查询词典 film show

The experiments show that TiO〓 nanowire arrays have higher photodecomposition efficiency than TiO〓 film. It is due to not only their higher surface area, but also their wider energy gap. 6. Ordered NiO nanowire arrays embedded in anodic alumina membranes have been prepared by using an electrochemical deposition method. Thermogravimetry curve shows that NiOH embedded in AAO decomposed slowly compared to thin film.

可能存在两个原因：氧化钛纳米丝具有比氧化钛纳米膜更大的比表面积；氧化钛纳米丝的光学带隙大于氧化钛纳米膜的，带宽的增加，使得价带电子电位变得更正，导带电位变得更负，这实际上增加了光生电子和空穴的氧化还原能力，提高了半导体光催化氧化有机物的活性。

Their electrochemical behaviors for single solute and mixed systems of hydroquinone(H2Q) and pyrocatechol are investigated.A pair of redox peak of H2Q and two pairs of redox peaks of PC on the composite film electrodes can be obviously distinguished in their mixed systems,which show the composite film electrodes have excellent electrocatalytic activity for two ...

结果表明聚苯胺复合膜电极具有很好的电催化作用，在混合体系中对苯二酚的一对氧化还原峰和邻苯二酚的两对氧化还原峰能够清楚地区分；并且在一定的浓度范围内单组分的浓度与峰电流呈良好的线性关系，说明该电极对苯二酚的测定在定性、定量中具有潜在的应用价值。

The results show that the antibacterial rate of the stoneware with TiO2 film on surface is 90% and 88% in UV light and sunlight respectively,both of them is higher than that of the stoneware without TiO2 film.

结果表明，在紫外光和日光下，表面负载了TiO2膜的炻器灭菌率分别为90％和88％，均高于未负载TiO2膜的炻器，且灭菌率随光强的增加而提高。

The results show that the dissolution of Ag was restrained by forming of a silver suboxide film on the surface under low oxidant concentration and atmospheric pressure conditions (e.g., in NH_3-O_2-H_2O system); when the concentration of oxidant was high enough (e.g., in NH_3-H_2O_2-H_2O system), the leaching process was carried out without forming of the film and the rate of dissolution of Ag was controlled by a step of mass transfer.

结果表明，在常压下氧化剂浓度低时(如在NH_3-O_2体系中)，浸取反应受在Ag表面上生成的氧化物膜所阻碍；而在浓度足够高的氧化剂时(如在NH_3-H_2O_2体系中)，浸取过程可在不生成氧化物膜的条件下进行，此时Ag的溶解速度受传质步骤控制。

Experiments show that the strain of the SiGe film in the window is significantly different from that of the film grown on an unpatterned area on the same substrate,the former of which depends not only on the size of the window but also on the stress of the mask material of the window.

实验表明，微区生长材料的这些特性，与同一衬底上无边界约束条件下生长的材料相比，有明显的不同。微米尺寸窗口中生长的SiGe/Si材料的应变与窗口尺寸有关，也和窗口的掩膜中的内应力有关。

The results show that the hydrophilicity of PLA film is improved by introduction amido: the contact angle decreases from 78° to 56° and the free energy increases from 42.7mJ/m^2 to 51.4mJ/m^2. Compared with the control, osteoblast spread out more filopodia after 3 d incubation on amidation surface, and it entered cell division phase more quickly, which indicated that the surface amidation could promote the cell's adhesion and proliferation on the PLA film.

结果表明，酰胺基的引入改善了PLA膜的表面亲水性，其表面水接触角由78°减少到56°，自由能由42.7mJ/平方公尺增大到51.4mJ/平方公尺；与对照组相比，成骨细胞在改性表面培养3d后有大量的丝状伪足伸出，并且较快地进入了细胞分裂期，表明PLA膜表面的酰胺化能够促进细胞的黏附和增殖。

Appear principle teacher to make such explanatory normally to adding those who show film when film ply is incident light when the 1/4 that grows in filmy medium wave, going up filmily, the road path difference of the reflex below is equal to half wavelengh fitly, offset each other consequently.

对于增透膜的增透原理老师通常作这样的解释当薄膜的厚度是入射光在薄膜中波长的1/4时，在薄膜的上、下面的反射光的路程差恰好等于半个波长，因而相互抵消。

The result makes clear: EThe tensile strength of TFE film increases somewhat along with the addition of drawing speed, and rupture outspread rate reduces;ETFE to succumb filmily somewhat along with the addition of drawing speed the addition that intensity follows drawing rate and increase somewhat, but the 2nd succumb intensity increases not big;ETFE to succumb filmily meet an emergency follows drawing rate increase somewhat, the 2nd succumb the amount of tangent and stretch model that meet an emergency reduces;ETFE film somewhat and model of the 2nd flexibility measure those who follow drawing rate to increase show downtrend, quantity of secant flexibility model and quantity of the 3rd stretch model do not have apparent change.

结果表明：ETFE薄膜的抗拉强度随拉伸速度的增加略有增加，而断裂延伸率随拉伸速度的增加略有减小；ETFE薄膜的屈服强度随拉伸速度的增加而有所增加，但第二屈服强度增加不大；ETFE薄膜的屈服应变随拉伸速度的增加略有增加，第二屈服应变则略有减少；ETFE薄膜的切线弹性模量以及第二弹性模量随拉伸速度的增加呈下降趋向，割线弹性模量和第三弹性模量则没有明显的变化。

The results show that the toughness of over-heated zone increased greatly because of austenite film lying in lathy martensite and a few ferrite.The toughness of fine grained zone decreased due to many factors,such as acicular martensite,a small quantity of austenite film,carbide separation and so on.

结果表明，10Ni8CrMoV这一新型钢种的模拟焊接热影响区的过热区和细晶区表现出与绝大多数材料完全相反的规律，过热区存在少量的铁素体组织，马氏体板条束之间形成了一定量的奥氏体薄膜，这些韧度相的存在使得过热区的冲击韧度与基体相比有了较大的提高；细晶区部位奥氏体含量很少，细小的板条马氏体端部呈针状特征造成应力集中，易于诱发裂纹。

Calculations show that effects of film evaporation can be neglectable and the temperature field of liquid film can not be approximated to linear distribution.

数值计算结果确认了液膜蒸发量对换热系数的影响可以忽略，液膜内温度分布不能近似为线性分布。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。