查询词典 fixed load

For this reason, butterfly valve can only be used for load fixed occasions.

由于这一原因，蝶形阀只能用于负载固定不变的场合中。

On the fracture section, three strain gauges were put above the pins of groups fixed with external fixator. The gauges were recorded when the femurs were loaded vertically. Results (1) The compressive trabeculae and femoral calcar in the femoral neck region are the main load-bearing construction. The contract of the abductor muscle can protect the hip joint. When the model femur was abducted in small degree (10-30°), the stress improved gradually with the abductor angle. But adduction of the model will gradually decrease the stress in that area. When external violence was put on it, the main stress distribution was on the upper femur, which was in the middle and lower part of the femoral neck and between greater trochanter and lesser trochanter.

同时在④⑤两组又应用电阻应变片贴于断端间的三枚斯氏针上方以测定钢针上的应力与应变结果(1)股骨颈处的压力骨小梁和股骨距是重要的承载结构；载荷的传导主要通过压力骨小梁和股骨距由股骨颈区传至股骨干的中下1/3处；外展肌力的收缩对髋关节有一定的保护作用；在小角度外展实验中（10-30°）股骨颈区的应力递增，超过30°时股骨颈区的应力又逐渐减小，但在内收实验中随角度增大股骨颈处应力呈递减趋势；当外界暴力作用时，应力主要集中在股骨上段，即股骨颈中下段和大小转子处及其之间。

On conditions that sports technology come into being , keeping on adding load training will help improving sports technology. Further research declares that nerve connection which is set up by shaped action will be broken and new connection will be expended and differentiated till a new movement fixed after sports technology coming into being and sports intension overload. So sports technology is relative to a certain load training intension.

在运动负荷强度对运动技能形成的影响中，传统观念认为适宜的运动负荷强度有利于运动技能的形成，但是这里所指的运动技能的形成，实际上是建立在某一运动负荷强度下所形成的运动技能，当运动负荷强度超过原来已经适应的运动强度负荷时，已巩固了的运动技能动作所建立起的神经联系又被再次打破，产生新的泛化、分化直到建立新的动力定型。

Firstly, based on the Duhamel integral and dynamic reciprocity theorem, the generalized Duhamel integral expression is written to a point in the half infinity space under moving load. Secondly, the train load is considered as a series of centralized loads with fixed distance. The dynamic response expression of a point in frequency domain and frequencywavenumber domain are derived out through the Floquet transform and Fourier transform under a moving load, and then the dynamic response of a point is gotten ...

以Duhamel积分为基础，首先应用动力互等定理，得到了移动荷载作用下，半无限大弹性连续介质空间上任意点的动力响应的广义Duhamel积分表达式；然后将列车荷载简化考虑为一系列具有一定间距的集中荷载，采用Floquet变换、Fourier变换等方法，得到了一个集中移动荷载作用下任意拾振点ξ的动力响应在频域和频率波数域内的表达式，进而由叠加原理得到列车荷载作用下的动力响应解；最后，通过算例说明该算法的适用性。

This article describes the process and results of the bearing capacity test of the speed reducer of ZPL-350 trochoidal gears under fixed load.

本文介绍了ZPL—350变长线齿轮减速器在稳定负荷下进行承载能力试验的过程及结果。

According to normal condition, injured condition, repaired condition, repaired plus fixed device, injured plus fixed device in turn, between the tendinous sheath of extensor hallucis longus and lister tubercular, with the velocity 10mm/min the load is applied on the specimen. The translation changes from 0cm to 2.5cm during the test.

SPSS13.0统计分析软件分析在相同的位移情况下(1.5cm、2.0cm、2.5cm)，比较腕掌侧关节囊韧带复合体在上述五种情况下的负荷差别，了解腕关节掌侧关节囊韧带复合体在正常、损伤、修复及外固定支架对腕背伸稳定性的重要作用。

Results: Before the fixed bridge was applied, under vertical load, the high-stress region was near around the apical of periodontal ligament with mainly compressive stresses. Under oblique load, the high-stress region was near around the cervical of periodontal ligament with both tensile and compressive stresses. After the fixed prosthodontics, stress and strain distributions were similar with that when the fixed bridge was not applied. But the maximum stress, strain and displacement increased apparently. The stresses in exterior surface of periodontal ligament were larger than that of interior surface; this character of periodontal ligament under vertical load was more obvious than that under oblique load.

结果：固定桥修复前，垂直载荷下，基牙牙周膜的应力以压应力为主，应力集中在根尖；斜向载荷下，基牙牙周膜的应力主要是拉应力和压应力，应力集中在唇、舌颈缘；固定桥修复后，基牙牙周膜的应力和应变分布规律与修复前相似，但最大应力、应变值都明显增大；牙周膜内表面的应力大于牙周膜外表面；垂直载荷时，牙周膜内、外表面的应力差异更为显著。

The research results showed that (1) inelastic compressive behavior of the gusset plate was similar to a cantilever plate in compression load,(2) buckling strength was reasonably predicted based on an inelastic plate buckling equation and buckling coefficient, and (3) design guidelines of the gusset plate in compression were proposed with inclusions of edge stiffeners.

本研究结果显示：(1)含挫屈束制消能斜撑之接合板在受轴压作用下，将产生的挫屈模式为Fixed-Free、(2)接合板在Fixed-Free模式下之挫屈强度预测及(3)如何加劲接合板使其强度能达到降伏后之非弹性挫屈行为。

This thesis focuses on maximum-power-point-tracking algorithm applying for wind-turbine generator system. The system includes the serve-motor, induction generator, three-phase full bridge rectifier, buck converter and fixed load. This thesis uses traditional Current Perturbation Algorithm as well as Perturbation Stochastic Approximation Algorithm to implemented with Matlab/simlink and hardware to achieve the maximum power tracking.

本文针对风力发电系统提出最大功率追踪法则，整体系统架构包含了伺服马达、感应发电机、三相全桥式整流器、降压直流转换器和固定负载，并由传统电流型扰动观察法合并扰动近似演算法，进行Matlab/simlink 模拟与电路实作设计来完成最大功率追踪。

For the condition where both outlet states of cold plate are at superheated states, the mass flowrate for the fixed heating load is marginally higher than that of the smaller heating load, and the difference is insensitive to the rise of heating load. For this situation, the effect of accelerational pressure is negligible, and it is mainly attributed to two-phase/single-phase distribution pertaining to the effect of heating load.

若两冷板的出口均为过热状态下，固定热负载一端的流量会略多於施加瓦数较高的一端，且其差异量会随热负载不同而缓慢增加，在此一状况下，则加速度压降可以忽略不计，其原因在於单相／两相流在热负载下单相区与两相区所占的比重不同所致。

In the United States, chronic alcoholism and hepatitis C are the most common ones.

在美国，慢性酒精中毒，肝炎是最常见的。

If you have any questions, you can contact me anytime.

如果有任何问题，你可以随时联系我。