查询词典 flat surface

A surface that can be unfolded or unrolled into a flat plane or sheet without stretching, tearing or shrinking is called a 'developable surface'.

一个可以在没有拉伸、撕裂或收缩的情况下展开为一个平面或平面区域的面，被称为可展面。

9 Unless otherwise specified, the nozzle gasket surface shall be flat smooth surface and serration specified in ANSI standard is not to provide.

除非另有规定，设备口垫片表面应光滑平整， ANSI 标准规定的锯齿形不能使用。

Besides transporting some amount of water and sediment shoreward, the influence of flood front on tidal flat, reworking surface sediments and disturbing or even interrupting consolidation of surface sediments, might last until the very end of ebb or even several following tides.

除一定数量的水沙向岸输移外，通过扰动滩面沉积物而影响甚至中断其固结过程，潮锋作用的影响可延伸至落潮的最后时段，甚至是以后潮次的潮流过程。

Wooden floor installation checks and accept a standard: Material should accord with resident requirement and active product standard; The floor is installed should firm, breathed noise, without become loose; Wooden floor surface should plane burnishs, wait for a phenomenon without broken bits of dig mark, dig and burr, the floor of besmear varnish its design should clear; Juncture of floor spelling a flower is answered neat, aperture width is consistent, the surface is clean, without excessive glue phenomenon; Skirting board and floor connection are close; The edge on skirting board is flat, differ high endlong should not be more than ± 3 millimeter and metope are clingy, without aperture.

木制地板安装验收标准：材料应符合住户要求及现行产品标准；地板安装应牢固、无声响，无松动；木地板表面应刨平磨光，无刨痕、刨渣和毛刺等现象，涂清漆的地板其图案应清晰；拼花地板接缝应对齐，缝隙宽度一致，表面洁净，无溢胶现象；踢脚板与地板连接紧密；踢脚板上沿平直，全长高差应不大于±3毫米与墙面紧贴，无缝隙。

The main structure carriage includes a upper frame and a subjacent frame whose one side on the upper surface and the subjacent surface is flat, a primary pin allocation connection device and driving shaft assembling device.

该车的主体结构车架包括上表面或下表面中至少有一侧为平面的上架及下架、主销定位连接装置和驱动轴安装装置。

However, for the surface nitrided with the closed N2 cell shutter, after nitridation process at 500℃, the(3 × 3) RHEED pattern was observed and the surface still kept atomically flat.

但是，在关闭N2发生器挡板的情况下，在500℃下，经过氮化将观察到(3×3)再构的RHEED花样，表面仍保持原子级的平整度。

Culms rigid, branched at base and covered with leathery yellowish sheaths, 80–100 cm tall, ca. 7 mm in diam. Leaf sheaths glabrous; leaf blades flat or inrolled, tough, 18–30 × 0.4–1 cm, adaxial surface and margins scabrid, abaxial surface rather smooth, apex long acuminate; ligule ca. 0.3 mm. Inflorescence 20–60 × 2–3 cm; racemes ascending or spreading, crowded or spaced, 0.5–3.5 cm; main axis and rachis hispidulous.

秆硬质，在基部分枝并且为所覆盖的革质淡黄鞘，厘米高，无毛的直径约7毫米叶鞘；叶片平或内卷，坚韧， 18-30 * 0.4-1 厘米，正面和给镶边，背面相当清除，先端长渐尖；大约0.3毫米开花的叶舌 20-60 * 2-3 厘米；总状花序上升的或开展，密集的或隔开，0.5-3.5厘米；主轴和轴具短硬毛。

Leaf sheaths glabrous, pilose at mouth (hairs ca. 2 mm), tightly overlapping; leaf blades gray-green, involute or rarely flat, 4–18 cm, abaxial surface smooth, adaxial surface scabrid.

在嘴(毛约2毫米)无毛，具柔毛的叶鞘，紧紧地重叠；叶片灰绿色，平的内卷或很少，4-18厘米，背面平滑，正面。

Leaves glossy deep green adaxially, narrowly linear-lanceolate, straight or slightly falcate, 0.8-6.5(-7) cm × 1.5-5 mm, midvein green abaxially, 0.3-1.2 mm wide, flat with median longitudinal keel throughout, stomatal bands present on both surfaces, bands on adaxial surface 0.5-1.5 mm wide, of 7-28 rows of stomatal, white powdery or not, bands on abaxial surface 1.2-2.8 mm apart, 0.3-0.8(-1) mm from leaf margin, not or rarely white powdery, base decurrent, margin denticulate, sometimes indistinctly so, especially on old trees, with 18-55(-90) teeth per side, apex usually symmetric and spinescent, spine 0.3-2 mm. Pollen cone fascicles terminal, 1-3(-5) together, broadly obovoid, each of 8-20 cones, occasionally a few also around base of seed cone; peduncle 2-4 mm; cones narrowly oblong-conical.

正面的叶有光泽的深绿色，披针形狭线形，直的或稍镰刀形， 0.8-6.5(-7)厘米×1.5-5毫米，中脉绿色背面，全部的0.3-1.2毫米宽，平的具中间的纵向的脊，气孔带宿存在两面，在正面0.5-1.5毫米宽上条纹状，7-28排stomatal的，与否白色粉状，相隔1.2-2.8毫米的条纹状的在背面，从叶缘的0.3-0.8(-1)毫米，白色敷粉的或很少的不，基部下延，边缘具小齿，有时不清楚如此，特别是在古树上，具18-55(-90)齿每边，先端通常对称和具刺，刺0.3个-2毫米雄球花束簇终端，花序梗2-4毫米；圆锥形孢子叶球狭长圆形。

An experimental heat-transfer system as well as a data reduction procedure was established in this study on the basis of the fundamental theory of liquid crystal thermography with heating at the solid surface. The system was tested by using both the steady-state and the transient methods with single-step heating at the surface. Two problems considered in the test were the flow over a flat plat with an unheated starting length and a uniformly heated cylinder in the cross flow.

本研究基於对固体表面加热之液晶热像法的基本，建一套热传实验系统与据约化程序，并采用稳态实验方法与对固体表面单步级加热之暂态实验方法，以具有前端未加热长的平板，以及绕越长圆柱之横向进实验。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。