查询词典 feeding standard

The correlation coefficient of standard curve was 0.999 and the minimal detection limit was 8 bacteria/reaction.

标准曲线的相关系数为0.999，检出底限约8个细菌/反应。

The relative standard deviation of this method was 2.03%, the limit of detection was 0.006 4 mg/L, the linear correlation coefficient of the calibration curve was larger than 0.999 and the linear range was much wider.

其相对标准偏差：2.03%；检出限：0.064 6 mg/L；线性范围宽，校准曲线的线性相关系数应大于0.999等。

The standard curve of correlation between membrane surface and fluorescence intensity of FPE was obtained by acid titration. The membrane surface pH was measured according to this curve.

在不影响膜结构的条件下，利用微量TritonX－100消除膜表面与介质之间的质子浓度差，通过酸滴定实验，能够得到膜表面pH与FPE荧光强度之间的相关曲线。

The influence of solid-solid transition on the wax precipitation was considered in the correlation of standard fugacity ratio.

当温度低于旋转化温度时，烷烃成为低能量不可转化的β晶体，其间不同碳原子数的正构烷烃都经历了固-固转换。

Result's standard: statistics management:use chi-square test,exact probabilities in 2×2 table and correlation analysis.

结果判定：p16蛋白的阳性表达为细胞核，cyclinD1蛋白阳性表达为细胞核；参照Shimizu等的判断标准。

So a kind of what kind of correlation is standard and our life after all?

那么标准与我们的生活究竟是怎样的一种关联？

Adopting 6 standard liquids surface tension values and their corresponding contact angles on top of garlic skin and garlic kernel, solid surface tension were derived as 46 and 34 for garlic skin and garlic kernel, respectively.

采用6种标准溶液之表面张力值，配合在蒜皮与蒜仁上之接触角测量，可计算推导蒜皮及蒜仁固体表面张力值分别为46 和34 。

The scope of this standard provides for the determination of corrugated board thickness.

范围 本标准规定了瓦楞纸板厚度的测定方法。

Through studying and exploring the adoption and the change of city life, the author try to reestablish the pedestrian space, and then we could reestablish the modality of city life and improve the living standard in city, thus enable the whole city to coruscate its energy once again.

通过研究和探索城市生活形态的承袭与变化，以求重建城市步行空间的生成方式，进而推动城市生活形态的变化，提高城市生活质量，让城市这个大生命体重新焕发活力。

OBJECTIVE To establish the quality control standard of the powder of coryza.

建立鼻炎散制剂的质量标准。

The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.

论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。

I have not really liked him,I do not like his this kind of disposition.

我没有真的喜欢他，我不喜欢他的这种性格。