查询词典 fracture

Fracture behavior study showed that, reinforced of SiC or Si〓N〓 nanoparticles, or SiC whiskers is due to cracks deflection, or twist, or diverse, or stop during propagating, and bridging and pulling-out of whiskers, and accompanied by fracture of a few SiC nanoparticles and whiskers.

断裂机理研究表明：裂纹扩展过程中遇到纳米SiC晶粒、纳米Si〓N〓晶粒和SiC晶须时，将发生偏转、扭曲、分叉、终止及晶须的桥接、拔出，并有少量SiC晶粒、Si〓N〓晶粒和SiC晶须断裂。

The results shows that the flow characteristics of SiC-AlN granulated powder is obviously promoted after spray drying and a suitable particles grade match. With the increasing of pressure, the density of green body increases by the style of ladder at the pressure range of 4080 MPa, 80160 MPa and 160220 MPa, the green body is uniform and densification without hard pelleted particles above 160 MPa. The pressureless sintering SiC-AlN multiphase ceramic possesses superior sintering properties and mechanical properties. It is due to the rampart formation of AlN to SiC grain growth and the reaction of SiC and AlN to form 2H solid solution. It results in the grain fining, crack expansion producing bypass and deflection, fracture section producing tearing-open and pulling-out effects, which cooperatively improves the strength and fracture toughness of the multiphase ceramics.

结果表明：喷雾造粒后，复合粉体的流动特性显著提高，粒度级配合理；随着压强增加，坯体密度在40~80、80~160和160~220 MPa范围内呈现阶梯式增长，160 MPa以上成形后素坯均匀致密，无硬球颗粒存在；无压烧结SiC-AlN复相陶瓷具有优越的烧结性能和力学性能，这是由于AlN对SiC晶粒形成生长势垒，并反应生成2H型固溶体，从而细化晶粒，导致裂纹扩展产生了绕道与偏转效应，呈现晶粒撕裂与拨出现象，协同改善了复相陶瓷的强度及断裂韧性。

Sample 1 had no phenomenon of pulling-out and debonding of fibres under vertical compression load and the interface bonding intensity is strong between the fibres and the matrix. The material shows brittle fracture: if σ(subscript ⊥)=60.7MPa. However, sample 1 has the phenomenon of fibres debonding because of the shearing stress between the fibres and the matrix under parallel compression load. The material shows tough fracture:σ(subscript ∥)=52.6 MPa.

试样l在垂直纤维层方向压缩载荷作用下，没有出现纤维的拔出、脱粘等现象，界面结合较强，材料呈现脆性断裂：σ=60.7MPa；而在平行纤维层的压缩载荷作用下，纤维与基体存在剪切作用，存在纤维的脱粘，试样呈现韧性断裂：σ=52.6MPa。

The ore-control structure can be divided into two types which are transtension fracture and transpression fracture. The former controls quartz vein ore, and the latter controls altered rock ore.

控矿构造可分为两种类型，既压扭性和张扭性，前者控制着蚀变岩型矿体分布，后者则控制着含金石英脉型矿体分布。

The test result has been described and the causes of differential subsidence on the bottom of test pit have been analyzed from two aspects (deformation of loess collapse and slip and subside of wet soil mass along fracture). On this basis, the article summarized that Surface water and ground fracture in the activities is to promote mutual interaction.

通过对试验的几种不同沉降关系曲线和试坑沉降变形等值线图的描述，文章从可能引起试坑产生不均匀沉降变形的两个方面(黄土湿陷变形、浸湿土体沿裂缝滑移下陷)作了探讨，得出地表水与地裂缝的活动是相互促进相互影响的关系。

The test has been done to simulate the movement of ground fracture after surface water soaking in. The test result has been described and the causes of differential subsidence on the bottom of test pit have been analyzed from two aspects (deformation of loess collapse and slip and subside of wet soil mass along fracture).

通过对试验的几种不同沉降关系曲线和试坑沉降变形等值线图的描述，文章从可能引起试坑产生不均匀沉降变形的两个方面黄土湿(来源：ABC论4c文网www.abclunwen.com陷变形、浸湿土体沿裂缝滑移下陷作了探讨，得出地表水与地裂缝的活动是相互促进相互影响的关系。

OBJECTIVE: From the rheological point of view to quantitatively analyze the two fixators in clinical application of the treatment of spinal fracture-dislocation through simulation of spinal L1-2 fracture-dislocation and axial compression test after plate and intramedullary nail fixation.

目的：通过模拟脊柱L1~2骨折脱位，以钢板和髓内钉固定后对标本进行轴向压缩应力松弛实验，从流变学角度对临床治疗脊柱骨折脱位的2种固定器进行定量分析。

OBJECTIVE: From the rheological point of view to quantitatively analyze the two fixators in clinical application of the treatment of spinal fracture-dislocation through simulation of spinal L1-2 fracture-dislocation and axial compression test after plate and intramedullary nail fixation.

目的：通过模拟脊柱L(下标 1~2)骨折脱位，以钢板和髓内钉固定后对标本进行轴向压缩应力松弛实验，从流变学角度对临床治疗脊柱骨折脱位的2种固定器进行定量分析。

Through studying mechanism of drilling string failure in the action of interaction of cyclicstresses and corrosion, we find fracture source is accord with pitting corrosion inside surface ofdrilling string, crack from pitting corrosion lead to drilling string failure, the process of drillingstring failure is new drilling string → corrosion pit forming and crack initiation → corrosionfatigue crack propagation→piercement or fracture.

通过研究在钻柱交变应力和腐蚀的交互作用下的机理发现，腐蚀疲劳裂纹源与钻杆内壁蚀坑对应，蚀坑萌生裂纹造成钻柱失效，钻柱腐蚀疲劳破坏过程归结为：新钻杆—蚀坑形成及裂纹萌生—裂纹扩展—刺穿和断裂。

Shear wave responses to fracture media can serve as a tool to measure directly fracture strike and density.

中国石油化工股份有限公司江苏油田分公司物探技术研究院，南京 210046

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。