查询词典 flow

In this paper, a full flow model is given for calculating the average residence time of molten steel in non-symmetry multi-strand tundish to analyze flow pattern, the model is as follow:〓 The model can be used to calculate the volume fraction of the dead area、the piston flow and the mix flow, and is satisfactorily applied to the water model of three-strand tundish of Guangzhou Steel Works to analyze the data of the experiment.

本文认为在研究中间包内高温钢水的流动问题时，应该考虑钢水密度变化这个条件对钢水流动的影响，这样其结果更符合实际钢水流动规律。本文针对非对称多流中间包，提出了全流量模型计算多流中间包钢水平均停留时间：〓该模型也能够很好地计算多流中间包的死区、活塞流区、全混流区体积分数。

The flow stress was repeated by calculated using the "single factor" flow stress formula, the metal machining process was simulated interatively with new flow stress. When simulating value was in good consistent with experimental result, the "three-high" data and flow stress data were obtained.

由&单因素&流动应力公式反复计算与模拟应变率对应的流动应力，基于新的流动应力有限元模拟迭代的进行并追求模拟值与实验结果的一致，获取能反映切削材料力学性能的&三高&数据和流动应力数据。

Shunt flow valve assembly works Set flow diversion valve is diverting valve, set flow valve and flow diversion valve assembly general.

分流集流阀是分流阀、集流阀和分流集流阀的总称。

However, opening right turn on red light would increase the conflict between right-turn traffic flow and straight traffic flow on green.Nevertheless, for the respect of efficiency, opening right turn on red could indeed, under the premise of safety, improve traffic flow in some intersections with small traffic flow.

因开放红灯右转会增加右转车流与绿灯直行车流、行人之冲突，可能使交通事故增加，但以效率立场而言，开放红灯右转在部分车流量较小路口，确实可在维护安全之前提下，增进行车效率。

The Froude number of flow is the factor of flow status: supercritical flow or subcritical flow.

由流体流动的福劳德数可以确定流动的缓急程度。

The flow resistance of Ice slurry increases if the pipes obliquity increases. That means the ice slurry that in the level pipe has the largest flow resistance, the reason is: the gravitation make the flow became more and more foul-up, accordingly, lead to the increase of flow resistance. Sixthly, introduced all of the preparative tasks before we began the experiment, because we met many problems during the test, we had our own methods which could solve these problems. In this paper, problems and these methods were introduced.

随着管道倾角的增大，二元冰的摩擦阻力减小，也就是说相同条件下水平管道内的摩阻最大，这是因为重力的影响导致管道内二元冰和乙二醇分层现象更加明显，从而导致紊流程度增大，最终使得摩阻增大；第六，对二元冰蓄冷空调系统运行前的准备工作进行了介绍，由于在试验过程我们遇到了很多问题，针对这些问题，我们有自己的方法和解决办法，本文介绍了这些问题和相应的解决办法。

In accordance with the established design flow and design of lift in the type spectrum, the first ordinate in order to design the head to find out the requirements in line with the head, while the flow ranging from a few pumps, and then in the abscissa in order to design the flow to determine the selection of What kind of pump.

根据确定的设计流量和设计扬程，在型谱图上，首先在纵坐标上以设计扬程查找出符合扬程要求。而流量不等的几种水泵，然后再在横坐标上以设计流量来确定选用哪一种水泵。

, though particles are not in the flow passage of the outlet of the impeller, the absolute velocity of particles has a component velocity whose whirling direction is the same as that of the impeller under the influence of the revolving impeller, in addition, particles do not flow toward the outlet of the impeller, instead, they flow toward the inlet of impeller.

款 尽管粒子是不是在流道叶轮，绝对速度的粒子的一个组成部分，其速度旋转方向是相同的叶轮的影响下， 3777叶轮，此外，颗粒不流向叶轮，相反，它们流向导流叶轮。

In this paper, the bump patterns for flip-chip packages are discussed first, then an experiment is setup to study the dispensing phenomena for different bump patterns, and the CAE software is used to analyze and identify with experiment mutually. From these thorough comparisons and analytical analysis, the existence of channel could slow down the flow, the high density of bump could speed up the flow, and it could avoid the air trap by modified the bump and channel's arrangement on flip-chip package. Then flows in rectangular microchannels driven by capillary force and gravity are discussed; furthermore, the theoretical model of flow in microchannel driven by capillary force and gravity is formulated from the Navier-Stokes equations.

本文首先针对覆晶底部充填进行相关理论推导、实验与模拟，探讨不同凸块配置模型所造成的波前不平滑现象对底部充填流动的影响；即依据相关参数建立模型进行底部充填实验，同时以CAE(Computer-Aided Engineering)模流分析软体进行模拟，在完成理论探讨、实验与模拟分析之后，交叉比较理论、实验与模拟分析结果，归纳出影响底胶充填流动之因素，由结果显示在凸块密集度较高的区域，凸块可以帮助流动，但是在凸块区后方的沟槽区域则因为凸块区所提供之流量不足，所以会造成波前落后的现象，另外藉由修改凸块与沟槽配置的关系，可以有效的控制波前形状的变化情形，避免产生包风现象。

The hot-wire anemometry was also used to characterize the air flow patterns that were generated by high and low swirl port in a cylinder of a steady-flow rig. Some important phenomena of air flow in the simulative cylinder were found.

借助于热线风速仪研究了两种不同的螺旋进气道在稳流气道试验台的模拟气缸中产生的流场结构，发现了一些重要的现象。

Vishnu entered a dark fourth dimensional dream that did not support his field or continued life.

毗瑟挐进入了一个第四密度的黑暗梦想，那里并不支持他的能量场或继续生命。

Leaders and decision-making persons use it to collect the data, including the information of unit work, handing in fee, oweing fee, prepaying fee,changing and afterpaying and account transfering of joining-insurance employee, and account paying of all kinds of insurances from hospitalization insurance institutions.The collected data is picked up, organized, switched and showed to user.

该子系统主要面向各级领导、决策分析人员；从各个医疗保险经办机构和定点医疗机构采集数据，包括在各个医疗保险经办机构处理的单位办公信息，单位缴费、欠费、预缴费信息，参保职工变更信息，参保职工增减变动信息，参保职工补缴信息，参保职工帐户划拨信息：包括各定点医疗机构处理的各险种帐户支出信息，各险种的统筹金支付信息等；将采集的数据提取，组织和转换，然后展示给用户。