查询词典 format a disk

Hard work in time to avoid the shock of it, because the distance between head and disk very close to, if clustering was head of the shock will lead to knock disk may be scratched disk heads, but also may lead to the total head count of the bad, the entire hard disk can not be used.

在硬盘工作的时候要尽量避免它的震荡，因为，磁头与磁片的距离非常近，如果遭到聚类的震荡会导致磁头敲打磁片，有可能磁头会划伤磁片，也可能会导致磁头的彻底算坏，使整个硬盘无法使用。

In my opinion, the simplest approach is: Normally, the hard drive to back up a partition table (not, to find a model with the same hard disk partition table can be), the event was to get rid of a hard disk, floppy disk with both fixed, it can be hard in the bios will set none, to start after the backup to restore the partition table back to the hard disk and then change the settings back from the new start, fdisk it.

我认为，最简单的办法是：在平时，将硬盘的分区表备份一个（没有的话，找一个与之相同型号的硬盘的分区表也可以），万一硬盘被干掉了，用软盘都起不动的话，可以在bios里将硬盘设为none，启动后，将分区表的备份恢复回去，然后将硬盘的设置改回来，从新启动，fdisk就可以了。

Mobile hard disk can not move at will, mobile hard disk and lead plane jumper are general at least a few centimeters, a lot of people copy data at the same time actually, take at the same time in the hand, this is the error with the commonnest you, experience is fluky, your so harum-scarum behavior accumulative total has the possibility 10 times, 30, did not give a business on the spot, but hard disk of day of very possible abrupt some was hanged ahead of schedule, life of normal circumstance hard disk should be more than 35 years, be like what write above advertisement to have average time to failure, allegedly tens of thousands of hour, it is not quite clear that I am written down, when this plaything high speed runs, anyhow must place the platform that stabilizes in to go up.

移动硬盘并不能随意移动，移动硬盘和主机连接线一般至少几十厘米，很多人竟然一边拷贝数据，一边拿在手里，这是诸位最常见的错误，经验并不可靠，可能你这样鲁莽的行为累计有十次，三十次，从来都没当场出事情，但很有可能忽然某一天硬盘就提前挂了，正常情况硬盘寿命应该不止三五年，好象广告上面写的有平均无故障时间，据说几万个小时，我记不大清楚，总之这玩意儿高速运转的时候必须放置在一个稳定的平台上。

Command: d Partition number (1-11): 6 Command: n Command action l logical (5 or over) p primary partition (1-4) l First cylinder (5001-20886, default 5001): Using default value 5001 Last cylinder or +size or +sizeM or +sizeK (5001-7500, default 7500): Using default value 7500 Command: p Disk /dev/sda: 171.7 GB, 171798691840 bytes 255 heads, 63 sectors/track, 20886 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/sda1 * 1 1250 10040593+ 7 HPFS/NTFS /dev/sda2 1251 20886 157726170 5 Extended /dev/sda5 1251 2500 10040593+ 7 HPFS/NTFS /dev/sda6 7501 10000 20081218+ b W95 FAT32 /dev/sda7 10001 20886 87441763+ 7 HPFS/NTFS /dev/sda8 2501 3000 4016218+ 83 Linux /dev/sda9 3001 3125 1004031 82 Linux swap / Solaris /dev/sda10 3126 5000 15060906 83 Linux /dev/sda11 5001 7500 20081218+ 83 Linux Partition table entries are not in disk order Command: t Partition number (1-11): 11 Hex code: 7 Changed system type of partition 11 to 7 Command: p Disk /dev/sda: 171.7 GB, 171798691840 bytes 255 heads, 63 sectors/track, 20886 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/sda1 * 1 1250 10040593+ 7 HPFS/NTFS /dev/sda2 1251 20886 157726170 5 Extended /dev/sda5 1251 2500 10040593+ 7 HPFS/NTFS /dev/sda6 7501 10000 20081218+ c W95 FAT32 /dev/sda7 10001 20886 87441763+ 7 HPFS/NTFS /dev/sda8 2501 3000 4016218+ 83 Linux /dev/sda9 3001 3125 1004031 82 Linux swap / Solaris /dev/sda10 3126 5000 15060906 83 Linux /dev/sda11 5001 7500 20081218+ 7 HPFS/NTFS Partition table entries are not in disk order Command m for help

到这里，就已经将原先的windows的E盘（2501到5000柱面），那个/dev/sda6分成了三个区。现在如果保存分区操作后，再使用格式化工具创建文件系统后，原先的 2501到5000柱面上的数据将丢失。当然，我们不必担心，因为事先已经将文件复制到了其它的地方了。注意：现在有一个问题，看上面/dev/sda11 的尾柱面是 5000 ，而/dev/sda6的首柱面是5001 。一直到/dev/sda8 的首柱面都位于/dev/sda11的尾柱面之后。也就是说它们的物理位置在后面，但分区编号在前面。为改变这一状况，有一个简易的方法。就是先删紧靠 5000柱面之后的一个分区，然后立即按默认首柱面和尾柱面进行分配，在重建分区表的时候注意把分区的系统标识也改也原先的（因为 Linux的fdisk中默认的新建的分区系统标识为id为83。

The article introduces a method on software preventing copy Use particular disk tract juncture technology to make maternal disk action prevent copy disk of software confirm larcener software by installing hard disk parameter which has been encryped compared and storaged .

介绍采用特殊磁道接缝加密技术制作的母盘作为安装软件的防拷贝磁盘；采用硬盘安装参数经加密，保存，比较，判别确定是否为盗版软件，达到软件的防非法拷贝

First, this paper describes the situation and the prospect of magnetic disk drive, and points out that the dual-stage disk actuator is an effective way to increase track density of magnetic disk. The advantages and the problems of dual-stage disk actuator are discussed in brief.

本文首先对磁盘驱动器的发展情况和趋势进行了概述，指出磁盘两级定位系统是大幅度提高磁盘道密度的有效途径，并对其优势和有待解决的问题进行了论述。

However,some of the faster nonimpact printers can produce multiple copies of the same report faster than the time it takes impact line printers to do a single run with mult-plypaper 2 But user should be careful about possible "head crash",which means the surface of the read/write head or particles on its surface come into come into contact with the disk surface,causing the loss of some or all of the data on the disk 3 Like music CDs,a CD-ROM is a read-only disk that the disk's content is recorded at the time of manufacture and cannot be written on or erased by the user.

应该是这样： 1然而，其中一些更快nonimpact打印机能产生多份副本，同时报告速度比所花费的时间影响线打印机做一个单一的运行与多plypaper 2 ，但用户应小心可能的"头部撞车"，这意味着表面上的读/写头或微粒表面，其生效接触到磁盘表面，从而导致丧失部分或全部的数据，就磁盘三喜欢音乐光碟，唯读光碟，是唯读磁盘磁盘的内容，是记录当时的制造和不能写上或擦除由用户。

We open the C disk access disk C, and these are: the method in accordance with the above my computer to open a list of projects, according to the numeric keypad 4 or 6 button to switch to the 13 list, according to the number of keyboard 1 or 3 key to switch to the local disk C set the list of projects, according to slash the number of keys on the keyboard "click" options, press the Enter key numeric keypad,"Double-click" to open the C disk.

我们打开C盘查阅C盘的状态，步骤是：依照上面的方法打开我的电脑列表项目，按数字键盘的4或6键切换到13列表后，按数字键盘的1或3键切换到本地磁盘C盘列表项目，按数字键盘上的斜线键"单击"可选中，按数字键盘的回车键"双击"可打开C盘。

Major components of the vibration will meet head on the disc, causing the hard disk read-write head across the disk surface, which might damage the disk surface, the potential to undermine the existence of data on your hard disk your hard work yo!

大的震动会让磁头组件碰到盘片上，引起硬盘读写头划破盘表面，这样可能损坏磁盘面，潜在地破坏存在的硬盘上数据

Zero once the damaged track will be the primary boot hard drive and the partition table information will be seriously damaged, resulting in the hard disk can not boot. 0 tracks damaged judge: System self-test pass, but the boot partition C disc lost or directory is missing, there are laws of the hard disk "... creak ... creak" seek the sound of running SCANDISK scanning C disk, in the first cluster a red "B", or can not find Fdisk the hard disk, DM died in the 0 track, the track such a situation that is zero damage!

零磁道一旦受损，将使硬盘的主引导程序和分区表信息将遭到严重破坏，从而导致硬盘无法引导。0磁道损坏判断：系统自检能通过，但启动时，分区丢失或者C盘目录丢失，硬盘出现有规律的"咯吱……咯吱"的寻道声，运行SCANDISK扫描C盘，在第一簇出现一个红色的"B"，或者Fdisk找不到硬盘、DM死在0磁道上，此种情况即为零磁道损坏！

According to our present broadcasting situation,the thesis proposes using new technology to update and reform the present HFC. It also suggests broadcasting using self-advantage and arranging EPON in order to win the supermarket.

论文从我国广电的现状出发，结合实际，积极倡导采用新技术更新、改造我国现有的HFC网络；倡导广电现阶段利用自身优势，部署EPON网络来赢取市场。

A new general kinetic equation was derived in which the effect of the removal of condensation water was taken into account completely, and was applied to the polyesterification kinetic study of AA/HPHP and AA/NPG. It was found that the reaction order of self-catalyzed polyesterification was not constant. For these polyesterifications, the reaction order was 2.5 at a low temperature, while 3.0 at a high temperature.

考虑缩合水的排除对反应体系的影响，用体积浓度单位推导出一个新的聚酯反应总包动力学方程，并应用到AA/HPHP和AA/NPG两个聚酯化反应的动力学研究中，研究发现，自催化聚酯反应的反应级数并不是固定值，对于AA/HPHP和AA/NPG两个聚酯化反应而言，低温时反应级数为2.5，高温时反应级数为3.0。