查询词典 first order reaction

The reaction mechanism between nickel ion and butynediols in the electroless plating process was analyzed. The results show that the change of BOZ concentration is a quasi first-order reaction, the change of the nickel ion concentration is related to the BOZ density, and this change belongs to a higher order reaction. The reaction rate equation was determined as dC/dt=-8.585×10^(-4)+1.188×10^(-4)t-4.64×10^(-6)t^2+5.8×10^(-8)t^3-2.3×10^(-11)t^4. The activation energy of this process decreases as temperature increases, and it decreases with the BOZ concentration as 64-423 mg/L, it increases with the BOZ concentration as 123~240 mg/L. The S value is positively correlated to temperature, when the temperature is 80℃, the reaction rate and S value are the largest; while when the temperature is above 80℃ and BOZ concentration is over 160 mg/L, S value and the reaction rate decrease gradually.

结果表明，镀液中BOZ浓度的变化是准一级反应，镍离子的浓度变化与BOZ的浓度有关，属多级反应，其反应速率方程为dC/dt=-8.585×10^(-4)+1.188×10^(-4)t-4.64×10^(-6)t^2+5.8×10^(-8)t^3-2.3×10^(-11)t^4，反应体系的活化能E随温度的升高而减少，随BOZ浓度的变化而变化：当BOZ浓度在64~123mg/L时，E线性减少；在123~240mg/L时E线性增加。S随温度的升高而增加，当温度达到80℃时S值最大，反应速度最大；当温度超过80℃，BOZ浓度大于160mg/L时，蝎的值逐渐减少，反应速度降低。

This article that focuses on the systematic and in-depth research in the current primal problem about abnormal burst pressure reservoir depress burst pressure has procured following main fruits:1 It forms the method which could obtain massive vertical static state mechanics parameters.2 In a foundation of acquisition of rock mechanics parameters,apply bent lamella that as mechanical model along with characteristic of actual geologic characteristics to analysis curvature for anticlinal strcture, get homologous tectonic stress value throug relation between the curvature and stress and different principal curvature in anticlinal structure,consequently set up laminational stress model for anticline reservoir. The block lamination for existed fracturing date has formed method of setting up mechanical model of lamination terrestrial stress by abtaining the block tectonic stress coefficients which are got by complex utilization test, laboratory test and fracturing date playback.3 Analysesing the main reason which lead to high burst pressure by considering the characteristic of reservoir geology,reservoir,and rock mechanics and reservoir damage,etc.Establishing burst pressure quantitative prediction model which provide gist for depressing construction risk and optimizing construction craft under the condition of open hole completion ,gun-perforated completion and damaged reservoir.4 Provding theoretical basis for interpreting acidification pretreatment which could depress busrt pressure by finding the relation between the influencing factors and rock machanics parameters and analysing the factors that have effect on rock mechanics parameters. Expounding the mechanism of reaction of mixed monomineral and acid from the angle of microcosmic element, evaluating quantitatively acid sensilility of different kinds of mineral effectively, and determing the first-order reaction dynamical equation of each mineral.5 Revealing rock mechanics property chage as a result of acid flooding in different condition by sandstone traumata experiment in different temperatures which combined with rock mechanics triaxial stress experiment.6 Associating damage mechanics with sandstone acidizing, established sandstone damage mechanics model in the foundation of the recognition on the rock mechanics parametric variation which is caused by acid-rock reaction in both macroscopic view and microscopic view ,also demonstrated those processes and quantitative estimated the acid busrt pressure to direct the site operation.

本文针对目前异常破裂压力储层降低破裂压力的主要问题展开较为系统和深入的研究，取得了以下主要成果：1形成了利用测井资料，结合室内岩芯测试结果，获取静动岩石力学参数的相关性特征，从而获得纵向上大量静态力学参数的方法。2在获取了岩石力学参数的此基础上，利用弯曲薄板作为力学模型，结合区块实际地质特征对背斜构造进行曲率分析，通过曲率与应力的关系，利用背斜构造不同部位的主曲率求得相应的构造应力值，从而建立起背斜储层的分层应力模型；对已有压裂资料的区块分层，形成了综合利用测试、室内实验、压裂资料反演获得该区块构造应力系数，建立起分层地应力的力学模型的方法。3综合考虑储层地质、油藏、岩石力学特性和储层伤害等因素，分析造成高破裂压力的主要原因，综合利用岩石力学、弹性力学等知识，建立了裸眼完井、射孔完井条件下以及储层受到伤害后的储层破裂压力定量预测模型，为降低施工风险和优化施工工艺提供了依据。4完成了物性、岩性影响岩石力学参数的因素分析，找出了各影响因素和岩石力学参数之间的关系，为从机理上解释酸化预处理降低破裂压力提供了理论基础；从微观元素的角度阐述了单矿物与酸反应的机理；并在此基础上，有效评价了各种矿物的酸敏感性，定量确定了岩石中各矿物的一级反应动力学方程。5完成了不同温度下的酸液类型、酸液浓度、注酸量等一系列砂岩损伤实验，结合岩石力学三轴应力实验，系统揭示了在不同条件下注酸而引起的岩石力学性质变化。6将损伤力学与砂岩酸化相结合，在宏观、微观两个方面认识酸岩反应引起岩石力学参数变化基础上，建立了砂岩损伤力学模型，并对其进行验证，在此基础上定量计算酸化后的破裂压力，有效指导现场施工

The experimental results show that the electrochemical synthesis process of sodium dichromate from sodium chromate presents zero order reaction kinetic characteristics, and the electrochemical synthesis process of chromic anhydride from sodium dichromate presents first order reaction kinetic characteristics.

铬酸钠电催化合成重铬酸钠反应表现为拟零级反应动力学特征，重铬酸钠电催化合成铬酸酐反应表现为拟一级反应动力学特征。

The experimental reaction kinetics data were represented by two models:(1) Pseudo-first order reaction mechanism incorporated with the zwitterion mechanism for CO2-AMP reaction mechanism.

而二氧化碳在混合醇胺水溶液之亨利常数、扩散系数将由氧化亚氮相似定律估算。

The result showed that the oxidation reaction of abietic acid is first-order reaction during the initial period but then isn't first-order reaction because of oxidant film.

实验结果表明，枞酸氧化反应动力学在初期阶段呈表观一级，后期受氧化膜影响不呈表观一级。

The optimal measuring conditions were investigated. The results indicated that the catalytic reaction to Pt and bromocresol purple was the first-order reaction. The apparent activation energy was 217.4kJ/mol and the maximum absorption wavelength of fading reaction was at 434 nm. The linear range of Pt was 0.16-4.0μg/L and the detection limit was 2.5×10^(-11)g/mL. Most of common ions had no interference with the determination, while ten multiples of Ru, Rh and Os had interference with the determination of Pt. Therefore.

选择了最佳测定条件，实验结果表明，催化反应对铂和溴甲酚紫为一级反应，反应的表观活化能为217.4kJ/mol，褪色反应的最大吸收波长为434nm，方法测定R哪的线性范围为0.16~4.0μg／L，检出限为2.5×10^(-11)g/mL，大多数常见离子不干扰测定，10倍以上的Ru，Rh和Os对测定有干扰，可在测定前分离除去。

The results demonstrated that the fractional conversion and reaction rate were rapidly increased in the initial curing reaction. The higher the curing temperature, the higher the fractional conversion and reaction rate was. With increasing of the curing temperature and time, the fractional conversion and reaction rate decreased and became constantly. The initial curing reaction was a first order reaction. The apparent activation energy and frequency factor of curing reaction used G- capryl ester was bigger than that of used G-oligomer.

结果表明：固化体系在研究的固化温度下，转化率和反应速率在固化反应初期增加快速，温度越高增加越快，随着固化时间的延长，这种变化逐渐变慢，并最终趋于恒定；初期固化反应为一级反应，反应初期的表观活化能和指前因子大小顺序为G-预聚体＞G-辛酯。

Kinetics analysis showed that the photochemical reaction kinetics of 4,4'-DI3B was pseudo-first order reaction in n-hexane solution, and the reaction was a process of debromination step by step.

动力学分析表明，4，4'-DBB在正己烷中的光化学反应为准一级反应，是一个逐步脱溴的反应过程。

The rational reaction mechanism of alkylation with PTC was proposed and the experiments show that the alkylation reaction is a pseudo first-order reaction.

由实验得到的反应动力学方程符合拟一级反应，提出了合理的反应机理。

The kinetics of transesterification of extracted oil was also studied. The experimental data could to be described by second-order reaction model for the initial stages of the transesterification and followed b first-order reaction and zero-order reaction model.

考察了大豆油脚浸出油酯交换反应的动力学，由实验数据绘制的动力学曲线呈现出酯交换反应在开始阶段为二级反应，并逐步转变为一级反应，反应后期为零级反应。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。