查询词典 finite element method

The mesh model was then built in ALGOR, the finite element analysis software. Results The three dimensional finite element model was constructed on the computer, which had 47 155 nodes and 41 878 tetrahedrons elements.

结果：所构建的三维有限元模型具有良好的几何相似性，共有单元47 155个，节点数41 878个，可以按照不同的研究要求进行删除、旋转、切割和添加。

In this paper, design is first conducted for the bed of a CNC lathe and Pro/ENGINEER is employed for modeling, then Pro/MECHANICA is used for finite element analysis. It is shown by the result that measures like finite element analysis can be employed for optimization design, thereby avoiding the inherent structural defects and disadvantages.

本文首先对某数控机床的床身进行设计并利用Pro/ENGINEER建模，然后运用Pro/MECHANICA对其进行有限元分析，结果表明：有限元分析等手段可以进行最优化的设计，避免结构存在先天上的缺陷和不足。

New progresses in finite element analysis for telescopic box section hoist boom of truck cranes are summarized. Merits and defects of existing finite element methods arc analyzed.

总结汽车起重机箱形伸缩式吊臂有限元分析国内新进展，分析现有的有限元方法优缺点。

Considering the loading and boundary conditions of the model finite element calculation is carried out. Both for the working conditions of prestress and load, the finite element model of the box beam is approved to be suitable and correct by the actual test results.

考虑模型的载荷及约束进行有限元计算，在预应力和载荷两种工况下，利用实测结果论证了箱型梁的有限元分析模型是合适和准确的。

The finite element analysis model of pre-pressing contact of low carbon steel resistance spot welding un-der spherical electrode condition is created with the finite element software.

1前言电阻点焊是汽车制造领域中的主导加工工艺，每辆汽车上的电阻焊点平均为3000～5000个[1]，因此电阻点焊的质量很大程度上影响着汽车的质量。

First, the stretch tests of polyester samples were carried out according to the test methods required by the corresponding national standard, from which the coefficients for Mooney Rivlin equation were achieved; then the finite element models of the standard test samples and dust cap were established, and the nonlinear finite element software MSC-Marc was used to calculate the their stiffness.

首先，根据橡胶产品的国家标准进行标准试样的拉伸试验，由此得到有限元模型中材料模型的参数；然后，建立相应的标准试样和聚酯防尘罩产品的有限元模型，并通过非线性有限元软件MSC-Marc进行了计算，得到标准试样和聚酯防尘罩产品的刚度。

Earlier fatigue failure phenomenon of SOFIM engine connecting rod bolt is concentred.After a finite element model was established,a finite element analysis and a fatigue test were carried out.

针对SOFIM发动机连杆螺栓出现的早期疲劳断裂现象，建立了连杆螺栓的有限元模型，利用有限元方法进行了该连杆螺栓的疲劳寿命分析，并与疲劳试验进行了对比。

The revolution bellows is idealized as a series of conical frusta, joined at nodal circles. The linear finite element analysis equation and the geometrical nonlinear finite element analysis equation in Total Lagrangian Formulation for the revolution bellows are derived using stationary total potential principle.

考虑到油罐刚度比波纹管刚度大的多，将油罐看作为刚体，将波纹管部分和管道部分分别用空间梁单元离散化，通过分析得到波纹管与油罐连接接合面、波纹管与管道连接接合面不同单元之间的位移协调约束方程，并用罚函数法进行处理。

In this research, a 3-D hexahedral finite element model of left foot including bones, cartilages, and soft tissues was developed. Besides, three finite element models of footwear including flat insole, total contact insole, and flat insole combined heel pad were also built, respectively.

本研究建构一组包含骨骼、关节软骨与完整软组织之左足三维六面体有限元素模型，并分别建构平板式鞋内垫、全触式鞋内垫与平板式鞋内垫加上足跟垫之简易鞋具三维六面体有限元素模型。

The nonlinear finite element models are also used to analyze the hysteresis behavior of the joints under reversed cyclic loads using ANSYS 8.0. The influences of the stiffener length and the infilled concrete are analyzed. Analytical results show that the stiffener length and the infilled concrete are critical for the joints. Furthermore, the skeleton curves of the finite element models are in good agreement with those of experiments.

运用ANSYS8.0对各节点试件在低周反复荷载作用下的滞回性能进行非线性模拟计算，分析内填混凝土、加劲肋长度等因素对节点受力性能的影响，结果表明：内填混凝土和加劲肋长度对节点受力性能的影响较大，有限元所得的骨架曲线与实测曲线吻合较好。

Summary In copyright infringement cases,if the alleged infringer uses or even plagiarizes the copyrighted works or parts thereof,which causes no substantially adverse effect on the normal exploitation of the work,nor does it inflict any substantial damages to the right owner,the de minis doctrine should be applied to exempt the liabilities of the defendant and seek the balance of interests between the right owner and the general public embodied by the copyright law.

在侵犯著作权案件中，如果被控侵权行为人虽未经著作权人的同意，使用甚至抄袭了受著作权保护的作品或作品的片段，但若情节轻微，未对该作品的正常使用产生任何实质不利的影响，亦未对权利人的权利造成实质性的损害，则应适用&不计琐细原则&，免除行为人的责任，以寻求在权利人利益与著作权法所体现的社会公共利益之间的平衡。

This new product will become our best seller.

这个新产品会成为我们最畅销的产品。