查询词典 fixed point method

Fixed buck Saver, saving money is not festival, lights shorten the life span of lights for the high costs and engineering fees: a fixed step-down energy-saving products Product, if the fixed descending 5V, power-saving rate is too low, fixed down 10V, energy-saving rate not high, if the lights on down 20V, turn on the lights when there are many lights do not stand up.

固定降压节电器，节电不节钱，灯具寿命缩短，换灯成本和工程费高：固定降压产品节能产品，如果固定降5V ，节电率太低，固定降10V ，节电率也不高，如果开灯就降20V ，开灯时就有许多灯亮不起来。

Definition of package and packaging Regarding the definition of the term 'package', the components of a typical shipment for radioactive material could be basically classified as: radioactive material container body with lid and devices permanently fixed to it (e.g. trunnions, fixed inner structure to hold the content) inner equipment not permanently fixed to the container body (e.g. cans, inner containers) equipment outside the container body used during handling and transport but not permanently fixed to the container body (e.g. a transport frame) conveyance.

定义封装和包装关于这一术语的定义'包'，各组成部分的一个典型的货物的放射性物质可以基本上划分为：放射性物质集装箱的机构，盖子和设备永久固定给它（例如trunnions ，固定举行内部结构的内容）内的设备不会永久固定在集装箱机构设备以外的机构使用的集装箱装卸和运输过程，但不会永久固定在集装箱机构运输工具。

The enterprise should establish the complete fixed quantity system, including the product needed materials fixed quantity, a manufacture time allowance, low consumption fixed quantities and so on work clothes, tool, the maintenance cost fixed quantity and the part work quota and so on, and fulfils exactly the system of rating.

企业应建立完整的定额体系，包括产品用料定额，制造工时定额，工装、工具等低耗定额，维修成本定额及部分工作定额等，并严格执行定额制度。

Using the perspective drawing formation principle,this paper makes comprehensive elaboration of one-point perspective,two-point perspectives and three-point perspectives formation principle with the matrix representation method,and infers one essential method to these three kinds of perspectives formation principle which the perspective reverses,uses this essential method to reverse the picture's some characteristic point coordinates,then completes the reconstruction object's three-dimensional model with these characteristic point coordinates and carries on the confirmation using the surface,the body,these two kinds of fundamental elements as examples.

利用透视图的形成原理，对一点透视、两点透视和三点透视的形成原理用矩阵表示的方法作了全面的阐述，并对这三种透视的形成原理进行反推，推导出透视反求的一种基本方法，利用这种基本方法反求出图片的一些特征点的坐标，然后用这些特征点的坐标来完成重建物体的三维模型，并以图像中面、体两种基本元素为例进行了验证。

Firstly, this paper investigated roundly the basic theory of the ambient vibration method, analyzed systematically the main methods of ambient vibration identification, and discussed their advantages and disadvantages. Then we established the finite element model of structural dynamics and test model and analyzed their mutual relation, improved MUSIC method and correlation function method in the harmonic identification, and gave the subspace method and correlation function method based on continuous model, which is multi-harmonic retrieve technique. And then, this paper also puts forward least-squares method to estimate directly structural physical and modal parameters; this approach replaced the derivative operator in the continuous time model with an equivalent approximation, and estimated the physical parameters of structures by the least-squares method. And then, we discussed the approximation methods of derivative and their convergence. Finally, this paper researched the modal parameters of a frame structure by the simulation and test. The results demonstrated that subspace method, correlation function method and the least-squares method are effective and stable respectively.

全面地研究环境振动识别方法的基本理论，系统地分析环境振动识别方法的主要方法，讨论它们的优点和不足；建立结(来源：6666AB44C论文网www.abclunwen.com)构动力学的有限元模型和试验模型，分析有限元模型与试验模型之间的相互关系；改进谐波识别中的MUSIC识别方法和相关函数识别方法，给出大型结构模态识别的连续型的子空间分解识别方法和相关函数识别方法，这个方法是多元谐波识别方法；提出直接识别结构的物理参数和模态参数的最小二乘方法，这个方法利用导数的近似值代替导数值，并运用最小二乘方法识别结构的物理参数，讨论导数近似值的选择方法，分析算法的收敛性；通过仿真计算和模型实验，研究高层框架结构的模态参数识别，验证子空间分解识别方法、相关函数识别方法和最小二乘识别方法的有效性，算法的稳定性；从理论和试验两个方面分析和研究噪声对识别精度的影响，影响识别精度的因素，以及部分模态成分的模态参数不能够被识别的原因。

The revised Hargraves formula has the best result compared with Penman-Monteith formula, the average relative error is 6%, moreover, Hargaves method requiring the least data in calculating ETo, so this method has the high actual application value; The following are Radiation method and Blaney-Criddle method ; The worst is the Pan method, even after revised, the highest and average relative error is 36% and 10%, respectively. So, in this study, Penman-Monteith method, Radiation method, Blaney-Criddle method and Hargraves method are used except Pan method.

在这四种方法中，修正后的Hargraves方法与彭曼—蒙特斯方法的计算结果符合最好，其平均相对误差为6％，而Hargraves方法需要的气象数据只有计算时段的最高、最低温度，该方法具有较高的实际应用价值；辐射方法和布兰尼—克里德尔方法次之；蒸发皿方法最差，即使在修正后，E601型蒸发皿的最大误差也高达36％，平均为10％，所以在预报系统的研究设计中采用了除蒸发皿方法之外的四种方法。

According to the principle of the diameter of a circle corresponding to the right angle and the principle of short side for little angle in right triangle, projecting the initially-chosen point to the hyper-planes of the linear equation group in which every linear equation can be regarded as a hyper-plane and the projection points can be obtained. The initially-chosen point, and one arbitrary projection point, and the solution point are all on the surface of the relative hyper-geometry ball, therein-to, there is a projection point which is nearest to the solution point and it can be regarded as the next iterative initially-chosen point, so the solution problem of the linear equation group can be changed as an iterative problem of approaching the solution on the surface of a hyper-geometry ball.

根据直径对应的圆周角足直角以及直角三角形中短边对小角的原理进一步知道，当将初始点向线性方程组中各个方程所代表的超平面上投影得到投影点时，初始点和其任何一个投影点及方程组的解点都将位于一个相应的超球面上，其中必定存在一个投影点离问题解点的距离最短，即把该点作为下一次迭代的初始点，从而可将线性方程组求解的问题变成球面上逼近解点的迭代问题。

Thence in a southeasterly direction to Corner Point No. CP14 (X = 484 330, Y = 683 415); thence in a. northeasterly direction to Corner Point No. CP15 (X = 484 390, Y = 683 490); thence in a southeasterly direction to Corner Point No. CP16 (X = 484 415, Y = 683 470); thence in a southwesterly direction to Corner Point No. CP17 (X = 484 355, Y = 683 395); thence in a southeasterly direction to Corner Point No. CP18 (X = 484 430, Y = 683 335); thence in a southeasterly direction to Corner Point No. CP1, the point of beginning.

从该点起向东南延伸至隅角点CP14（X = 484 330，Y = 683 415）；从该点起向东北延伸至隅角点CP15（X = 484 390，Y = 683 490）；从该点起向东南延伸至隅角点CP16（X = 484 415，Y = 683 470）；从该点起向西南延伸至隅角点CP17（X = 484 355，Y = 683 395）；从该点起向东南延伸至隅角点CP18（X = 484 430，Y = 683 335）；从该点起向东南延伸至隅角点CP1。

This method is based on the work of reference [1]. By using the Riesz present theory in Hilbert space, we first transform the iterative procedure of variational inequalities into a fixed point form. Then, using the Schauder fixed point theory, we construct a numerical verification method with high efficiency that through numerical computation generates a bounded, closed, convex set in which the approximate solution is included.

通过Hilbert空间中的Riesz表示定理，首先将变分不等式问题的迭代过程转化为一种不动点形式，再利用Schauder不动点定理构造了一个高效率的数值证明过程，即通过数值计算产生一个包含近似解的有界闭凸子集。

B:Oocytes and early embryos were permeated in 0.5%Triton X-100 for 10 minutes,then fixed in 4% paraformaldehyde/PBS.Method C:Oocytes and early embryos were fixed in 1%PFA while permeated in 0.2%Triton X-100 at the same time for 1 hour.Method D: Oocytes and early embryos were fixed in precooled methanol(-20℃) for 15 min,then permeated in 0.5%Triton X-100 for 10 minutes.

方案A：先用4%多聚甲醛固定1h，再用0.5%Triton X-100穿透10min；方案B：先用0.5%Triton X-100穿透10min，再用4%PFA固定1h；方案C：用1%PFA+0.2%Triton X-100同时固定与穿透1h；方案D：用-20℃预冷甲醇固定15min，再用0.5%Triton X-100孵育10min。

Through comparing with the results by simulation to study the effects of theprojectile"s final velocity, the angle of rotation and the ballistic trajectory"s migration withdifferent projectile"s rotating speeds, different target"s moving speeds and differentpenetration angles.

通过比较数值模拟的结果来研究不同弹头转速、目标速度、侵彻角对侵彻过程中弹头最终速度、翻转角度和弹道偏移的影响。

I love stationery and all the accoutrement of writing.

我爱文具以及所有的书写的工具装备。