查询词典 from end to end

The left ventricular internal dimension at end diastole, interventricular septal thickness at end diastole and left ventricular posterior wall thickness at end diastole were measured in the parastemal long axis view by transthoracic two-dimensional echocardiography, and to calculate left ventricular ejection fraction with Teichholtz formula and left ventricular mass with modified Devereux formula, left ventricular mass index=LVM/body surface area. From the apical four chamber and two chamber view, the basical segment and middle segment of interventricular septal, left ventricular lateral wall, anterior wall and inferior wall were obtained by tissue Doppler imaging, Regional left ventricular relaxation asynchrony index was calculated.

应用二维超声心动图在胸骨旁左心室长轴观测量左心室舒张末期内径、室间隔和左心室后壁舒张末期厚度，采用Teichholtz公式计算左心室射血分数，采用Devereux校正公式计算左心室心肌质量，左心室心肌质量指数=左心室心肌质量/体表面积；在心尖四腔心和心尖两腔心切面，应用组织多普勒成像获取室间隔、左心室侧壁、前壁和下壁的基底段和中间段8个心肌节段沿左心室长轴运动的速度频谱，测算左心室局部心肌松弛不同步性指数(regional left ventricular relaxation asynchrony index， AI)；在心尖四腔心切面，应用彩色M型多普勒超声心动图测量左心室舒张早期血流传播速度。

An end cover which can be taken out by fingers sets on the inner end of the carriage of the outer cylinder, the end cover prevents eyewinker from passing through the gap between the outer cylinder and the drive transfer component to immerge into the outer cylinder.

在外筒的车厢内侧端部，可用手指取出地设有端盖，该端盖防止异物经过上述外筒与上述驱动力传递构件之间的间隙而浸入到外筒内。

In the teleology of history, the subject of faith changed from individual man to the human being. The object of highest good changes from the synthetic connection of virtue and happiness to the final end of history; the idea of freedom became the perfect stage of the world; the importance of immortality is lower than ever, and degenerated into "the faith of second rank"; the function of God lies in guaranteeing the possibility of final end of history.

在历史目的论中，道德信仰的主体从前两部批判中个体的人转变成了人类；作为信仰客体的至善变成了历史的最终目的，即自然与自由的综合统一，它不再属于一个超验的世界，而属于这个世界的一个完美阶段；相应地，自由概念也转变为这个完美阶段的基础；而不朽的地位不再重要，变成了"次一级的信仰"；上帝存在的意义也变为保证历史的最终目的的可能性。

This system mainly contains the front-end pulse interception and back-end software analysis. In the first part, we used a non-invasive infrared measurement method based on the dual channel simultaneous measurement technique. We measured the photo-plethysmograph from the subject's fingers and toes simultaneously, then used an analog circuit and central control unit to process the signals. Finally, the digital volume pulse data is processed by a personal computer. Because the characteristic points of digital volume pulse always occur in sharp variations, this paper proposes two algorithms to solve this problem. First, we find the pacemaker and percussion wave peak from transient slope variation, and then locate the dicrotic notch and dicrotic wave peak by using the wavelet transformation algorithm. When we analyze the data, we use the Visual Basic graphical user interface, which together with the Matlab is the core of the system.

本系统主要包含前端脉波撷取及后端软体分析两部分，其中前端脉波撷取部份是以非侵入式的红外线量测方式，双通道同步量测受测者手指与脚趾的光容积变化描记图，同时将此讯号经类比处理电路及中央控制单元输出成为数位容积波，再传送至个人电脑中；而在后端软体分析部份，因数位容积波之特徵点皆出现於波形中急剧变化的部份，故本论文以瞬间斜率变化量来定位脉波讯号中的起搏点及主波峰顶点，并利用小波转换演算法（wavelet transformation algorithm）来分析重搏切迹与重搏波顶点；程式撰写主要以Matlab为核心，结合Visual Basic的图形化使用者操作介面，增加系统与使用者间的亲和力。

The invention also relates to a nozzle body (31) comprising a nozzle outlet which is disposed on the combustion chamber side end thereof, a nozzle needle (33) which is arranged in an axially displaceable manner and/or which can is actuated in a longitudinal recess (32) of the nozzle body (31); a throttle disk (25) which is arranged between the nozzle body (31) and the control valve (20) and which is closed on the rear end (oriented away from the nozzle outlet) of the longitudinal recess (32). Said throttle disk forms an opening stop for the nozzle needle (33) which co-operates with the rear front surface (orientated away from the nozzle outlet) of the nozzle needle (33) and defines the opening stroke of the nozzle needle (33), and a control chamber (45) formed between the rear nozzle needle front surface and the throttle disk (25), said control chamber being hydraulically connected to a pressure connection (29) which is used to supply fuel.

还设置了：一个喷嘴体(31)，在该喷嘴体的燃烧室侧的端部上构成一个喷嘴出口；一个喷嘴针(33)，该喷嘴针在轴向上可运动或可操作地安置在该喷嘴体(31)的一个纵向开口(32)中；一个封闭该纵向开口(32)的后面的端部的、安置在喷嘴体(31)与控制阀(20)之间的节流盘(25)，该节流盘构成用于该喷嘴针(33)的一个打开止挡，在此与该喷嘴针(33)的后面的端面协同作用并由此限定该喷嘴针(33)的打开行程的边界；和一个在该后面的喷嘴针端面与该节流盘(25)之间构成的控制室(45)，该控制室与一个用于燃料输入的压力接口(29)处于液压连接中。

As for charging for Intelligent Power Storage Mobile Power Supply, insert 5P end of data wire into 5P end of Intelligent Power Storage Mobile Power Supply, then connect USB end of data wire to computer and charger with USB interface to electricize before keeping a large quantity of power please always remember to switch from ON gear to OFF gear after finishing electricizing in case that a charger with voltage of 5V-6V is adopted.

给智能储电宝移动电源存储电量，将数所线5P 头插入智能储电宝5P 母头，然后将数据线一端 USB 头接上电脑和带有 USB 的充电器进行充电（切记电压在5V-6V 的充电器，充电完成后将开关 ON 档移动到 OFF 档）锁住电量。

In protected conditions the time of flower bud differentiation of peach is from middle July to the end of September. The majority of flower bud primordia are formed from end of July to middle September.

结果表明：保护地桃花芽分化时间从7月中旬到9月下旬，7月末到9月中旬是早醒艳桃花芽集中分化期。

The imagoes keep active from the time when the tree began to burgeon the next year,particularly from the end of April to the end of June.

翌年于椒树花芽萌动时，越冬成虫陆续出蛰活动。成虫为害叶片，造成缺刻或孔洞，幼虫蛀食花序梗和复叶柄，使花序和复叶萎蔫下垂，继而黑枯。

In group A, the left musculocutaneous nerve was transected to make the model of biceps brachii denervation and anastomosed to its proximal end 6 weeks later; In group B, the musculocutaneous nerve was transected and the distal end was coapted to the purely motor medial pectoral nerve immediately and the musculocutaneous nerve was separated from the medial pectoral nerve, and reanastomosed to its proximal end 6 weeks later.

随机分为两组（ n =8）：肌皮神经延期修复组，单纯剪断左侧肌皮神经，造成肱二头肌失神经支配模型，6 周后行肌皮神经修复；神经移位寄养二期肌皮神经修复组，剪断左侧肌皮神经后即刻将胸内侧神经分支的近端移位寄养于肌皮神经的远端，6 周后结束寄养关系行二期神经修复术。

A magnetic source and condenser for protecting a pipe, ionizing any fluid flowing therein, and ionizing any dissolved and suspended solids in such fluid, comprising:a magnetic source including a magnet having a pair of opposed planar major faces and a planar minor face extending between said major faces and perpendicular to said major faces,said magnet being charged so that one of said major faces is a south pole and the other of said major faces is a north pole,a magnetic condenser a pair of pole pieces, each of said pole pieces having a pair of opposed planar major faces, one of which is an inner major face and the other of which is an outer major face, the area of said inner major faces being equal to that of the major faces of said magnet, the area of said outer major face being larger than each of said major faces of said magnet,said pole pieces being positioned on opposite sides of said magnet such that said pole pieces sandwich said magnet, said inner major face of each pole piece is contiguous with and completely covers an entire major face of said magnet, and said outer major face of each pole piece faces away from said magnet,each pole piece having an integral foot extending perpendicularly to said inner major face of each pole piece such that said pole pieces have two respective integral feet which extend toward each other and are substantially coplanar, each foot having a distal and a proximal surface with respect to said magnet, each foot having an end which is spaced from the end of the opposite foot,said distal surface of each foot having a predetermined concave curvature which will conformingly mate with an outside surface of a pipe having a predetermined convex curvature,said proximal surface of each foot being contiguous with said minor face of said magnet

我要求： 1。一台磁性来源和冷凝器为保护管子，电离任何流体流动在其中，和电离任何被溶化的和暂停的固体在这样的流体里，包括：一个磁性来源包括磁铁有一对被反对的平面主要面孔和一张平面较小面孔延伸在前述主要面孔和垂线之间对前述主要面孔，前述磁铁被充电以便前述主要面孔的当中一个是南极并且其他前述主要面孔是北极，一台磁性冷凝器每对杆片断，每个前述杆片断有一对被反对的平面主要面孔，其中之一比每个是是一张外面主要面孔的一张内在主要面孔和其他，前述内在主要面孔区域是相等的与那前述磁铁，前述外面主要面孔区域的主要面孔大的前述磁铁的前述主要面孔，前述杆片断被安置在前述磁铁的反面这样，前述杆片断三明治认为磁铁，各个杆片断的前述内在主要面孔是接触的与和完全地包括前述磁铁的一张整个主要面孔，和各个杆片断面孔的前述外面主要面孔从前述磁铁，各个杆片断有一只缺一不可的脚垂直地延伸对各个杆片断的前述内在主要面孔这样，前述杆片断有延伸往彼此和极大地coplanar 的二各自缺一不可的英尺，各只脚有末端和接近表面谈到前述磁铁，各只脚有被间隔从相反脚的末端的末端，各只脚前述末端表面有与管子一个外表面conformingly 将联接有被预先决定的凸面曲度的被预先决定的凹面曲度，各只脚前述接近表面是接触的与前述磁铁的前述较小面孔

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。