查询词典 flow point

Using a continuation power flow method based on the above load-flow algorithm, the critical point of voltage stability of a test system is computed and compared to that by the conventional power flow method.

采用上述潮流模型的连续潮流算法，对一个试验系统进行了电压稳定临界点的计算，并与常规潮流算法进行了比较。

Based on the BISQ model, we studied the elastic wave speed in two-phase porous isotropic media and its relation with Biot-flow and squirt-flow. The Green function is obtained for a point load in the two-phase porous isotropic media using the decomposition of the field potencial and the properties of Delta function. The expression and effects of squirt-flow in BISQ-Green function are discussed.

以BISQ模型的波传播方程为基础，研究了弹性波在孔隙各向同性介质中的传播速度及与流体的Biot流动和喷射流动力学机制的关系，进一步利用场势分解和δ函数的性质，给出了同时受Biot流动和喷射流动两种动力学机制作用下，两相介质波场位移在集中力作用下的Green函数，并讨论了喷射流动在Green函数中的表现形式和作用。

To accelerate the widespread of Synchronous Chip Seal and improve the operation quality of Synchronous Chipsealer, key techniques which influence the operation quality is studied detailedly, including the control of distributing quality, the dynamics characteristics of hydraulic system and the spray characteristics of asphalt nozzle of Synchronous Chipsealer.1 The factors which influence Synchronous Chip Seal quality are studied. Fiducial probability of simultaneous distribution density is advised to be used in evaluating the distribution bias and standard deviation of asphalt and aggregates simultaneously, which is more advanced than the single index evaluation method used before.2 The volume efficiency formula of asphalt pump is revised after analyzing the data of volume efficiency with mathematical statistics, which is helpful to match the asphalt spray system and control the flow out of asphalt pump accurately. With equation deduction and experiment, dynamic of hydraulic system used in Synchronous Chipsealer is studied, which lay the theory foundation on improving the stability and efficiency from design and controlling.4 Simulation on hydraulic system used in Synchronous Chipsealer is done with AMESim; the results indicate that multi-circle parallel connected hydraulic system with constant pressure power is better than that with load-sensing pressure power at present, because the latter will oscillate when the multi circles work at the same time. This conclusion has been proved during the debug of Synchronous Chipsealer.5 Asphalt nozzle characteristics, such as flat jet shape, flow distribution, are studied with experiment, the results indicate that cross quality of asphalt distributing is not increased linearly follow the increase of fan overlap level, the best point usually exists between two whole overlap level, asphalt distributing quality is better than±4% at the 2.5 overlap level, meets the superior specified in standard; The distribution quality of Synchronous Chipsealer can be increased by spray asphalt of different flow rang with nozzle of different diameter

为了加快同步碎石封层技术的推广，提高同步碎石封层设备的作业质量，本文对同步碎石封层设备作业质量的影响因素与控制方法、液压系统的动力学特性和沥青喷嘴的喷洒特性等关键技术进行了深入细致的研究：1研究了影响同步碎石封层作业质量的因素，提出了采用联合密度分布置信概率对同步碎石封层中沥青洒布量和碎石撒布量的系统偏差和标准差指标进行综合评价的方法，克服了传统评价方法只能对单一指标进行评价的缺陷；2采用数理统计的方法，研究了沥青泵的容积效率特性，修正了沥青泵容积效率公式，为沥青喷洒系统的匹配和沥青泵出口流量的精确控制提供了依据；采用数理方程推导与试验相结合的方法，研究了同步碎石封层设备液压系统的动力学特性，为从设计和控制的角度提高同步碎石封层设备液压系统的稳定性和效率奠定了理论基础；3运用AMESim软件对采用负载敏感控制和恒压控制的两种同步碎石封层设备液压系统进行仿真，结果表明：负载敏感控制的并联液压系统在多回路同时工作时，由于液压泵排量控制参考压力不稳定，容易引发液压系统振荡，恒压控制的并联液压系统是目前技术条件下比较理想的同步碎石封层设备工作装置驱动方案；该结论亦通过同步碎石封层设备装机试验得到了验证。4采用试验的方法对沥青喷嘴的喷洒特性进行了研究，结果表明：沥青洒布的横向精度并不是随着喷洒扇面重叠度的增加线性增加，其最高点通常出现在二个重叠度之间的"半重叠位置"，"2.5重叠"洒布时，沥青的横向洒布精度≤±4%，可以达到国家相关标准中的优级标准；同步碎石封层设备还可以根据不同洒布量情况下的流量需求，采用不同通径的喷嘴进行喷洒，提高沥青洒布精度。

With this method, calculating the flow at the running point of 60% load in the draft tube of a power station, which have a severe stability problem, accordingly gaining the frequency of the vortex flow and supply a gap for computing the unsteady flow in draft tube.

依据该方法，就国内某振动问题比较严重的水电站的尾水管进行了60％负荷工况点的不稳定流场计算，首次通过计算的方法得到了尾水涡带的频率特性，填补了这一领域的空白。

During the period from the reverse trendelenburg position to the starting point for the closure of the valve, the reverse flow of blood occurred in the experimental group with the velocity of (1.4 ± 0.3) cm/s; while in the control group, there was no reverse flow of blood, but the peak flow rate was decreased from (21.3 ± 2.1) cm/s to (18.2 ± 3.3) cm/s.

动物于头高脚低位至瓣膜开始关闭时，实验组均出现血液返流现象，返流流速（1.4 ± 0.3）cm/s；对照组未出现血液返流现象，但血液流速下降，由高峰流速（21.3 ± 2.1）cm/s 减至（18.2 ± 3.3）cm/s。

Shiv :- From windows work flow point of view there are two types of workflow the first is a sequential work flow and the second is a state machine work flow.

希夫： -从Windows工作流点的观点有两种类型的工作流程的第一顺序是一个工作流程，第二个是一个状态机工作流。

The flow characteristics of surface singular point, seperation lines, re-adhesional lines, low speed back-flow area of the impeller and back-flow area at the impellor's inlet were revealed.

揭示了额定流量与小流量时叶轮的表面奇点、分离线、再附着线、低速回流区和进口回流等流动特征，进而提出了改进螺旋离心泵设计方法与结构的设想。

On the basis of distributive shapes of point collection on the Poincare section, define three indexes to quantitatively describe the distribution of point collection. Which are distance between two adjacent points, diffused angle and distance between every point and center point of point collection.

以庞卡莱截面上RR间期序列的点集分布形式为基础，提出点集中相邻点间距离、扩散角度和点到点集中心距离三项指标，用以定量地衡量点集的分布形式。

Firstly, according to this character, primacy central point is detected by the exploring extremum method in the windows of 3×3 pixels. Then, basing on this central point, approximate normal line at ±45°、0°and 90°angle are drew.if the minimums of normal line is at central point and the difference between the minimums and the maximum in the normal line is more than the threshold, this point is considered to the edge point of image.

首先，在3×3象素的窗口中，如果中心值为最小值，则以该点为基础，以±45°、0°和90°方向作为近似法线带，然后判断该法线上的象素最小值是否在切点上（即是否在法线的中心点上），再通过检验切点与轮廓法线上亮度极大值的差值是否超过阈值，来判断切点是否为边缘轮廓上的点。

While it is usually impractical for the marshallate to measure blade weight directly by weighing the sword before the basket hilt, cross, or pommel weight is attached, the linear density of the blade (its weight divided by its length) can be estimated fairly easily by weighing the finished sword, locating the point on the blade at which it balances, and measuring the distance from the point of balance to the tip, from the point of balance to the hilt, and from the point of balance to the point where the additional weight (the basket hilt, cross, or cross plus pommel weight) is attached to the blade.

而这通常是不切实际的为marshallate来衡量的刀身Weight直接由称重剑前一篮子的Hilt ，交叉，或pommel重量是重视，线性密度的刀片可估计相当容易称重成品剑，定位点的叶片在它的结余，以及测量距离平衡点，以尖端性，从平衡点到极限和从平衡点以点的额外重量（篮子的Hilt ，交叉，或跨加pommel重量）是连接到刀片。

The production moved off-Broadway to New York City, where she won the Joseph E. Calloway award for her performance, and was profiled in American Theater Magazine as one of ten young theater artists to watch.

生产提出过百老汇的新的纽约市，在那里她赢得了约瑟夫calloway奖，她的表现，并于异型在美国的战区杂志之一， 10战区的青年艺术家观赏。

It's a risk tradeoff, and I believe that adding test support code usually wins.

这是一个风险的权衡，我相信添加测试代码通常会占上风。