查询词典 fluidity

Embellishing reality and aesthetics is a two way fluidity process indivisible in documentary film creation.

&真&的美化和&美&的真化是纪录片创作中一个不可分割的双向流动过程。

The results show that the fluidity of extruded state alloy is the lowest.

半固态坯的流动性能是获得优质、复杂制件的基础和关键。

New dribbles, feints, ways of shooting at goal,fluidity in off-the-ball movement and stringing of passes, as well as the keeper have been reworked.

新的带球动作，假动作，射门方式，无球状态下的跑动和传球方式，甚至门将都被重新制作。

If you want to achieve an even layer of glaze in all parts of the body , more attentions should be paid to the different fluidity of various types of glazes.

要做到造型中各部分的釉层均匀一致，厚薄适当，还要注意到各种釉的不同流动性，实在不是一件容易的事。

Capital securitisation, anew sparkle in world financial renovation since 1970s, was originally used torevitalize the bank capital that is short of fluidity and then played an important role indisposing the non-performing loans.

资产证券化是20世纪70年代以来世界金融创新的一个新亮点，起初主要是用来盘活银行流动性较差的资产，后来在不良金融资产处置方面也起到了重要作用。

The pressure of fluidity surplus still perplexes China's economy operation so in short run tight monetary policy will continue.

流动性过剩的压力仍然影响我国经济运行，在短期内紧缩货币政策将继续下去。

Two series of polyurethane acrylate grafted acrylic resins (Acr-g-TPU-PETA and Acr-gPPU-PETA) self-emulsifying systems are obtained by grafting -NCO group modified polyurethane acrylates with acrylic copolymer prepared from n-butyl acrylate, styrene,βhydroxyethyl methacrylate and acrylic acid The self-emulsifying systems showed Newtonian fluidity with viscosity closed to that of water, the solid contents were around 30% The T〓 of 15～4℃ for dried film before photocuring favored film formation at room temperature DSC and DMA results showed that PU-PETA is compatible with acrylic resin in the grafted resin The TG and dTG curves for Acr-g-PU-PETA samples were substantially different from the corresponding blends, and the brodened dTG peaks for photocured grafted resin suggest that there might be multiple interactions among chain segments The photocued film of the grafted resins self-emulsifying system exhibited good overall properties with polyurethane acrylate grafts ranging from 30% to 50%, and Acr-g-TPU-PETA series showed better properties than Acr-gPPU-PETA series The adhesion of the photocured film was 1～2 grade, impact strength was 50kg-cm and flexibility was 1mm The Shore hardness and the adhesion of the film decreased markedly if PETA was replaced by HEMA as photoactive group due to the lower C=C double bond content in the grafted resin The polyhydroxy amine-linked thioxanthones photoinitiators can be evenly dispersed in self-emulsifying system without color spot appearing in the dried film The films photocured with IV〓～IV〓 generally exhibited higher Shore hardness, gloss and solventresistance than that cured with Irgacure 2959 and did not induce the rusting of the iron substrate Pigmenting with titanium oxide had no effect on the photocuring The polyhydroxy amine-linked thioxanthone IV〓 and IV〓 can be new candidates for the formulation of titanium oxide pigmented photocurable water-borne coatings for their pale-yellow appearance and slight interference with the color of the coatings WB 4759 with high water-solubility coalesced and separated from the dried resin film, and even induced the rusting of iron substrate.

以丙烯酸丁酯，甲基丙烯酸-β-羟乙酯，丙烯酸及苯乙烯合成厂丙烯酸共聚树脂，并与含-NCO端基的聚氨酯丙烯酸酯接枝反应，经水性化后，得到两个系列（Acr-g-TPU-PETA和Acr-g-PPU-PETA）各5个不同配比的丙烯酸树脂接枝聚氨酯丙烯酸酯自乳化体系，粘度与水相近，为牛顿流体，固含量30％左右。光固化前干燥涂膜的玻璃化转变温度在-15℃～4℃之间，有利于室温下成膜。DSC及DMA谱表明两种树脂基本相容。Acr-g-PU-PETA的热失重行为明显不同于共混材料，接枝样dTG峰明显宽化，表明接枝样中链段之间的相互作刚有多重性，丙烯酸树脂与聚氨酯之间有一定的相容性。接枝树脂自乳化体系光固化涂层的综合性能以聚氨酯丙烯酸酯成分为50％～30％者相对较好，且以Acr-g-TPU-PETA系列更理想。光固化膜的附着力为1～2级，冲击强度为50kg·cm，柔软性多为1mm。以HEMA代替PETA作为接枝树脂的活性基团，碳—碳双键密度太低，光固化膜交联点太少，硬度和附着力均较差。多羟基胺连硫杂蒽酮光引发剂能均匀分散于树脂自乳化体系和接枝树脂干膜中，不出现色斑，光固化膜肖氏硬度一般高于以Irgacure 2959为光引发剂的光固化膜，光泽度及耐丁酮溶剂性能均有所提高，不会诱导铁基生锈，钛白着色对光固化结果几乎没有影响。本论文所合成的多羟基胺连硫杂蒽酮光引发剂IV〓与IV〓为浅黄色，对光固化涂层的颜色干扰较小，为配制钛白着色光固化水性涂料提供了新的光引发剂。水溶性太强的WB 4759在干膜中易聚结析出，且对所附着的铁基有诱导锈蚀作用。

It is recommended that the plasticizing efficiency of MLS should be more accurately judged by water reducing rate instead of fluidity of paste.

另外还探讨了正确评价MLS塑化效果的方法，认为采用混凝土减水率指标更能真实反映其应用效果。

The membrane lipid fluidity of infected cells appeared obviously low-There were significant differences statistically(p.05-0.01)(2)By cytohisto-chemical stain-ing and microspectrophotometer quantitating,before cultured 72 hours,ACP and SDH in infectedcells raised.

动态观察1、6、24、72h培养后的淋巴细胞、单核细胞、中性粒细胞，发现感染后细胞膜脂的流动性明显降低，并随培养时间的延长而明显，和正常对照组比较有显著性差异（P＜0.05～0.01）。

At last, the influence of the modified retarder on increasing fluidity of cement slurries was proven through experiment.

经性能测试发现，复配缓凝剂还有增强水泥浆流动度的作用。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。