查询词典 flue surface

The upside in the coping of reative cell and flank sets aspersion shower nozzle, time, aspersion of surface of grey grain of mensurable Xiang Shi, make the surface of limestone covers film of a thin water, when flue gas has spread every reative cell, the SO2 in flue gas and the limestone grain that covering water film undertake osculatory, in entering water film through diffusing, with limestone happening chemistry reacts, 80% above are the by-product that reaction produces gesso crystal.

反应室的顶部和侧面中上部设有洒水喷头，定时，定量向石灰颗粒表面洒水，使石灰石的表面覆盖一层薄水膜，当烟气流过每个反应室时，烟气中的SO2和覆盖着水膜的石灰石颗粒进行接触，通过扩散进入水膜中和石灰石发生化学反应，反应产生的副产物80%以上为石膏晶体。

Commonly used are desuperheater (sub-surface, and spray-type desuperheater Desuperheater two kinds) thermostat method; flue gas re - circulating thermostat method; swing burner thermostat law; flue baffle thermostat law; gas - gas heat exchanger thermostat law.

常用的有减温器（分表面减温器和喷淋式减温器两种）调温法；烟气再循环调温法；摆动燃烧器调温法；烟气档板调温法；汽—汽热交换器调温法等。

The well type gas nitrogenation oven uses the multi-layered multistage multi-link multi-spot assignment type ammonia input mode, enables the active nitrogen member fast evenly with the work piece surface union, forms the even fast nitrided level, the coordinate high speed spiral air flue, the effective addressing work piece blind hole and the deep hole nitriding craft, nitrides strongly by the microcomputer programmed control infiltrates, the diffusion technology heating curve.

井式气体氮化炉采用多层多段多环多点分配式氨气输入方式，使活性氮气分子能快速均匀地与工件表面结合，形成均匀快速氮化层，配合高速螺旋风道，有效解决工件盲孔和深孔地氮化工艺，由微电脑程序控制氮化强渗、扩散工艺加热曲线。

Both the gas velocity profiles and total pressure distributions are well axial symmetric when flue gas pass by the demisters with rotated-stream trays , which the liquid drops are revolved and threw toward wall surface by flue gas to carry out gas-liquid separation .

结果表明：烟气经过折板除雾器，产生了明显的压降，且在拐角区域，湍流耗散强烈，是实现气液分离的关键区域；而烟气经过旋流板除雾器，速度和压强分布具有良好的对称性，液滴被气流旋转抛向壁面实现气液分离。

The mathematical correlation model of heating surface area and flue outlet temperature has been established,and the best flue temperature at furnace outlet upon condition that the heating surface area is minimized has been obtained by optimization.

建立锅炉受热面积与炉膛出口温度的数学关联模型，并通过解的最优化处理得到锅炉最少受热面积下的最佳炉膛出口温度。

For coal-fired boilers: coal rate of 8 ~ 20%; clear coking coal-fired system 50 ~ 95%; to reduce sulfur emissions 20 ~ 30%; to reduce harmful gas emissions 50 to 95 percent; firepower improve about 20%; lower value of about 14% of spontaneous combustion, and life brought about by the extension of the boiler to reduce the repair cycle of the furnace, flue, heating surface, such as equipment maintenance Qing Jiao role in enhancing the stability of combustion, reducing harmful gas emissions and other benefits.

对于燃煤锅炉：节煤率为8～20％；清除燃煤系统结焦50～95％；降低硫排放20～30％；降低有害气体排放50～95％；火力提高20％左右；降低自燃值14％左右，并带来延长锅炉使用寿命，减少维修周期，对炉膛、烟道、受热面等设备具有清焦保养作用，提高燃烧的稳定性，减少有害气体的排放等效益。

Through the flue gas and air characteristic analysis in supercharged boiler,the results showed that the value of parameters would increase with the increase of fuel consumption.And volume heat load of the furnace, fuel consumption, heat change between flue gas and convective heating surface and evaporation value would increase with the increase of compression ratio.The heat calculation would be different because of dissimilar thermal calculation in the turbo-compressor when the boiler load was changed.As the boiler load increased,heat loss in the turbo-compressor would increase and the efficiency of the boiler would decrease.The results of the boiler start-up simulation showed that the time of start-up would decrease with the increase of flue consumption ,but instantaneous pressure amplitude would increase.Steam water"s dymamic diversification would be more complex than flue gas"s,and dynamic characters of their parameters would be changed due to different boiler load and disturbance variable,which was shown by results of the simulation when boiler load was changed.

通过分析增压锅炉内的空气、烟气参数特性，发现随着锅炉负荷的增加，空气和烟气的各项参数值都相应的增加；炉膛容积热负荷、锅炉的燃料负荷随着增压比的提高成比例增加；随着增压比的增大，烟气与对流受热面的换热增加，蒸发量随之增加；由于涡轮增压机组在不同负荷下的热力计算不同而造成增压锅炉在不同负荷下的热平衡计算的不同；锅炉增压机组的总的热损失随着锅炉负荷的增加而增加，而增压锅炉的热效率随着锅炉负荷的增加而减少；锅炉启动模拟仿真结果中发现，锅炉启动时燃料量增加，锅炉的启动时间就会减少，但是瞬时升压速度会增加；而动态负荷变化模拟仿真结果中发现，锅炉汽水侧的变化相比烟气侧更为复杂，且在不同负荷和不同扰动量下，烟气侧和汽水侧的重要参数动态特性是不同的。

By using the said model, the mass flow of flue gas and steam can be calculated on the basis of temperature and pressure concerning the working medium at inlet and outlet of the boiler's heating surface, and the variated amount of the heating surface's thermal resistance can be calculated without using structural parameters of the heating surface.

由于简单换热器模型能够根据锅炉受热面进、出口处工质的温度和压力，计算烟气和汽的质量流量；可以不使用受热面的结构参数，计算受热面导热热阻的变化量。所以，采用该模型开发电站锅炉吹灰优化控制系统，能够解决传统方式存在的流量计算精度低、污垢热阻计算不准确等问题。

These factors have seriously influenced the security and economical operation of the unit. This paper firstly summarizes the research background and the general situation of resarch about the overheating problem of boiler's high-temperature surface ,introduces the aspects and research findings in this field such as flux deviation、thermal deviation、flue gas velocity deviation at the exit of furnace and tee bends,et al.Then analyses the reason why high-temperature surfaces are overheated from such aspects as design、manufacture、operation, et al and points out one of the main factors that cause the overheating of reheaters is the flue gas velocity deviation caused by the remaining turning at the exit of furnace.

本文首先综合论述了课题的研究背景和目前电站锅炉高温受热面超温问题的研究概况，介绍了国内外流量偏差、热偏差、炉膛出口残余旋转、&三通&等研究方向和研究成果，然后从锅炉的设计、制造、运行等方面分析了高温再热器超温的原因，指出水平烟道内气流的残余旋转是造成再热器超温的主要原因之一。

The effects of different cutting-root methods (time of the cutting, distance of cutting surface to stem base, and the numbers of cutting surface) and K top-dressing measures at later growth stage on K content in leaves of flue-cured tobacco plants were studied.

从断根时间、断根部位、断根数量、断根时追钾与否及追施钾素的形态等方面研究了不同处理及其组合对烤烟烟叶含钾量的影响。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。