查询词典 fever heat

Through this material one could setup an overall impression of the study content and the study method.In order to investigate the basic heat transfer characteristics of regeneratively cooled scramjet, in the second chapter, one dimensional heat transfer model of regeneratively cooled scramjet was developed. In this model, N-R correlations were used to describe hot gas-side and coolant-side convection heat transfer. Simple model of gas properties was also used.

为了初步了解超燃冲压发动机再生冷却传热的基本特征，第二章建立了超燃冲压发动机再生冷却的一维传热数理模型，采用了准则关系式描述燃气侧和冷却剂侧的对流换热，采用了简化的燃气物性模型，并对衬层材料、衬层厚度和冷却剂流量进行了参数研究。

The heat pipe technology is one of the most efficiency method to solve the key technique for hard problems in order to gain high efficiency of resource utilization and good economy benefit in the application of renewably energy,In this paper,characteristics of the heat pipe technique is introduced,and its application and exploration in the solar energy,subterranean heat energy,living material energy are reviewed.

笔者结合热管技术特点，综述了其在太阳能、地热能、生物能三大能源利用领域中的国内外进展。1热管技术的技术特点[1](1)高的导热性。热管内部主要靠工作液体的汽液相变传热，热阻很小，因此具有极高的传热效率。(2)优良的等温性。

Design indoor temperature of residental buildingfor household heating and heat metering was studied in this article based on thermal comfort formula and PMV/PPD evaluation index. It can be determined that when indoor temperature is 20℃ and varies in the range of 16℃~24℃,it's feasible for thermal comfort,woking efficiency and health standard,thus the key problem of heat load calculation is resolved. It's significant for perfecting heat metering techniques and providing specifications of HVAC.

简介： 本文从热舒适、工作效率、健康标准等方面出发，以热舒适方程及PMV/PPD评价指标为依据，对采用分户计量供热系统的居住建筑的室内设计计算温度的确定进行了研究，确定其为20℃，室温变化范围是16℃～24℃，从而解决了热负荷计算的核心问题，对完善热计量技术及相关暖通规范的编写有一定的指导意义。

In actual reactors, the cooling condition outside the hexcan-wall of blocked fuel subassembly is analogous to its counterparts in the SCARABEE BE+ experiments. The upward and downward heat transfer could be neglected, while the radial heat transfer plays a key role in slowdown the accident scenario. As time goes on, the dominant radial heat transfer mechanism is liquidus sodium convection at first, and then gradually transforms into sodium condensation near the inner surface of the hexcan-wall, and finally becomes volume heated boiling pool convection.

对实际快堆中发生全堵的燃料组件而言，其外部的冷却条件与SCARABEE BE+系列实验非常相似；2）堵流组件向上和向下的传热可忽略不计，径向传热对事故有较强的延缓作用；3）随着时间推进，径向传热的主导机理依次为液态钠单相对流、钠蒸汽在组件盒内壁冷凝、体热源沸腾池散热。

Development of speciality resin for heat shrinkable film ;2. The heat sensitivity of polyvinyl chloride heat shrinkable film was described.

阐述了聚氯乙烯热收缩膜的热敏性，并从生产实际的角度详细讨论了PVC热收缩膜热敏性的影响因素以及热敏性与成型收缩率和贮存性能之间的关系。

Toop's model and Miedema method are to be used to calculate the heat of formation of ternary compounds. A projected method is used to obtained the heat of formation of AB_(1-x)G_x. The heat of formation is negative for GaAs_(1-x)P_x and for GaAs_(1-x)N_x compounds in the all range and for GaP_(1-x)gN_x compound in the

我们分别用Pauling和Phillips经验方法及Miedema半经验方法计算[59]得到Ⅲ-Ⅴ族二元合金的生成热，比较三种方法，均只定性与实验结果吻合，但Miedema方法具有准第一原理特点，可以从组元基本特性出发来得到合金生成热的数据；我们把TOOP'S模型引入计算中，并把计算结果投影到Ⅲ族组元总浓度等于所有Ⅴ族组元总浓度的平面上，即计算AB_(1-x)C_x合金系的

The experimental results are as follows:(1) Without EAF the fouling resistance increase along with addition of time and change of the heat transfer coefficient is just contrary to the result. However, with EAF fouling resistance still enhances at the beginning of experiment and later, it gradually minishes after experiment has started for some time. Of course, the change of heat transfer coefficient still is contrary to the outcome. But when experiment lasts longer time, fouling resistance and heat transfer coefficient change in the same trend as the fore results at the beginning of the experiment. However, They all go to the tranquilization until the last.

实验结果表明：(1)没有经过电磁处理时，污垢热阻随着时间的增加而增加，换热系数随着时间的增加而减小；一旦经过电磁场的处理，污垢热阻开始时仍呈上升趋势，经过一段时间以后，便逐渐下降，换热系数的变化与此正好相反，即在实验开始时呈下降趋势，后来逐渐上升；当实验时间延长时，发现污垢热阻及换热系数在实验开始时的变化趋势与前面的实验结果基本相同，但到后来，二者的数值则分别均趋于稳定。

Hello, hair removal is recommended that you go to a regular hospital for plastic shed, for hair removal methods currently being used for hair removal using photons, the photons unhairing this unique light and heat treatment technology, full use of the combined effect of light and heat, through the launch special spectrum of pulsed light, penetrate the skin to reach the depth of different organizations, was the corresponding depth of the hair follicle, hair dry, and melanoma cells, such as target tissue absorption of heat generated by the formation of an instant local high temperature, dry and damage hair follicles, and obstructed and the termination of hair growth, to achieve permanent hair removal results.

您好，脱毛建议您去正规的整形医院进行脱毛，对于脱毛目前采用的方法是采用光子进行脱毛的，光子脱毛这种独特的光热治疗技术，充分利用了光和热的综合效应，通过发射特殊谱段的脉冲光，穿透皮肤到达不同的组织深度，被相应深度的毛囊、毛干、黑色素细胞等靶组织吸收，产生的热量形成瞬间局部高温，破坏毛干及毛囊，阻碍和终止毛发的生长，达到永久性脱毛的效果。

Along with development of heat pump and its all kinds of driver device and heat pump system experiment study, heat pump technology will be applied more and more widespreadly in our country,and will play an important.

概述了中国目前的能耗现状和能源问题面临的形势，提出热泵技术是回收和利用低位热能的有效措施之一，研究和推广应用热泵技术对于节能有重要意义。

The conclusion of three burning methods mentioned above during the heat storage period is that the first method is the best one, which is propitious to keep higher blast temperature because of the heat exchange in the middle and blow of hot blast stove has been aggrandized through convection heat transfer caused by the added exhausted air quantity and increased flow rate.

以上三种燃烧制度，在蓄热期：第1种因废气量增大，流速加快，利于对流传热，强化了热风炉中下部的热交换，利于维持较高风温，第2种因废气量减少，不利于传热和热交换的强化，不利于维持较高风温，第3种由于废气大量减少，流速降低，传热减缓，蓄热量较少，不利于提高风温。

Nowadays, most of research are to build a transmutative Petri Nets through adding controlling place sets, controlling arc sets and controlling policy to the basic Petri Nets, while the Controlled Petri Nets could be used to argue many controlling theory problems conveniently and to induce many logically and physically supervisory and solve the Event Feedback Controlling Problems and State Feedback Controlling Problem in DEDS supervisory theory.

目前大多数的研究表现为在变形后的受控Petri网基础上，利用各种方法求得各种逻辑型、结构型控制器，解决DEDS监控理论中的事件反馈控制问题与状态反馈控制问题。

On one hand, there are discussions with the works council and union about extension of short time working up to the end of September.

一方面，有讨论，工程理事会和联盟关于延长工作时间短至9月底。