查询词典 feeding bottle

METHODS Infants were divided into three groups according to different feeding manners. They were breast feeding group, artificial feeding group, mixture feeding group.

按喂养方式不同把婴儿分成3组：母乳喂养组、人工喂养组、混合喂养组，记录其感染性疾病发生的情况，对其结果进行分析。

The volatile compounds of silkies on feeding medlar and feeding stuff were extracted and identified with solidphase micro extraction and gas chromatography-mass spectrum 79 from silkies on feeding medlar and 61 from silkies on feeding stuff.

采用固相微萃取法，结合气相色谱－质谱技术对甘肃景泰条山农场的枸杞园散养和饲料笼养乌骨鸡肉的挥发性物质进行检测分析。

Figure 2 shows the jigging concentrate relations between content and ore feeding volume, when the diaphragm jig and the sawtooth pulsation jig are provided with different ore volume. Figure 3 shows the jigging concentrate relations between the sulphur recovery rate and ore feeding volume. As the test result shows, when the tailing content reaches approximately 7%, the diaphragm jig has 1.00 t / h · m2 feeding volume, which is also the maximum sorting efficiency in the test. As such, the sawtooth pulsation jig could choose 1.2 t / h · m2 feeding volume. As the test contrast of two groups shows, the sawtooth pulsation jigging concentrate contains higher-grade sulphur than the diaphragm jigging concentrate does.

图2为隔膜跳汰机及锯齿波跳汰机在不同给矿量的情况下，跳汰精矿品位与给矿量的关系，图3为跳汰机精矿硫回收率与给矿量的关系，试验结果表明，在尾矿品位接近7%，隔膜跳汰机给矿量为1.00 t/h·m2指标是隔膜跳汰机给矿量试验中选别效率最高的点，同理选择锯齿波给矿量为1.2 t/h·m2，将两组试验数据比较可以看出，锯齿波跳汰精矿含硫品位高于隔膜跳汰精矿含硫品位。

In the gasifying oven, there are coal feeding port and fuel gas feeding port at the top and the bottom, an inclined plane which drops coal grains and accumulates them onto the bottom, and the ventilating duct with opening over the fuel gas feeding port. It has also steam feeding port at the bottom, resultant gas outlet on the side and waste gas outlet at the upper part.

它是在气化炉的上部和底部分别设有煤供给口和燃气供给口，并设有使投入的煤颗粒落下、堆积到底部上的倾斜面，以及开口端在燃气供给口的上方、在炉内朝上延伸的通风管；还在气化炉的下部和侧部分别设置蒸汽供给口和生成气体排出口，并在上部设置废气排出口。

Do not nipple hole is too large not to let the feeding bottle when the attention of the head left the air, so as to avoid inhaling too much air the children; 3 when feeding the child his head and upper body elevation, 45-degree angle, can not ping lying down to eat; 4 the child should be breast-feeding after vertical hold, pat his back until the child will be discharged air stomach.

奶嘴孔不要太大，喂奶时注意不要让奶瓶头部留有空气，以免宝宝吸入过多空气； 3）喂奶时将宝宝头部及上身抬高，成45度角，不能平躺着吃； 4）喂奶后应将宝宝竖抱，轻拍后背，直到宝宝将胃内空气排出。

If the latter you can try to squeeze the bottle to breast feeding, if the baby or do not eat, then you look at the bottle of milk temperature is moderate, some babies do not like the milk does not eat, my baby If the milk cool a little, he would not eat, you can also try baby happy when the bottle into his mouth and let him slowly adapt to have this thing he could suck the breast, do not be too anxious, infants are Small babies are the most basic instinct, patience, he will adapt to the

如果是后者你可以尝试把母乳挤进奶瓶来喂，如果孩子还是不吃的话，那你再看看奶瓶中的奶温是否适中，有些孩子不喜欢吃不适中的奶，我的孩子如果奶稍微凉点，他就不吃，你还可以尝试在孩子开心的时候把奶瓶放入他嘴里，让他慢慢适应有这个东西他也可以吃奶，不用太着急，吃奶是宝宝子们最基本的本能，耐心点，他会适应的

The stress calculation method and strength condition of PET aerated water bottle were obtained from theory. The strength of PET aerated water bottle was simulated and calculated ANSYS. The stress graphics of the bottle with different thickness was plotted and their stress property was analyzed. The influence of axial load and grooves on bottle stress was also studied.

从理论上得到了聚酯碳酸饮料包装瓶的应力计算方法和强度条件；利用ANSYS对其强度进行了有限元模拟和计算，得到了不同厚度的聚酯碳酸饮料包装瓶的应力图，并分析了其应力特点；同时研究了轴向载荷和瓶体开凹槽对瓶体应力的影响。

The stress calculation method and strength condition of PET aerated water bottle were obtained from theory. The strength of PFT aerated water bottle was simulated and calculated ANSYS. The stress graphics of the bottle with different thickness was plotted and their stress property was analyzed. The influence of axial load and grooves on bottle stress was also studied.

从理论上得到了聚酯碳酸饮料包装瓶的应力计算方法和强度条件；利用ANSYS对其强度进行了有限元模拟和计算，得到了不同厚度的聚酯碳酸饮料包装瓶的应力图，并分析了其应力特点；同时研究了轴向载荷和瓶，婚开凹槽对瓶体应力的影响。

The appliances provided by us conform to the requirements of "GMP" and they are operated according to the ISO9001 quality system strictly .Themain products have one pair of needles,Six-Needle Drawing1-20ml Filling and Sealing Machine. 1-20ml Ampoule Bottle Showering Machine ,1-20ml Ampoule Bottle Spin-Drying Machine, AF Ampoule Bottle Printer such equipment for production purpose of water thimble as the ampoule bottle prinker ,etc.

本公司所提供的设备符合国家"GMP"的要求，并严格按照ISO9001质量体系制作，主要产品有双针、六针1－20毫升拉丝灌封机，1－20毫升安瓿瓶淋瓶机，1－20毫升安瓿瓶甩水机，AF型安瓿瓶印字机等水针生产用设备。

To avoid this, high pressure foam generating procedure must be applied, which means high pressure purified water or deoxygenated water must be fed into the bottle with small flow under high pressure, thus raising CO2 in the beer to the bottle neck as foam to remove gas from the bottle neck and dropping oxygen content in the bottle neck.

可通过增加高压激泡工序，即将高压纯净水或脱氧水以微小的水流高压注入瓶中，使啤酒中的CO2以泡沫形式上升至瓶口，排走瓶颈的气体，达到减少瓶颈气体含氧量的目的。

The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.

论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。

I have not really liked him,I do not like his this kind of disposition.

我没有真的喜欢他，我不喜欢他的这种性格。