查询词典 fitting of a curve

For drawing the parameter curve by point to point it orde to the parameter t's step length of increased make the progress range of the curve can not large than the length of one pels, otherwise the curve may step over one middle pels and skip one point that it should be on the curve.

要逐点地生成参数曲线，就要求参数t每次增加的步长要使曲线前进的幅度不得超过一个象素长度，否则有可能跨过一个中间象素而产生断点。

Based on the example of turbine reverse engineering , the general procedure that can be used to translate the physical object into CAD datum by Surfacer software is determined in this paper1 By going deep into the vector of point-cloud , it's parametrization can be gained by adopting the precept of accumulating chordal parametrization1 According to the principle of const ructing curve using the least square method , the high quality-curve can be gained by modifying curve's parameter1 This paper also empha2sizes on some methods about processing point-cloud , const ructing curve and const ructing surface1 And it can provide several methods to const ruct high quality2CAD model for mould machining1

此栏目为免费论文，可自行复制获取，如需要其他完整论文，可点击论文范文查找摘要本文就涡轮反求造型的实例，采用Surfacer 软件规划出由实物转化为工程CAD 资料的一般流程。在深入分析点云数据的矢量方向基础上，采用积累弦长参数化方案实现点云的参数化；根据最小二乘法曲线拟合原理，修改曲线参数获得高品质曲线；并重点论述了点云处理、曲线生成、建构曲面的方法，为模具加工提供了建构高品质CAD 模型的有效途径。

The horizontal and vertical first derivatives of magnetic anomalies of an infinite cylinder are calculated by the cosine transform method, in which the maximum errors are -0.28 nT/m and 0.47nT/m, respectively and the percent errors are generally within -3.57%~3.27% and -1.94%~1.88%, respectively except several data of the boundary and part are bigger because of remains of Gibbus effect. The calculating curve and theoretical curve are approximately coincident, and there is no influence by effective magnetic dip angle in computing. But the errors with the Fourier transform method are -10.62nT/m and 14.42nT/m, there is large departure between the calculating curve and theoretical curve and evident influence by effective magnetic dip angle in computing.

利用余弦变换法计算的无限长水平圆柱体磁异常水平和垂向一阶导数的最大误差分别为-0.28nT/m、0.47nT/m；水平一阶导数的误差一般在-3.57%~3.27%之间，垂向一阶导数的误差一般在-1.94%~1.88%之间；计算的磁异常一阶导数值与理论值大致重合，而且不受有效磁化倾角的影响而Fourier变换法计算的水平和垂向一阶导数最大误差分别为-10.62nT/m、14.42nT/m，计算曲线与理论曲线偏离大，受磁化倾角的影响也较大。

Results: The renal perfusion was increased in diabetes group after the injection of alloxan. The PSI, AUC and ascending slope rate of the curve of the time-intensity curve were increased in 1w and 2w with decreased of HPT; the pathological examination exhibited glomeruli hypertrophy and no thickening of basal lamina. The PSI and AUC in 4w and 6w were more than that of control group; the PIT and ascending slope rate of the curve got closed to normal in 4w and 6w; the intercapillary cells increased. The speed of ascending slope rate of the curve in 8w, 10w and 12w was slower, shown as PIT and HPT delayed; the pathological examination showned increasing of mesangial cell, hyperplasia of mesangial matrix and thickening of basal lamina, followed with obliteration of partial micrangium, glomerular sclerosis and reduce of PSI in 12w.

结果：糖尿病组兔注射四氧嘧啶后肾皮质血流灌注增大，1周、2周表现为时间-强度曲线参数中峰值强度升高、曲线下面积增大、达峰时间缩短、曲线上升斜率升高，此时病理可见肾小球肥大，系膜基质正常，基底膜无增厚；4周、6周，峰值强度、曲线下面积高于对照组，达峰时间、曲线上升斜率接近正常，系膜细胞增多。8周、10周、12周，达峰时间延长、曲线上升斜率减慢、峰值强度减半时间延长，病理出现肾小球系膜细胞明显增多，系膜基质增生，基底膜增厚，至12周病理出现部分毛细血管管腔闭塞，肾小球节段性硬化，峰值强度测值减低。

Based on the theories of rheology, Non-Newtonian Fluid Mechanics, petroleum chemistry, crystallography and pipeline technology etc. and sampling Huabei crudes, experimental indexes and programmes are drew out, integrating the oil properties and parameter analysis; in terms of the macro analysis of continuum mechanics, substantial experiments are conducted with HAAKE RS600 rotational rheometer and the rheological equation as well as the viscosity-temperature equation are further developed with tested rhrogramme and viscosity-temperature curve, respectively. Beased on the researches on thixotropic mechanism and thixotropy fluid property, hysteresis loop curve, structure failure and viscosity build-up curve as well as shear stress decrement curve for one type oil are first present in this paper. According to the theoretical researches and testing results, a novel thixotropy equation with τ=τ_∞e~ pattern, which is of hi-accuracy, few parameter and simplicity, is developed. Considering the influence of various parameters on rheological behaviour, depressant adding condition is optimized and experimental evaluation on BEM-5P is conducted, which further unrip its mechanism on the Huabei crude. A corresponding viable pipe transportion programmel is also recommended.

本文基于原油流变学、非牛顿流体力学、石油化学、结晶学、原油管输工艺学等理论，以华北原油为研究对象，结合原油物性及实验影响因素分析，制定出实验研究的评价指标及实验方案；从连续介质力学宏观分析的角度，利用HAAKE RS600高端旋转流变仪开展了大量的室内实验，并运用微观研究方法，测定了油样的流变曲线和粘温曲线，建立了流变方程和粘温方程；通过对触变性机理和触变性流体特征的研究，首次对华北原油测定出滞回环曲线、结构破坏与恢复粘时曲线、剪切应力裂降过程曲线，并在理论研究和实验结果的基础之上，建立了能定量描述含蜡原油剪切应力裂降过程的新型三参数触变模式τ=τ_∞e~b/(t+c，该模型具有精度高、参数少、实验简便且适用性强的特点；通过对含蜡原油流变性的影响因素理论研究，开展了加剂条件优选及BEM-5P降凝剂室内评价实验，进一步揭示了降凝剂对华北原油作用机理，在此基础之上，提出了华北原油管输的可行性方案。

Based on the theories of rheology, Non-Newtonian Fluid Mechanics, petroleum chemistry, crystallography and pipeline technology etc. and sampling Huabei crudes, experimental indexes and programmes are drew out, integrating the oil properties and parameter analysis; in terms of the macro analysis of continuum mechanics, substantial experiments are conducted with HAAKE RS600 rotational rheometer and the rheological equation as well as the viscosity-temperature equation are further developed with tested rhrogramme and viscosity-temperature curve, respectively. Beased on the researches on thixotropic mechanism and thixotropy fluid property, hysteresis loop curve, structure failure and viscosity build-up curve as well as shear stress decrement curve for one type oil are first present in this paper. According to the theoretical researches and testing results, a novel thixotropy equationwith τ=τ_∞e~ pattern, which is of hi-accuracy, few parameter and simplicity, is developed.Considering the influence of various parameters on rheological behaviour, depressant adding condition is optimized and experimental evaluation on BEM-5P is conducted, which further unrip its mechanism on the Huabei crude. A corresponding viable pipe transportion programmel is also recommended.

本文基于原油流变学、非牛顿流体力学、石油化学、结晶学、原油管输工艺学等理论，以华北原油为研究对象，结合原油物性及实验影响因素分析，制定出实验研究的评价指标及实验方案；从连续介质力学宏观分析的角度，利用HAAKE RS600高端旋转流变仪开展了大量的室内实验，并运用微观研究方法，测定了油样的流变曲线和粘温曲线，建立了流变方程和粘温方程；通过对触变性机理和触变性流体特征的研究，首次对华北原油测定出滞回环曲线、结构破坏与恢复粘时曲线、剪切应力裂降过程曲线，并在理论研究和实验结果的基础之上，建立了能定量描述含蜡原油剪切应力裂降过程的新型三参数触变模式τ=τ_∞e~b/(t+c，该模型具有精度高、参数少、实验简便且适用性强的特点；通过对含蜡原油流变性的影响因素理论研究，开展了加剂条件优选及BEM-5P降凝剂室内评价实验，进一步揭示了降凝剂对华北原油作用机理，在此基础之上，提出了华北原油管输的可行性方案。

The results indicated that the lysing curve of host cells was consistent with the one step growth curve of cyanophage, thus it was more convenient to substitute measuring the lysing curve of host cells for the one step growth curve measurement of cyanophage.

近年来，随着浮游病毒的认识的深入，人们认识到浮游病毒对水体中初级生产力的影响是巨大的[1] ，其主要证据就是发现噬藻体在海洋蓝藻的种群控制上发挥着重要作用[2 ] 。

The second section analyzes the restraint conditions of establishing zero-coupon bond yield curve in China. In order to analyze the constraint conditions of establishing zero-coupon bond yield curve, we should firstly study the current situation and problems of Chinese bond market because the data estimating zero-coupon bond yield curve mainly come from bond market which can't be separated from the analysis of the development history of bond market. So the main content of this section includes the development history of bond market, the present problems of Chinese bond market and the restraint conditions of establishing zero-coupon bond yield curve in China.

第二节分析中国零息票债券收益率曲线构造的约束条件，由于估计零息票债券收益率曲线所需要的数据主要来自债券市场，这样，要研究零息票债券收益率曲线构造的约束条件，首先必须研究中国债券市场的现状和问题，而这一切又离不开对中国债券市场发展历史的分析，因此本节的内容包括中国债券市场发展的历史沿革、中国债券市场目前存在的主要问题和中国零息票债券收益率曲线构造的约束条件三个部分。

Unit 4: We introduce two methods of curve fitting, and then make use of them to extract body contour line, find the optimum fitting method.

第四部分：介绍了两种曲线拟合方法，接着利用它们分别对人体轮廓线进行提取，得出最佳的拟合方法。

Cubic spline function fitting is a good method in the curve fitting because it is characterized by very good subsection smoothness.

三次样条函数拟合是曲线拟合的一个公认的较好方法，它具有很好的分段光滑性。

As of Tuesday, Google's results were still censored in China.

截至周二，谷歌的搜索结果仍受中国审查。

In order to make the positive action increase and negative one decrease, the sub-forces of the social factors must be adjusted to form a centripetal force.

在这一过程中，人的主体性发挥是社会有机体健康发展的灵魂。