查询词典 finite

In this paper, based on the finite element method, a three-dimensional finite element model was selected to simulate performance of the self-tapping screw connections and the failure modes of the panel, considering material nonlinearity and changing-status nonlinearity.

本文运用有限单元法，建立三维实体有限元模型，考虑了材料非线性与接触非线性，对钢板－自攻螺钉连接的受力情况和破坏模式进行了细致研究。

Single factor experiments were done with the factors including the width of protrusion and the trolley's velocity, which showed that the surface frictional coefficient decreases with the width of protrusion increasing, and doesn't change with the trolley's velocity changing, which was consistent with the results of the orthogonal experiment. A theoretical model of the horizontal projection of a corrugated bionic surface's contact area was built, which showed that the contact area's horizontal projection decreases with width and interval increasing respectively and that the ratio of the contact area's horizontal projection and the vertical load decreases with the vertical load increasing. It indicated that the surface frictional coefficient decreases with the above three factors increasing respectively. Finite element modeling and analysis of interactions of a plate and soils was done using ANSYS, which showed that the plate frictional coefficient is little relative to soil elastic modulus and decreases with vertical surface pressure and that trolley's pull and vertical displacement of bionic surface's control pilot keep constant almost during the plate being pulled. Finite element modeling and analysis of interactions of a corrugated bionic surface and soils was done using ANSYS, which showed that surface frictional coefficient is little relative to soil elastic modulus and decreases with bionic surface's structural parameters and vertical pressure increasing. However, the three factors all didn't affect the surface frictional coefficient remarkably on the condition of 90% dependability. For the first time, bionic surfaces were applied to screw piles, which formed bionic screw piles, and the contrast experiments showed the bionic screw pile had certain resistance-decreasing effects.

建立了波纹型仿生曲面与土壤的接触面积的水平投影的理论模型，表明接触面积的水平投影A随着波纹型仿生曲面突起宽度、两相邻突起间距的增大而减小，接触面积的水平投影与波纹型仿生曲面表面垂直载荷之比随着波纹型仿生曲面表面垂直载荷的增大而减小，进而得出仿生曲面摩擦系数随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小；利用ANSYS软件对平板与土壤的相互作用进行了有限元建模与分析，表明平板摩擦系数与土壤弹性模量关系不大，而随着表面垂直载荷的增大而减小；平板牵引过程中台车牵引力和仿生曲面控制节点垂直方向位移基本保持不变；利用ANSYS软件对波纹型仿生曲面与土壤的相互作用进行了有限元建模与分析，表明波纹型仿生曲面系数在一定范围内基本不受土壤弹性模量的影响，随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小，但在可信度为90％的前提下，三个因素影响都不显著；首次将波纹型仿生曲面应用于与土壤作用方式以挤压为主的螺旋桩，形成仿生螺旋桩，并与普通螺旋桩进行了沉桩对比试验，表明波纹型仿生曲面应用于螺旋桩桩体表面具有明显的降阻作用。

Based on rolling technology of 2050 hot strip roughing mill group, a 3-D coupling thermal, mechanical and microstructural rigid-plastic finite element model had been developed by using nonlinear finite element method and physical metallurgy microstructural evolution models.

根据某厂2050热带钢粗轧机组轧制工艺，借助物理冶金组织演变模型，利用非线性有限元法开发了热连轧过程热、力、组织耦合三维刚塑性有限元模型。

This paper puts forward CS roof plate finite element model and its analyse method. The analysis result indicates that the finite element model and analyse method is appropriate and makes some analyse of the CS plates with different distributed steel.

本文提出了三步节能CS屋面板有限元模型建立以及分析方法，分析结果表明本文建立的有限元模型和采用的分析方法是合理的，并利用有限元方法对其他配筋形式的三步节能CS屋面板进行了分析。

S the rational finite element interpolates with the soultions of elasticity and formulates directly in the physical domain, it has superiority over the isoparametric finite element in clear physical meaning and accuracy.

bstract 由于理性有限元用弹性力学的解插值并且在物理域内直接列式，因而与等参元相比，具有物理意义明确和精度高的优点。

An equal cross-section blade was investigated and a finite element model was built parametrically. Geometrical parameters (such as length, width and thickness), material parameters (such as young's modulus and density) and speed of blade were considered as input random variables while the static frequencies and dynamic frequencies were output random variables. Combining the finite element method, response surface method and Monte Carlo method, the statistical properties and cumulative distribution functions of static frequencies and dynamic frequencies were obtained. Probability sensitivities analysis, which combined the slope of the gradient and the width of the scatter range of the random input variables, was applied to quantitatively evaluate the sensitivities of static frequencies and dynamic frequencies with respect to the random variables. The Scatter plots of structural responses with respect to the random input variables were illustrated how to adjust the values of the static frequencies and dynamic frequencies by changing input random variables.

文中以某试验台用汽轮机等直叶片为研究对象，考虑几何参数、材料参数和转速的随机性，通过有限元参数化建模，将确定性有限元方法、响应面方法和Monte-Carlo模拟法相结合，从而获得了叶片静频、动频的统计特性和累积分布函数；同时考虑随机变量的梯度和离散范围对静、动频的影响，通过概率敏感性分析，定量地判断出叶片静、动频对随机输入变量的敏感性；通过绘制叶片静、动频与输入变量的散点图，定量地分析了如何改变随机变量以调整静、动频率的方法。

In order to verify the accuracy of heat transfer coefficient,2D nonlinear finite element axisymmetric model is established by the means of finite element software MSC.Marc, which is utilized to simulate the transient temperature field coupled with phase transformation process and nonlinear synthetic surface heat transfer coefficient of several typical steels in the different quenchants.

Marc作为模拟平台，建立了淬火过程二维非线性有限元模型，模拟淬火过程中的瞬态温度场，在模拟过程中以多种常用钢在不同淬火介质中的非线性表面综合换热系数为边界条件，同时耦合了相变过程的影响。

In this paper, finite element method is used to analyze the sinusoidal buckling of drill-strings with connectors in straight well bore. Three kinds of beam elements, one of them is a newly established transition element, are adopted in the finite element model.

本文运用有限元法分析了直井中考虑接头与井壁接触时钻柱的正弦屈曲，有限元模型采用三种不同类型的梁单元，其中一种是新建立的过渡单元。

The three-dimensional finite element model of guided wave in the pipe was built by the finite element method.

利用有限元方法建立管道导波3-D模型，通过在管道中激励纵向超声波，模拟导波在管道中的传播形态。

Each clause contains one finite verb , so if we know the number of finite verb s we know the number of clauses

每个子句含有一个限定动词，所以如果我们知道限定动词的数目，我们就知道子句的数目。

Article 144 The Government of the Hong Kong Special Administrative Region shall maintain the policy previously practised in Hong Kong in respect of subventions for non-governmental organizations in fields such as education, medicine and health, culture, art, recreation, sports, social welfare and social

第一百四十四条香港特别行政区政府保持原在香港实行的对教育、医疗卫生、文化、艺术、康乐、体育、社会福利、社会工作等方面的民间团体机构的资助政策。原在香港各资助机构任职的人员均可根据原有制度继续受聘。

Small wonder, then, that the Chinese spend more in the shop than any other group of foreign visitors do .

这样的小惊喜，使中国顾客比任何国家的人消费得更多。