查询词典 fem

Based on the modem FEM with the dynamic substructure method, itd dynamic equation is established with almost no limits to DOFs of the system, in which the left side is the first approach of the nonlinear system and the right side is the excitation and coupling nonlinear pseudo forces. The modal analysis method is used to get the eigen solution to the reduced linear homogeneous dynamic differential equation. When the system is excited by the harmonic excitation at the right side of the equation, the nonlinear dynamic response can be calculated by the numerical method to give quantitative analysis.

基于近代有限元和子结构模态综合法的动力学建模方法，获得非线性系统动力学微分方程，其自由度几乎没有限制，对左端首次近似齐次方程进行模态分析，选取对响应有贡献的部分本征对，同样对右端激励和非线性伪力作模态变换，得到减缩后非线性系统耦合动力学微分方程。

Therefore analysis using FEM and improved designe are presented in this thesis in allusion to the fracture of the crankshaft of JZH25 homogenizer.

本文以此为立足点，针对JZH25型均质机经常发生的曲轴断裂问题进行了有限元分析和改进设计。

To similinear hyperbolic system, we use interpolated coefficient FEM and get similar results as the linear one.

对于一阶半线性双曲组，我们对半线性项插值系数有限元方法，得到了和线性问题类似的结论。

By anchoring an imaginary spring between each data point and deformable curve or surface, the fairing model is established. Then FEM is used to solve the deformation problem of the model caused by imaginary springs and a bicubic B-spline surface patch is taken as one element. Lastly the B-spline active surface model is applied to surface reconstruction from layer data and the problem resulted from fitting for uneven cross-sectional curves can be solved.

通过在数据点与模型之间连接虚拟弹簧，建立光顺模型，并以双三次B样条曲面片作为单元，运用有限元法对模型在虚拟弹簧作用下的变形问题进行求解，得到光顺后的B样条曲面；并在此基础上，提出了一种新的基于断层数据的表面重建方法，可很好地解决不均匀截面族的曲面生成问题。

A 3-dimesion FEM model was adopted to simulate the rheological model, which has three layers, contacted one by one. The interfaces are immersible.

采用三维有限元模型模拟岩体，模型由依次接触的三层介质组成，层间定义为不可入的接触面。

Based on the low-velocity impact test, 4 major modes of low-velocity impact damage including delamination and matrix cracking were taken into account FEM simulation.

从z-pin增韧复合材料层合板低速冲击实验出发，考虑了复合材料层合板在受低速冲击时的分层及基体开裂等四种损伤形式，引入适当的损伤判据，对T300/3234碳纤维树脂基复合材料层合板的低速冲击损伤过程进行有限元模拟。

Based on the low-velocity impact test, 4 major modes of low-velocity impact damage including delamination and matrix cracking were taken into account FEM simulation. By using appropriate failure criterion, the low-velocity impact damage of z-pin reinforced laminates can be identified.

从z-pin增韧复合材料层合板低速冲击实验出发，考虑了复合材料层合板在受低速冲击时的分层及基体开裂等四种损伤形式，引入适当的损伤判据，对T300/3234碳纤维树脂基复合材料层合板的低速冲击损伤过程进行有限元模拟。

Rubber ; Yeoh model ; incompressibility ; generalized ; variational principle ; FEM

橡胶； Yeoh模型；不可压缩性；广义变分原理；有限元法

Numerical calculation of FEM and experimental investigations are used in the present research. The influence of loading condition and size of indenter on the tensile strength of rock has been investigated. The results obtained by numerical calculation and experiments show that tensile strength of rock will increase with the increase of indenter size.

通过有限元数值计算与理论分析相结合的方法，对不同载荷接触条件和接触面宽度角下的岩石抗拉强度进行了深入分析，结果表明，在圆弧形和平台加载条件下计算的岩石抗拉强度随载荷接触宽度角α的增大而增大。

Due to its versatility and flexibility, the FEM is capable of modeling complicated structures as well as inhomogeneous materials.

有限元法求解的基本思想是把边值问题的求解转化为条件变分问题的求解。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。