查询词典 finite element method

For some shortcomings of unknown quantity numbers in finite element method, QR-method establishes a transformed relationship between a unit node displacement vector and the entire framework of spline node displacement vector,making the structure of the total stiffness matrix, damping matrix, mass matrix directly superimposed in no need of finite element method in the first expansion after the superposition process. So the method greatly simplifies the calculation process and improves computing speed.

针对有限单元法中未知量数目很多的缺点，QR法建立起单元结点位移向量与整个框架样条结点位移向量的转化关系，使得结构总刚度矩阵、阻尼矩阵、质量矩阵可以直接叠加，不需要有限单元法中先扩张后叠加的手续，大大简化了计算过程，提高计算速度。

At present the numerical simulation of electromagnetic method of finite difference method, finite element method, boundary element law, integral equation method, and so on were commonly used in the exploration.

目前电磁法勘探中常用的数值模拟方法主要有：有限差分法、有限单元法、边界单元法和积分方程法等。

The main contents include: Some preliminary theory (introduction to Sobolev spaces and variational formulations for differential equations); finite element methods for one-dimensional elliptic problems; the construction methods for general finite elements; error estimates for interpolation operators and inverse inequalities for finite element spaces; a priori and a posteriori error estimates for the finite element method for high-dimensional elliptic problems; some typical spectral methods for partial differential equations; error analysis for the spectral approximation for some linear and nonlinear partial differential equations.

主要内容有：准备知识（Sobolev空间的基本概念和主要结果，微分方程的变分描述）；一维椭圆型方程有限元方法；一般有限元的构造；插值算子误差估计和逆不等式；高维椭圆型方程的先验、后验误差估计；求解偏微分方程的几类谱方法；线性与非线性问题谱逼近的误差分析等。

Three moment method,the transition matrix method and finite element method in shipping shaft system alignment are used ,the application of finite element method in shipping shaft system alignment is proved to be more reasonable through an example .

并以某实船为例，利用三弯距法、迁移矩阵法和有限元法对船舶轴系进行校中计算，说明有限元法更先进合理。

The formulas derived show that FAM is more accurate and reasonable than finite difference method and finite element method , also, on the element partial differentiation of dynamic Reynolds equations with respect to circumferential and axial direction is directly obtained by finite analytic solution.

本文在详细分析目前流体润滑轴承层流、紊流润滑理论及轴承-转子系统稳定性理论的基础上，提出了将有限分析法用于计算动压、静压、动静压轴承的静特性和动特性系数，并推导了相应的计算公式。

In the numerical computation, a two-dimensional numerical method integrating finite element method and difference method was employed, where the finite element method is used to calculate the magnetic field of the permanent magnetic guideway and the difference method is used to calculate the induced current in the superconductor, then the levitation force and the lateral force were calculated by Lorentz formula.

在数值计算部分，实现了一种集有限元法与差分法为一体的数值计算方法。

Based on the virtual displacement principle of finite element method, a weak variation of GAO-YONG turbulence equations is put forward. The subroutine of the element and the integrated finite element code are generated by the finite element program generator successfully.

基于有限元方法中的虚位移原理，写出了不可压流Gao-Yong湍流方程组弱形式的微分方程表达式，利用有限元程序自动生成系统得到了全部有限元计算程序。

In theory, firstly, the numerical simulation methods, such as the boundary element method, the finite difference method and the finite element method, were utilized to calculate the distribution of electric field intensity and potential of the electron-gun system, the focusing system and the whole equipment, respectively. Then, the trajectories of the electron-beam were traced by using of the Runge-Kutta method and the Monte-Carlo method associatively. The point spread function was also calculated.

在理论分析中，先后采用边界元方法、差分方法、有限元方法等科学数值计算方法，编制程序，对X射线源的电子枪发射系统、聚焦系统以及发射系统与聚焦系统的组合系统等的电场分布进行了严格的计算，在准确求得各系统电场内各个剖分点的电场场强、偏导数等参量的基础上，采用蒙特-卡罗模拟方法和不等距龙格-库塔方法相结合，追踪由LaB_6单晶阴极表面发射出的大量电子束在电场内的运动轨迹，求出点扩展函数，并根据点扩展函数的优劣，反复调节、大量计算对比，挑选出X射线源最佳的电极结构及其组合。

In this paper, arrangement scheme of a novel multi-star phase shifted pole changing coil was given and the methods to determine coil split ratio were analyzed. According to electromagnetic theory, 2D electromagnetic mathematical model in which stator windings were spitted coil was developed, and magnetic field distribution of the novel motor at starting was solved by finite element method, starting performance of motor was calculated. Based on energy method, rotor slot leakage reactance under different poles and different loads were calculated, and the variation of rotor slot leakage reactance with loads was gotten. Based on time-step finite element method, distribution of branch current in stator windings and operating performance were calculated and analyzed when branch was unbalance, the method to calculate circulating loss in stator windings of novel multi-star phase shifted pole changing motor was given, and the effects of the loads variation and degree of unequilibrium on circulating loss in stator windings were calculated and analyzed.

论文系统的给出了采用分裂线圈法新型多星形移相变极绕组的排列方案，进一步分析线圈分裂比的确定方法；根据电磁场理论，建立了定子为分裂线圈绕组的电机二维电磁场数学模型，并采用场路耦合法求解了新型多星形移相变极电机起动时的磁场分布，计算了电机起动性能和基于能量法计算了不同极数下起动时转子槽漏抗和不同负载时转子槽漏抗，得出转子槽漏抗随负载变化的规律；采用时步有限元法计算分析了定子绕组支路不平衡时支路电流的分布情况及运行性能，给出了新型多星形移相变极电机定子绕组环流损耗的计算方法，分析比较了负载的变化和支路不平衡度大小对定子绕组环流损耗的影响。

With a 586 computer and ALGOR FEAS software of finite element method, the static stresses of the equalizing bar are obtained by finite element analysis for three finite element models of beam, plate and brick element.

在微机586和ALGOR FEAS有限元软件环境下，对推土机平衡梁以梁、板、块单元为主分别建立了三种有限元模型和进行了有限元应力分析。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。