查询词典 flame-out

OpenGL three flame effect, can control the intensity and location of the flame, with C source code.

OpenGL 实现的三种火焰效果，可以控制火焰强度及位置，含C++源码。

His hatred of you burns with a lurid flame -the flame that never dies.

他对你的仇恨象熊熊燃烧的火焰--永不熄灭的火焰。

Flame observation: If it shown yellow in flame cone, blue around, and the opposite wall could be seen through peep hole, that means the blending ratio of air and coal gas is ok. If air excess, it shown sky blue, bright, and the wall of combustion chamber could be seen clearly but dulling. If coal gas excess, it shown dark red, muddiness, and the wall of combustion chamber could be seen hardly.

1火焰观察：从窥视孔观察燃烧室火焰，如果火焰中心呈黄色，四周微蓝，透明，清晰可见燃烧室对面砖墙，则为空气煤气配比合适；如果空气量过多，则呈天蓝色，明亮耀眼，燃烧室砖墙清晰可见，但发暗；如果煤气量过多，则呈暗红，混浊不清，难见燃烧室砖墙。

By analyzing on the flame resistance and testing, the structure and component of the material of biology and chemical protective clothing for firefighters are confirmed when it has mustard gas resistance and flame resistance.

本文通过对材料阻燃理论的分析和阻燃试验，确定了兼具抗芥子气渗透性能和阻燃性能时，消防员防生化服装面料的组成和结构。

The microstructure of the coating and the mechanism of the wear resistance were analyzed. Compared with the coating using oxyacetylene flame process, results showed that the wear resistance of coating prepared by plasma spray welding process is higher than that of the coating using oxyacetylene flame process.

进而对涂层的微观组织和耐磨机理进行了分析和研究，并且与氧乙炔火焰喷焊技术所制备的涂层进行了对比测试分析，结果表明，利用等离子喷焊技术所制备的超厚涂层耐磨性能更为出色。

In recent years, cutting the development and application of technology has been developed by leaps and bounds, cutting technology has shifted from the traditional oxyacetylene flame cutting into the development of new industrial gas flame cutting, plasma arc cutting, laser cutting, water jet cutting, and other energy sources, a variety of Methods of modern technology, cutting technology, modern control technology at the same time again and cutting technology to combine research and development of a new generation of automated cutting machines.

近年来，切割技术的开发和应用取得了长足的发展，切割技术已经从传统的氧乙炔火焰切割发展成为新型工业燃气火焰切割、等离子弧切割、激光切割、水射流切割等多能源、多种工艺方法在内的现代化切割技术，与此同时又将现代化控制技术与切割技术想结合，研究开发出新一代的全自动切割设备。

Although the total calorific value of oxypropane flame is higher than that of oxyacetylene flame, its first calorific value is lower,so its burning temperature is lower and its heating time is longer.

氧丙烷焰比氧乙炔焰的总热值高，但一次热值低，因此燃烧温度低，预热时间较长。

The surface heat processing man method has the flame hardening and induction heating the heat treatment, the commonly used heat source has oxyacetylene or flame, the induced current, the laser and the electron beam and so on oxygen propane and so on.

在渗入元素后再进行其它热处理工艺，比如淬火和回火。化学热处理的主要有渗碳、渗氮、渗金属的方法。

It is studied the synthetic conditions of phosphoryl amic type P-N intumescent flame retardant from bisphenol A and phosphorus oxychloride and melamine. And the fire retardance of P-N intumescent flame retardant on poplar wood were studied by thermogravimetric analysis and burning test.

研究了以双酚A、三氯氧磷和三聚氰胺为原料合成磷酰胺类磷氮系膨胀型阻燃剂的反应条件，并用热重分析和灼烧实验方法初步研究了它对杨木粉的阻燃特性。

First is enhances the boiler the heat energy transfer rate,(1) changes the vertical chimney to the horizontal-type chimney, reduces the speed of flow, Increase the time which the actuating medium and the boiler hot flame doing heat change;(2) changes the high temperature system sole medium sole heat transfer area to many kinds of medium the multi-channel heat transfer area(2-6 medium, 2-6 heat transfer area, this article takes four medium, 4 heat transfer areas confer elaboration), the increase heat transfer flow path through many times heat absorption,Lets the pot furnace coal flame heat energy as far as possible much transmit gives the actuating medium, Enables the quantity transfer rate from the present 60%--75% enhances to is bigger than 95

第一是提高锅炉的热能转移率，（1）将立式烟囱改为卧式烟囱，降低流速，增加工作介质与锅炉热焰气的热交换时间；（2）将高温系统单一介质的单一换热区改为多种介质的多道换热区（2—6种介质， 2—6道换热区，本文取四种介质，4道换热区加予论述），增加换热流程，通过多次吸热，让工作介质尽可能多地把锅炉煤焰气的热能传递给工作介质，使能量转移率从现在的60%--75%提高到大于95

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。