查询词典 force-feed

For explain this equation, Jos's approach discard the equibalance force of density variation, only consider equibalance force from saturation of solute, it is equal the movement of fluid in the weightless condition, this is not realistic.

从方程的角度上来说， Jos 的算法里丢弃了水趋往均势的运动量，只包含了水中溶解物趋往均势的运动量，相当于无重力环境下水在平面上的运动，或者是溶解物在液面上运动，这是不符合实际的。

The force equilibrious equation and the approximate plastic conditions are set up,solved using the boundary condition and the strenth static coefficient σ/σs of fixed cycles short core when the tube is drawn so calculating the drawing force at every pass.

建立近似的力平衡方程，近似的塑性条件。应用边界条件联解上述方程，求出固定圆柱形短芯头拔管时的应力状态系数σ_拉/σ_S，以计算各道次的拔制力。

For because of Cutting force, inertial force , exogenic processand so on the gravity is not destroyed the work piece already thecorrect position which decides, but also must certainly exert to itclamps the strength, this process is called "clamps".

为了不因受切削力、惯性力、重力等外力作用而破坏工件已定的正确位置，还必须对其施加一定的夹紧力，这一过程称为&夹紧&。

Basically, an AFM is using the attractive or expulsive force between the atoms of the AFM probe and the sample. The force can be as small as at the order of N, in which any minute deviation may be fatal to the measurement.

基本上， AFM 是依据量测针尖与样品之原子间的吸引力或排斥力的大小不同，达到的量测与显像解析的目的，一般的探针大约可感测到 N 的力量大小，在如此微小的力量情况下，一个可靠有效的探针振荡悬臂梁之弹簧系数校正方法也就相形重要。

The results show that the air crossing pressure pulse magnitude of the container generated in the tunnel is 3.46 times that generated in open air when container flat wagon at the speed of 160 km/h passed by EMU moving at the same speed. Both the lateral force and overturning moment of the container train during the crossing induced in open air and tunnel are approximately proportional to the square of running speed of the passing train. The pressure of crossing side and uncrossing side for the container flat wagon is almost equal since the one-dimensional characteristic of pressure distributing induced in the tunnel is not faintish. Consequently, the value of the lateral force and overturning moment of the container train generated in open air is greater than that generated in the tunnel, about 1.1 times.

研究结果表明：集装箱平车以160 km/h的速度与动车组等速交会时，在隧道内会车时车载集装箱中部压力变化幅值是在明线会车时的3.46倍；在明线和隧道内会车时，集装箱列车受到的侧向力和侧滚力矩均与交会列车运行速度近似成平方关系；因隧道内压力分布一维特性较强，集装箱平车交会侧与非交会侧压力相差并不大，因此，在明线会车时集装箱平车受到的侧向力和侧滚力矩均比隧道会车时的大，大约是其1.1倍。

On the basis of analyzing and evaluating civil product industry status quo,using fezzy set, the paper analyzes and determinds that RYR Institute shold take high-tech product ,self-control technology ,detecting technology electronic device for automobile ,as well as military initiating technology as prop industry of its civil product competition in order to provide plunge point for the development of its civil product industry .Then ,it analyzes the key competitive force of the civil product corperation of the institute ,set up C2R and C2GS2 models used in technical progress DEA analysis ,fmds the relation between scale benefit .and production administration .Through the analyzing of competitive core force ,it indicates that the cause resulting in low benefit of military enterprises is stagnancy of human resource exploitation .The key for the realization of advance by leaps and bounds of civil product work of RYR Institute is personnel excitation mechanism.

论文在对民品产业现状分析与评价的基础上，应用模糊聚类法分析并确定了以高技术产品、自控技术、探测技术、汽车电器及军工传爆技术作为RYR所民品竞争的支柱产业，为RYR所民品产业的发展提供切入点，在此基础上分析了RYR所民品公司的核心竞争力，建立了技术进步DEA分析的C~2R模型和C~2GS~2模型，找出了RYR所规模效益与生产组织管理方面的关系，通过对核心竞争力的分析，挑明了军工企业效益低下的主要原因是人力资源开发滞后，要实现RYR所民品工作的突飞猛进，建立有效的人才激励机制是关键。

Including the force BQ ao mixture and the force seepage cleaning media, can eliminate the bathtub to soak the circle, the soap filthily effectively, the boiler scale and so on.

含强力BQ型鳌合剂和强力渗透除垢剂，能有效清除浴缸渍圈，皂垢，水垢等。

And the capacitor touch sensor has compact structure, high mechanical strength, and high flexibility, while the product can contact the surface with any curvature to sense the volumes of normal force and tangent force, and be applied for the production of flexile capacitor touch sensor array.

所制作的电容式触觉传感器结构轻薄，机械强度高，可挠性好，可贴附在任意曲率表面同时感受法向力和切向力的大小，同样适合由众多这种柔性电容式触觉传感器单元组成阵列的制造。

The studies also show that the increased supporting force can reduce the radius of the fractural zone in surrounding rock derectly, but the main effect of the increased supporting force is to improve the compressive stress on rock in elastoplastic region, and to increase the rock strength of whole fractural zone so as to reduce the scope of fractural zone.

而当围攻岩中出现了塑性区和破裂之后，支护力的作用才开始显现。提高支护力可直接减小围岩破裂区范围，但提高支护力的主要作用是提高弹塑性区围岩压应力，达到提高破裂岩体宏观强度的目的，从而减小塑性区和破裂区的范围。

The results are as follows:(1) With the imposing of orthopedic force of simulating maxillary protraction on maxilla, in the sagittal direction, the maxillary complex of the SD Rats in experimental group grows more quickly than that in two control groups, and the extent of the maxillary complex increases more evidently. The maxillary complex displays anti-clockwise forward and upward rotation.(2) With the imposing of orthopedic force on maxilla, upper incisors exhibit labial-inclined, labioclination of lower incisors changes insignificantly, and the shape and the dimension of skull are not affected significantly.(3) The expression of TGF-3 , in frontomaxillary sutures and palatomaxillary sutures shows different intensity in different extent of time. But The expression of TGF-{3, in experimental group is more intensive than that in two control groups, and that in operated control group and natural growth group has no significant difference.

结果如下：在模拟上颌前牵引矫形力作用下，(1)生长发育期大鼠上颌复合体在矢状方向生长加快，长度明显增加，并表现出向前向上的逆时针旋转；(2)上切牙唇倾，下切牙的唇倾度没有明显变化，颅脑的形态与大小不受影响；(3)额颌缝和腭颌缝中TGF-β_1的表达，同一时段实验加力组要强于手术对照组与自然生长组，而手术对照组与自然生长组之间无显著性差异。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。