查询词典 filling-in

Three types of subgrade filling material are selected to analyze the change rule of subgrade resilience modulus under different compaction. Meanwhile PFWD（portable falling wei-ght deflectometer） is combined to integrate this parameter with compaction of construction control index,which brings about the conversion relation between three subgrade filling material and compaction. It can provide reference for pavement design and construction.

选定三种不同类型的路基填料，分析在不同压实度条件下路基回弹模量的变化规律，并结合PFWD检测方法，将设计参数回弹模量与施工控制指标压实度联系起来，得出三种路基填料的回弹模量与压实度的转换关系，可为路面设计与施工提供合理的依据。

The combining ability of grain filling durationand grain filling ratein wheat were investigated by using 6×6 diallel crosses.

以6×6双列杂交的F1～F3及亲本为试材，对籽粒灌浆持续期和籽粒灌浆速率进行配合力分析。

It adopts imported photoelectric fiber switch and precision protractorto to realize no-bottle-no-filling fucation with simple structure and achieves no-bottle-no-filling fucation with a high pass rate.

采用进口的光电光钎开关和精准的分度器来控制无瓶不灌装，结构简单，无瓶不灌装动作实现率高。

The results shown that, for the typical kind of photonic crystal fibers with hexagonally arrayed circular air holes, the band gap of acoustic wave of XY mode appears only when the air holes' filling rate is greater than certain threshold value, and the upper and lower boundary values of the band gap decrease with the increasing of the air holes' filling rate.

结果表明，对于较为常见的空气孔排列为六角密排结构、空气孔形状为圆形的实芯光子晶体光纤，只有当空气孔的填充率大于一定阈值时才出现较明显的XY模态声波的带隙，并且最低与次低带隙的上下边界均随空气孔的填充率的增大而下降。

Twelve density treatments were designed, which were 225×10^4 (T1), 300×10^4 (T2), 375×10^4 (T3), 450×10^4 (T4), 525×10^4 (T5), 600×10^4 (T6), 675×10^4 (T7), 750×10^4 (T8), 825×10^4 (T9), 900×10^4 (T10), 975×10^4 (T11) and 1050×10^4 (T12) basic plants/hm^2. Grain dry matter growing process and grain filling rate could be described by Richards Model and Monodic Quadratic Equation, and the grain filling parameters could be calculated from Richards model fomula. Relation analysis, stepwise regression analysis and path analysis were made by DPS, SPSS software.

方法设计了225万(T1)、300万(T2)、375万(T3)、450万(T4)、525万(T5)、600万(T6)、675万(T7)、750万(T8)、825万(T9)、900万(T10)、975万(T11)、1050万(T12)基本苗／hm^2共12个密度处理，分别运用Richards模型、一元二次方程模拟了冬小麦籽粒干物质增长过程及籽粒灌浆速率随花后时间的变化情况，并对所建立的Richards模型进行推导得到基本的灌浆参数，通过SPSS、DPS软件对籽粒灌浆参数与千粒重进行相关、逐步回归及以及通径分析。

Liquid overfill shall be prevented by providing positive design and operation steps, such as two reliable and repairable level instruments and an independent high-level alarm that independently stop the filling operation by closing the filling valves.

通过积极的设计及操作步骤防止液体溢流，如安装一个可靠并可维修的液位仪表和一个独立的高液位报警装置（该高液位报警装置通过独立关闭注入阀而停止继续注入操作）。

I will take a mouth cast now, you will choose the color of the precast filling and you will have a temporary filling until next visit….

我将嘴演员，您会选择预制的颜色填充，你将有一个临时填补，直到下次访问。。。

Through orthogonal test method.taken maximum load as judging basis,the effect of mining steps,filling material rigidify and filling ratio on stpoe stability is studied by using RFPA numerical simulation.

通过正交试验方法，运用RFPA数值程序研究了不同开挖步骤、充填体刚度、充填接顶情况对铜陵有色金属公司冬瓜山矿床开挖稳定性的影响。

They are characterize by irregular and subangular with sandy filling or no filling,and some of them are jointable.

经研究，金顶矿区存在两种成因的角砾岩：构造-膏溶角砾岩和底辟-侵位角砾岩。

The filling process and filling pressure of thixotropic Al alloys and steel were simulated.

对触变铝合金和钢件充型过程及压力变化进行模拟。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。