查询词典 fem

Based on the ESand modern design methods such as FEM, structural optimization etc., a set of software about the CAD of hydraulic cylinder for hydraulic press is developed.

本文针对液压机用液压缸，在AutoCAD R14平台上开发了一套以专家系统和优化设计为支撑软件的液压缸CAD系统——《YYGCAD2.0》。

The FEM result showed that the impact of damping force from vibration absorber resulted in the fracture of side rail.

分析结果表明：减震器支架在车辆行驶过程中对纵梁的冲击导致了纵梁的开裂。

FEM is used to calculate precisely the ela stic deflection error of the system under the condition that t...

在车削加工工件尺寸及形状皆连续动态变化时，应用有限元方法准确计算出工艺系统因弹性变形所引起的误差。

And, the DEM displacement and FEM stress analysis are two common methods of computer simulation.

在边坡变形破坏的计算机模拟已有的方法中，应用比较普遍的是有限元应力分析和离散元位移分析。

We also make the calculation of the FEM in with indoor data, then we detrude safety factory of anti-liquefaction、 vibration shearing strength and level vertical displacement of these improvement measure on tie condition of earthquake, we could determinant these methods after series analysis of the results.

结合室内试验数据，通过有限元计算，得出几种处理措施在地震作用下的抗液化安全系数、动剪应力、水平位移和竖向沉降位移和震陷情况，对计算结果进行分析，判定几种处理方案的可行性；最后对振冲碎石桩方案进行合理性分析，得出最优化方案。

In this paper the FEM package ANSYS is used to establish a parameterized 3-D finite element model of the dewater disc.

本文首次采用ANSYS的APDL语言对圆盘进行参数化造型和计算分析。

By using FEM software we found that discharge lateral pressure is twice higher than static pressure. The effect of the dilatancy is also presented in the paper.

文中通过有限元软件模拟发现筒仓在卸料过程中侧压力值会达到静载情况下的2-3倍，同时发现材料剪涨角对筒仓压力有着重要的影响，为今后的规范修正提供了一定的依据。

The Finite Element Method is used to implement the numerical simulation on the model, and the rule of temperature distribution and the relations between screw deformation and temperature are obtained.

应用有限元法(Finite Element Method， FEM)对该模型进行数值模拟，得到滚珠丝杠传动过程中的温度场的分布规律以及温度对丝杠变形的影响关系。

And the heat transmission model is computed with FEM. Then the paper analyzed rules of difference in temperature. Different in temperature is divided into transverse temperature difference and lengthways difference, and corresponding formulas are respectively presented.

并在此基础上，进行了导热问题的有限元分析，得到了温差分布规律，将计算温差分解为横向温差和纵向温差几，并建立了相应的温差计算公式。

The magnetic field of motor and the eddy current loss in PM are both solved based on FEM for three-dimensional electric magnetic field.

通常在永磁同步电机中都认为转子损耗是可以忽略不计的，主要是因为转子是同步于定子磁动势旋转的。

I didn't watch TV last night, because it .

昨晚我没有看电视，因为电视机坏了。

Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.

今年以来，在北京的很多小区里，电梯液晶电视被撤了下来。