查询词典 flange joint

When connecting rubber joint and pipe flange,the bolt pole shall extend to the pipe flange so as to prevent from crushing or pricking the coved screw thread expanding because of pressure, all bolts shall be pressured and screwed down and word congruously, If the surrounding circumstance is bad,spring washer and flat gasket shall be added to prevent bolts from loosing .

4，若使用拱形或高弧度橡胶接头时，（因螺栓六角难以穿过法兰孔），必须采用双头螺栓，并尽量减少球体端螺纹突出部分，以免球体受压膨胀时被挤伤，使橡胶接头早期损坏。

All expansion joints shall have bolted flange-to-flange type connections on both sides of expansion joint for removal of complete unit.

所有的伸缩接头都应当采用法兰栓接。

In order for the flange joint to maintain a gasket seal, it requires dynamic loading.

在为了使法兰接头，以维持一个垫片密封，它需要动态加载。

A three-dimensional mechanical model and a heat transfer model of bolted flange joint were built.

建立了螺栓法兰联接的三维力学及传热学模型，在考虑垫片非线性基础上，研究了法兰的瞬态温度场分布以及温度场的变化，对垫片和螺栓载荷的影响。

Flange joint with high intensity bolt,its bolt screw is not tighten match.

法兰采用高强度螺栓连接，其螺孔不是紧配合的。

The simplification of the flange joint is verified by the test and a simple and reasonable approach to one dimension modeling for the muffler with complex topology structure is provided.

本文建立了基于梁单元的排气系统一维数值模型，给出了排气组件的建模方法，特别对法兰接头的简化进行了实验验证，对具有复杂拓扑结构的消声器的一维简化提供了简单实用的建模方法。

The lagging is terminated 75mm either side of each flange joint and separate lagging with removable aluminium covers are used over the flanges.

保温层离两端法兰各 75mm，分开的保温层及法兰都用可动的铝蒙皮覆盖住。

And a gasket, matching the elastomeric valve seals, is installed in the bottom flange joint, regardless of attached valve type, in order to seal external fluid from the housing interior.

为了密封外壳，使得流体不会从外壳内泄露出来，需要一个与阀门弹性密封相配的垫圈，安装在底部法兰连接件里，而无论所连接的阀门是什么类型。

With this model, the deformation and stress distributions of the flange joint are analyzed using ANSYS FEM software, and the influences of gasket properties, tube side pressure and shell side pressure, bolt pr.

本论文以U形管换热器法兰夹管板接头为研究对象，考虑垫片材料压缩的非线性特性和压缩-回弹时的时滞效应，将法兰接头各元件看成一个系统，研究各元件的相互作用，建立了管板-法兰-垫片-螺栓连接系统的非线性三维有限元分析模型。

11 Dryer Process Ducting 干燥机管道 5.11.1 Leak tightness of joints can be assessed visually, without removing the flange joint cladding, by the presence and witness of brown discoloration.

在不移走接口法兰的覆盖层的情况下，通过褐色的污迹的存在，可以证明应接口的松懈而造成了泄漏。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。