查询词典 finite measure

CFD-fluent simulation software and measurement are applied to establish the math models of exhaust gas concentration distribution and boundary conditions. Finite volume methods and PISO are used to solve the differential equations of exhaust gas distribution in a kitchen. After the adjustment and comparison with those from the practical measure, the simulation results of CO2 and CO concentration distributions accord with experimental ones.

运用CFD-fluent模拟软件和实测相结合的方法，建立废气的浓度和扩散分布的数学模型与边界条件，利用数值分析法中的有限体积法和PISO算法对厨房内废气分布的微分方程进行离散和求解，对模拟结果进行校正并与实际测试结果进行比较。

Because operating rigid frame bridges have chief diseases at present. A diseasing bridge is evaluated by using analytic hierarchy process and expert evaluation combined factor method at first, then the reinforcement measure is studied based on evaluation consequence, the calculation of internal force and deformation are carried Out by the finite element method, and the evaluation analysis of reinforcement effect is done by calculation result.

针对目前正在运营的刚架混凝土拱桥出现的主要病害，首先利用基于层次分析及专家评估的变权综合系数法对一实际病害桥梁结构进行了评估，然后根据评估结果对该桥的维修加固措施进行了研究；采用有限元方法对桥梁加固后的内力和变形进行了计算，并根据计算结果对该桥的加固效果进行了评估分析。

According to the property of EBB, scanning electron beam was considered as plane heat source instead of spot heat source in this paper. Aiming at the problems to measure the real-time temperature and residual stress of radiator difficultly at high temperature, the two-dimensional finite element models were established. Based on the thermal elastic-plasticity, the temperature fields and stress fields of EBB 6139T and 6204T radiator by two kinds of process were simulated by the software of ANSYS. It is of great value and significance to guide actual production.

本文根据电子束钎焊的特点，将电子束点热源转化为扫描加热时的面热源，针对散热器高温下温度实时测量和残余应力实测困难这一问题，建立了二维有限元模型，以热—弹塑性理论为基础，利用ANSYS软件对6139T和6204T散热器分别按两种电子束钎焊工艺钎焊的温度场和应力场进行了数值模拟，对于指导实际的生产具有重要的价值和意义。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。