查询词典 functional block

The design of each functional block is presented in detail.

各个功能块都进行了详细的展示。

In the article has produced the system hardware functional block diagram, the software flow chart.

文中给出了系统的硬件原理框图、软件流程图。

In general, a communication system can be represented by the functional block diagram shown in Figure below.

通常，一个由信号源产生的通讯系统可以由以下这幅原理框图来说明。

In this paper research of functional block structure was based on the theory of rheology of the polymer melt and the basic requirement of extrusion die channel.

本论文对于功能块的研究，是以聚合物熔体的流变学理论，以及挤出模头流道的基本要求为基础。

Very few studies on functional block structure were reported, consequently, the structure design of functional blocks was selected as the research object in this paper.

目前很少有人对功能块进行研究，因此，本论文选择功能块的结构设计作为研究对象。

Various functional block structures of different factories home and abroad were analyzed and the structure characterizations of functional blocks were also summarized.

分析了国内外不同厂家功能块结构的异同点，总结出功能块结构的特点。

This article describes reuse-based functional block design flow through developing the header error control processing block set.

本文通过异步传递方式中信头差错控制模块组的设计，阐明基于设计再利用的功能模块的设计流程。

Through a study of the cases of transit signaling system improvement in the world, this paper introduces the development of CBTC-MB, which is compared with the traditional Fixed Block, the principle, the functional block diagram and the technical standard of CBTC-MB, holds that this technology will be further developed and applied in urban mass transit.

通过国际上城市轨道交通列车控制系统发行的案例，介绍了移动闭塞在国际上的发展概况。比较了基於通信的列车控制的移动闭塞列车控制方式和传统闭塞方式之间的不同。介绍了移动闭塞的工作原理、组成及相关的技术标准。指出移动闭塞和CBTC必将在城市轨道交通中得到发展和应用。

Twin-block functional appliance; malocclusion, Angle Class Ⅱ division 1; lateral cephalograph;mandibular growth

Twin-block功能矫治器错，安氏Ⅱ类1分类 X线头影测量下颌生长发育

The aim of this study was to develop a novel amphiphilic functional block poly(ε-caprolactone) bearing ketone groups MPEG-b-P(OPD-co-CL. 2-oxepane-1, 5-dione was copolymerized with ε-caprolatone in which methoxy poly (MPEG, Mn=5 000) and stannous octoate were used as initiator and catalyst, respectively. The syntheses were conducted by bulk and solution polymerization. 1H NMR results showed that peak position and splitting of the polymers synthesized through solution polymerization were consistent with theoretical data, demonstrating the products were designed block copolymers. While in the bulk polymerization, polymer peak position was changed due to their high reaction temperature, suggesting their structural variation.

将带有羰基官能团的4-羰基己内酯和ε-己内酯分别在甲氧基聚乙二醇(MPEG，Mn=5 000)为引发剂，异辛酸亚锡为催化剂溶液和本体体系中开环聚合，合成了两亲性侧基带有羰基官能团的聚己内酯嵌段共聚物MPEG-b-P(OPD-co-CL.1H NMR结果表明采用溶液聚合法合成的聚合物各峰的峰位置和分裂情况与理论一致，证明了产物是实验所设计的嵌段共聚物，而采用本体聚合法合成的聚合物由于温度的影响，聚合物各峰的峰位置发生了变化，说明其结构发生了变化；差示扫描量热法分析结果表明随着OPD单体含量的增加，聚合物的熔点，玻璃化转变温度和熔融焓增加；热失重测试结果表明OPD单体的引入增加了聚合物的热敏感性。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。