查询词典 force-feeding

It would be, in effect, a smaller version (perhaps 1,500-strong) of NATO's now-defunct Allied Command Europe Mobile Force-Land, a brigade-sized force (about 5,000 soldiers) whose role was to act as a tripwire in the cold war.

实际上这将会成为现在已经不存在的北约的盟军欧洲统帅部地面机动部队——一支旅级部队（兵力大约5000人），作用是冷战中作为前线军事力量（tripwire是个军事术语，指能引发较大规模军事行动的规模相对较小的前线军事力量，译者注）——的瘦身版（兵力也许有1500人）。

Because of the biceps and triceps' contract force and the reacting force of trochlea humeri, compressive stress was produced in the front of olecranon, while tensile stress in the back. The stress caused olecranon fracture. The place of most fracture lied between the tine and the middle, and most of fracture line was transverse or oblique.

由于肱二头肌、肱三头肌的收缩和肘关节反力的作用，尺骨鹰嘴关节侧产生压应力，背侧为张应力，导致尺骨鹰嘴发生骨折，骨折多发生在尖腰部，骨折线多呈横形或短斜形。

Truss bridge generally more common in the railway and highway; into winding force by force, and last quarter of two ...

桁架桥一般多见于铁路和高速公路；分为上弦受力和下弦受力两种。。。。

The predicted values of resistance force and power for the conventional surface furrow opener at 100 mm depth and 0.28 m/sec speed were0.51 kN and0.14kW, while at 100 mm depth and 0.92 m/sec the values were0.98kN and0.88kW. At 135 mm depth and 0.28 m/sec speed, the conventional surface furrow opener recorded 0.70 kN and 0.20 kW, while at 135 mm and 0.92 m/sec speed, the values were 1.40 kN and 1.26 kW. The predicted values of resistance force and power for the biomimetic furrow opener surface with UHMWPE tubular section ridges at 100 mm depth and 0.28 m/sec speed were 0.45 kN and 0.12kW, while at 100 mm depth and 0.92 m/sec speed, the values were 0.73kN and 0.66 kW.

对于超高分子量聚乙烯材料仿生脊型非光滑结构表面，当耕深100 mm和耕作速度0.28 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.45kN和0.12kW；当耕深100 mm和耕作速度0.92 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.73kN和0.66kW；当耕深135 mm和耕作速度0.28 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.62kN和0.17kW；而当耕深135 mm和耕作速度0.92 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.91kN和0.82kW。

The experimental values of resistance force and power for the biomimetic furrow opener surface with UHMWPE tubular section ridges at 100 mm depth and 0.28 m/sec speed were 0.60 kN and 0.16 kW, while at 100 mm depth and 0.92 m/sec speed, the values were 0.80 kN and 0.72 kW. At 135 mm depth and 0.28 m/sec speed, the biomimetic furrow opener surface with UHMWPE tubular section ridges recorded 0.76 kN and 0.21 kW, while at 135 mm depth and 0.92 m/sec speed, the values were 0.95 kN and 0.85 kW. The predicted and experimental values of resistance force and power for the conventional surface furrow opener were higher than predicted and experimental values for the biomimetic furrow opener surface with UHMWPE tubular section ridges.

对于超高分子量聚乙烯材料仿生脊型非光滑结构表面，当耕深100 mm和耕作速度0.28 m/sec时，实测的仿生开沟器的土壤阻力和动力消耗分别为0.6kN和0.16kW；当耕深100 mm和耕作速度0.92 m/sec时，实测的仿生开沟器的土壤阻力和动力消耗分别为0.8kN和0.72kW；当耕深135 mm和耕作速度0.28 m/sec时，实测的仿生开沟器的土壤阻力和动力消耗分别为0.76kN和0.21kW；而当耕深135 mm和耕作速度0.92 m/sec时，实测的仿生开沟器的土壤阻力和动力消耗分别为0.95kN和0.85kW。

And the grasp features of the combined numerical cyclist dummy's hand is determined by simulation experiments, highlighting the interaction force between the cyclist and the two-wheeler, the driving inertia of the two-wheeler, the coupling force between the tyre and the ground, and thus set up the human-vehicle-road coupling system simulation model.

通过仿真试验确定组合式骑车人数值仿真假人的手部抓握特性，突出骑车人与两轮车之间的相互作用力，两轮车的行驶惯性和其轮胎与地面之间的耦合力，从而建立了骑车人-两轮车-路面耦合系统仿真模型。

In the method of time-frequency the phase of unbalanced force is confirmed by analysis of time domain and amplitude of unbalanced force is confirmed by analysis of frequency.

在这种时-频动平衡方法中，用时域分析来确定不平衡力的相位，用频域分析来确定不平衡力的大小。

Very simple apparatus with swinging pendulums and levers have demonstrated that energy CAN be extracted from centrifugal force, when an unbalanced oscillation between centrifugal force and gravity is created.

非常简单的钟摆摆动仪器和手段已经证明，能源可以从离心力中得到，当离心力和重力之间的不平衡振动。

Based on the force and moment balances on the shaft and compressor frame, mathematical formulation of shaft bearing loads, unbalanced force and moment acting on the frame were made in terms of balance weight design parameters such as masses and installations of the upper and lower balance weights.

分析了在二次平衡中，主、副平衡重的安装角为任意值的条件下涡旋压缩机的动力特性，推导了在保证机架受力情况最好的条件下，通过改变平衡重的安装角来控制主轴承受力的设计公式，从而确保了轴承的使用寿命，提高了压缩机的可靠性。

In order to take the influence of the internal force from translation into consideration, the design of in-plane buckling of unbraced frame s adopted a new second-order elastic method to calculate the structural internal force, e.

为考虑变形对内力的影响，对无支撑框架的平面内稳定计算提出采用假想水平荷载法进行二阶弹性内力分析，以与国际上钢结构设计相接轨。

It is suggested that TDS can be used as a new method for the analysis of pedogenesis and climatic change.

总之，热处理过程中磁化率的变化能非常灵敏地反映磁性矿物的转化情况，而且，这种转化往往与样品所经历的土壤化作用强度密切相关，因此，TDS可做为分析成土作用强度和古气候变化的一种新方法。

Therefore, in this chapter, I will research into the conflict and contradiction of the paternity. Also, in this novel, the father's behavior of "He who loves well chastises well." is quite suspicious, one of the reasons is that the father thought his son belonged to him. And then, this thesis quoted Lacan's theory to touch upon that someone who has accepted the concept of patriarchal society, he will be influenced for his whole life. That also reveals that human being has no choice sometimes in this society.

因此本章会先就父子关系的冲突与矛盾做深入的探讨，小说中的父亲似有对儿子爱之深责之切的行为，其原因可能在於父亲将儿子视为所有物所致；其次，论文将引用拉冈相关理论，讨论在父权社会中，不论身分为何，只要是已受父权社会观念根深蒂固影响的人物，终生都将受其所苦，此也揭示出人生存於社会上的无奈。