, and has six grade of temperature controls, suitably in 1250-1600℃ the different melting point metal's smelting, and may fall the files heat preservation to wait for the casting or the adjustment melt fluid ingredient, the electromagnetism magnetic field magnetic line of force automatic agitation causes the ingredient to be even, non-element loss by burning.

GYG-1-240节能型工频有芯熔炼炉，主要用于熔炼碳素钢，合金钢、高锰钢、铁合金、合金铸铁、灰铸铁、铜、铜合金等金属熔炼，由于炉温高于1600℃，并有六档温度调节，可适用于1250-1600℃不同熔点金属的熔炼，并可降档保温等候浇铸或调整熔液成份，电磁磁场磁力线自动搅拌使成份均匀，无元素烧损。

The GYG-1-240 energy conservation power frequency has the core smelting furnace, mainly uses in smelting the carbon steel, metals and so on alloy steel, high-manganese steel, ferroalloy, cast alloy iron, gray iron, copper, copper alloy smelts, because the furnace temperature is higher than 1600℃, andhas six grade of temperature controls, suitably in 1250-1600℃ the different melting point metal's smelting, and may fall the files heat preservation to wait for the casting or the adjustment melt fluid ingredient, the electromagnetism magnetic field magnetic line of force automatic agitation causes theingredient to be even, non-element loss by burning.

GYG-1-240节能型工频有芯熔炼炉，主要用于熔炼碳素钢，合金钢、高锰钢、铁合金、合金铸铁、灰铸铁、铜、铜合金等金属熔炼，由于炉温高于1600℃，并有六档温度调节，可适用于1250-1600℃不同熔点金属的熔炼，并可降档保温等候浇铸或调整熔液成份，电磁磁场磁力线自动搅拌使成份均匀，无元素烧损。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。