查询词典 flow into

In this study, the simulator was applied to square-cup deep-drawing process, using 36 blank holder modules with 3 embedded hydraulic cylinders, that is, a total of 108 segment blank holding actuators were employed for controlling the material flow of blank into the die cavity.

在这项研究中，这个模拟器是用于制造过程的基础上，利用square-cup 36边模块3嵌入式液压缸，也就是说，共108段压致动器是用来控制物料流进模具型腔的空白。

The former is the conversion into monetary cost in accordance with effective work time and local per capital income by collecting relevant service flow time.The later mainly includes management,training,operation location rent,equipment depreciation,water and electricity charge and cost of repair and maintenance,etc.

前者通过收集服务流程时间，根据有效工作时间和当地行业人均收入折算成货币成本；后者主要包括管理、培训、业务用房租金、设备折旧、水电与维修费几个部分。

When a sudden power failure or accident or normal pump stops when the pump stops, the valve inlet water velocity to reduce stress Agency, the valve plate also fall, when its velocity is zero (that is, inlet flow rate is zero Department), large valve plate because of its own gravity and rapidly turn off (time 3s ~ 5s), the majority of water to prevent backflow, when the valve before and after the formation of a water pressure, water stress, on the one hand through the small valve at the bottom of the three slot for pressure relief vent pressure. 4 water stress from the bypass tube into the cavity patch up the control room (this process for the suction pressure chamber that can effectively absorb the energy of water), when water stress on cavity than inferior vena cava, the pressure of water promote the diaphragm down mobile , the current cavity pressure of water being squeezed out all the small valve plate slowly drop back to standby status, the process time to ease closure adjustable (3s ~ 150s), then the valve has been fully closed, watertight.

当突然停电或事故停泵或正常停泵时，阀门进水口处压力水流速降低，大阀板也随之下降，当其流速为零时，大阀板由于自身重力而迅速关闭（时间3s～5s），可防止大部分水倒流，此时阀门前后形成一种水压差，压力水一方面通过小阀板底部的三条泄压槽进行泄压。4）压力水从旁通管进入膜片控制室上腔（此过程为吸压腔，能有效吸收一部分水能量），当上腔压力水大于下腔时，压力水推动膜片往下移动，当下腔压力水全部被挤出来时，小阀板缓缓下降，恢复到待机状态，此过程中缓闭时间可调节（3s～150s），届时阀板已全部关闭，滴水不漏。

This paper introduces a telemetric collecting and processing system which can continually collect telemetric data flow at a data rate within 480k bps, accomplish the tasks of data division, engineer- ing unit transformation and real-time data display, and put the data into large external memory in a designed format.

本文介绍的遥测数据采集与处理系统能对码速率在480kb/s以内的遥测数据流进行不间断的采集，并在采集的同时完成数据分路、工程单位转换、实时数据显示等数据处理工作，并将数据按规定格式存入外部海量存储器。

This paper inqures into the energy equation of debis flow in drainage canal , according to the law of coservation of energy.

根据能量守恒原理，推导出泥石流在排导槽中的能量方程。

The main works of this paper are as follows.First, according to the three-step method, 1-D unsteady flow model in river network is introduced. A new topological structure is presented to describe and store the topology information and data in river network ,which realises the connection between GIS and the numerical program of hydraulic calculating and turns the program into a universal one .A new formula of internal boundary conditions with double-recursion algorithm is deduced, and the relationship of recursive coefficient between imaginary channel length and non-imaginary channel length is presented ,which makes sure that the model can comprise the numerical simulation of the internal boundaries such as side pipe outflow ,barrage, slice gate and drainage pump station.

主要工作如下：(1)根据三级解法建立了一维河网非恒定流模型，并提出了一种新的数据结构来描述和储存河网拓扑信息，方便了GIS平台和数值计算程序的衔接，实现了三级解法程序的通用性；从河段方程组出发，根据虚设河段法推导出了内边界条件的双追赶法公式，指明了虚设河段的追赶系数和非虚设河段追赶系数的关系，从而使模型可以模拟集中旁侧入流、堰、闸、水泵等内边界对行洪过程的影响。

ZSM two-drum pulse low net work of the screen, pulp pressure from the top of the screen to cut into the screen, the two fall in the middle drum sieve, sieve in the drum inside and outside of the pressure difference and the dual-rotor rotary-wing together, qualified fiber Through the inside and outside the drum screen after screen to the body at the bottom of the pool, and then by the good plasma discharge tube machine, the screen remained in the dark between the flow of rough slurry residue by the rotor and driven together to drum sieve under the tailings from the slot after the Slag discharge pipe.

ZSM双鼓式低脉冲网前筛工作时，纸浆从压力筛的上部切向进入筛体，流到两个筛鼓中间，在筛鼓内外的压力差及双旋翼转子的共同作用下，合格纤维通过内、外筛鼓后汇集到筛体底部，然后经良浆管排出机外，留在筛鼓之间的粗渣受到浆流和旋翼的推动，汇聚到筛鼓下的尾渣槽后从排渣管排出。

In dry weather,the sewage f1ow of any community is generally equal to the water quantity it uses(dry-weather flow)plus any water that leaks into the sewers from the ground and minus any sewage that leaks out from the sewers.

气候干燥时，一个居民区的污水流量通常相等于该居民区的用水量，加上从土地渗漏到污水管内的水量，再减去从污水管中漏出的污水量。

In dry weather,the sewage f1ow of any community is generally equal to the water quantity it uses(dry-weather flow)plus any water that leaks into the sewer s from the ground and minus any sewage that leaks out from the sewer s.

气候干燥时，一个居民区的污水流量通常相等于该居民区的用水量，加上从土地渗漏到污水管内的水量，再减去从污水管中漏出的污水量。

A safety level-based evacuation scheme of subway station is presented in this paper, with performance-based evacuation design combined. According to the evacuation characteristics of subway station, accidental evacuation time and available safety evacuation time under smoke control have been classified into three safety levels respectively. Then four safety levels have been proposed based on them. A flow chart of safety evacuation scheme of subway station under fire was then proposed based on the guidelines of safety evacuation and code for design of metro.

针对地铁车站人员疏散特点，以人员安全疏散准则和现行地铁设计规范为基础，融合了火灾安全工程学的性能化人员疏散设计思路，分别将事故疏散时间和烟控可用安全疏散时间划分为三个等级，综合形成了四类人员疏散安全等级标准，并在此基础上提出了框架性的基于安全等级的地铁车站火灾人员安全疏散方案设计流程。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐