查询词典 filler

The front vent windows now employ a chrome air deflector on the upper edge of the vent window frame and a gas filler door hides the open gas cap of the '49 Ford.

前面的通气口视窗现在使用在通气口窗囗的上边缘上的一个铬空气偏流器车架，而且一扇气热隔片门藏 1949 福特的未结清气插接帽。

Based upon study of the gas flowrate changes of filler under various filling rates, submersion depth ,microporous and single orifice aeration ways,different aeration density and other conditions the hydraulics characteristics of HSL aerobic biological fluidized bed is studied,which provide good references for optimization design of HSL aerobic biological fluidized bed and similar reactors.

通过研究HSL好氧生物流化床在不同填料填装率、不同曝气水深、微孔曝气与单孔曝气两种不同的曝气方式、不同曝气密度等条件下的填料流气量，揭示了其水力学特性，从而为优化HSL好氧流化床及类似的反应器水力学流态提供有益的参考。

SEM analysis indicated that the dispersive state of nature rubber latex was improved with the addition of organosilicone. The two batch formulas were adopted in the manufacture of urethral catheter with an optimal addition of 1.5% of KGF-903. The catheters were obtained with smooth surface, finer evenness, moderate hardness and favorable yield of latex sacculus. The separation forces between connector and the interface of conical drainage as well as the tensile force between gas loading filler and drainage tube were improved, which guaranteed the safety of Foley latex in clinic use.

利用小试的最佳配方(即KGF-903的添加量为1.5%)生产了2批次医用导尿管，其表面光洁度、导尿管球囊的成品率、管身硬度、连接器与导尿管排泄锥形接口所承受的拉力和充气漏斗与引流漏斗连接处所承受的拉力等均有显著的提高，有效改善了产品的质量。

SEM analysis indicated that the dispersive state of nature rubber latex was improved with the addition of organosilicone. The two batch formulas were adopted in the manu facture of urethral catheter with an optimal addition of 1.5% of KGF-903. The catheters were obtained with smooth surface, finer evenness, moderate hardness and favorable yield of latex sacculus. The separation forces between connector and the interface of conical drainage as well as the tensile force between gas loading filler and drainage tube were improved, which guaranteed the safety of Foley latex in clinic use.

利用小试的最佳配方（即KGF-903的添加量为1.5%）生产了2批次医用导尿管，其表面光洁度、导尿管球囊的成品率、管身硬度、连接器与导尿管排泄锥形接口所承受的拉力和充气漏斗与引流漏斗连接处所承受的拉力等均有显著的提高，有效改善了产品的质量。

On the back side wall the plasma gas connector, the coolant filler neck, the mains cable entry and the slots for the cooling air exit are located.

在其后壁上设置有：等离子气体接头，冷却液填加口，主电缆入口和冷空气出口。

The suitability of the different processes was analyzed by observing the weld appearance,studying the microstructure and measuring the mechanical properties of the joint.The results show that a favorable weld can be obtained under the suitable parameters by laser beam welding or tungsten inert gas welding with filler metal.The TIG welded joint has a wider HAZ,and the laser welde...

试验结果表明：在工艺参数合适的条件下，加焊丝TIG焊和激光焊均能获得成形较好的焊接接头；TIG焊接头热影响区较宽，焊缝深宽比小，而激光焊时热影响区不明显，焊缝深宽比大；两种焊接方法所获得的焊缝区组织均为均匀的等轴晶，但激光焊时焊缝组织更细，从而使接头抗拉强度大幅度提高，达到母材的94%左右。

In the bead-on-plate experiment, the trial pieces were SAE1020 steel, the activating fluxes were oxide, Carbonate, Sulfide and fluoride, and the welding method was argon shielding gas tungsten arc welding without filler metal.

实验材料选用SAE1020，活性助焊剂选用氧化物、碳酸盐基、硫化物及氟化物，焊接方法采用不加填料金属的氩气保护钨极电弧焊来进行Bead-on-plate实验。

Therefore, in order to guarantee the stability of production, but also to reduce the actual running costs, heat-conducting oil bellows system should be chosen cut-off valve can not be selected filler valve seal or valve.

因此，为了保证生产的稳定，也为了降低实际运行成本，导热油系统应该选用波纹管截止阀，不能选用填料密封的截止阀或闸阀。

Spot checks contractor piping isometrics or fabrication drawings showing weld procedures, filler metal, pre-heat and post-weld heat requirements and monitors their use.

抽检承包商的管道轴侧图和预制图中关于焊接程序、填料、预热和焊后热处理的要求并监督其实施情况

The use of advanced automatic production line of the joint filler to ensure that the final product quality.

生产线采用先进自动联合灌装机，确保最终产品的优良品质。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。